Mechanical Engineering Commons^™

Structural Analysis Of Integration Of A Non-Cylindrical Cng Fuel Tank, Prathamesh Prashant Deshpande

Dissertations, Master's Theses and Master's Reports - Open

The purpose of this study is to computationally model and analyze the vehicle frame which is mounted with a non-conventional, non-cylindrical compressed natural gas (CNG) fuel tank. Integration of this tank in the vehicle underbody will resolve the issue of reduced storage space which is observed in a conventional CNG powered vehicle. This research will ultimately result in making CNG a good alternative to gasoline and reducing the increasing dependency on a single fuel. This tank will be developed in two phases: phase I design of the tank will be a standard rectangular outer box shape with Schwarz P-surface inner …

Modeling Of Biomass Torrefaction And Pyrolysis And Its Applications, Jordan L. Klinger

Dissertations, Master's Theses and Master's Reports - Open

Utilizing biomass provides a possible near-term alternative solution for fossil energy dependence in both electricity generation and transportation. Though thermochemical conversion can produce solid/liquid fuels that are compatible in existing infrastructure, detailed scientific chemical and mechanistic understanding are still being developed. In contribution to these efforts, this work is focused on development of a semiempirical, lumped parameter, chemical kinetic model to describe the degradation of woody biomass.

The initial kinetic model was developed in the torrefaction region to describe the gas-phase evolution of products (water, organic acids, permanent gases, and furfural) through a three consecutive reaction model. In this model, …

Water Transport Through Porous Media And In Flow Channels Of Proton Exchange Membrane Fuel Cell, Mehdi Mortazavi

Dissertations, Master's Theses and Master's Reports - Open

Proton exchange membrane (PEM) fuel cell has been known as a promising power source for different applications such as automotive, residential and stationary. During the operation of a PEM fuel cell, hydrogen is oxidized in anode and oxygen is reduced in the cathode to produce the intended power. Water and heat are inevitable byproducts of these reactions. The water produced in the cathode should be properly removed from inside the cell. Otherwise, it may block the path of reactants passing through the gas channels and/or gas diffusion layer (GDL). This deteriorates the performance of the cell and eventually can cease …

Co-Electrophoretic Deposition Of Liquid Metal And Silicon For Lithium-Ion Battery Application, Hanfei Zhang

Dissertations, Master's Theses and Master's Reports - Open

A low cost electrophoretic deposition (EPD) process was successfully used for liquid metal thin film deposition with a high depositing rate of 0.6 µ/min. Furthermore, silicon nano-powder and liquid metal were then simultaneously deposited as the negative electrode of lithium-ion battery by a technology called co-EPD. The liquid metal was hoping to act as the matrix for silicon particles during lithium ion insertion and distraction. Half-cell testing was performed using as prepared co-EPD sample. An initial discharge capacity of 1500 mAh/g was reported for nano-silicon and galinstan electrode, although the capacity fading issue of these samples was also observed.

Comparative Analysis Of Efficiency And Operating Characteristics Of Automotive Powertrain Architectures Through Chassis Dynamometer Testing, Jeremy J. Anderson

Dissertations, Master's Theses and Master's Reports - Open

The thesis "COMPARATIVE ANALYSIS OF EFFICIENCY AND OPERATING CHARACTERISTICS OF AUTOMOTIVE POWERTRAIN ARCHITECTURES THROUGH CHASSIS DYNAMOMETER TESTING" was completed through a collaborative partnership between Michigan Technological University and Argonne National Laboratory under a contractual agreement titled "Advanced Vehicle Characterization at Argonne National Laboratory". The goal of this project was to investigate, understand and document the performance and operational strategy of several modern passenger vehicles of various architectures. The vehicles were chosen to represent several popular engine and transmission architectures and were instrumented to allow for data collection to facilitate comparative analysis. In order to ensure repeatability and reliability during testing, …