Open Access. Powered by Scholars. Published by Universities.®
- Publication
- Publication Type
Articles 1 - 4 of 4
Full-Text Articles in Mechanical Engineering
Dynamic Behavior Of A Clamped-Clamped Bi-Stable Laminate For Energy Harvesting, Ajay V. Kumar, Andres F. Arrieta Ph.D., Myungwon Hwang
Dynamic Behavior Of A Clamped-Clamped Bi-Stable Laminate For Energy Harvesting, Ajay V. Kumar, Andres F. Arrieta Ph.D., Myungwon Hwang
The Summer Undergraduate Research Fellowship (SURF) Symposium
Multi-stable laminates have many applications in morphing structures, energy harvesting devices, and metamaterials due to the specific characteristics attributed to the exhibited stable states. Changes between stable states allow for large deflections, on-demand variation of the stiffness of compliant structures embedded within these elements, and control of effective dynamic properties in periodic lattices. These changes in state can be accessed via a snap-through instability triggered by introducing a well-defined activation energy. The resulting oscillations could enable broadband energy harvesting via piezoelectric transduction and resistive circuits. In this paper, a clamped-clamped bi-stable laminate is studied to understand the behavior of the …
Parametric And Design Analysis On Thermoelectric Generators, Shouyuan Huang
Parametric And Design Analysis On Thermoelectric Generators, Shouyuan Huang
Open Access Theses
In facing the limited energy source reserves and environmental problems, thermoelectric generators (TEGs) are one of the promising waste heat recovery systems. The modern TEGs for exhaust stream (e.g. from automobiles) can improve the fuel economy by around 5%, taking advantage of the recent developed thermoelectric (TE) materials.
In this work, we aimed at designing a TEG as an add-on module for a gas-phase heat exchanger with maximized power output, and without negative impact (e.g. maintaining a minimum heat dissipation rate from the hot side). We first developed a parametric optimization algorithm using response surface method (RSM) and genetic algorithm …
A Novel Microgrid Demand-Side Management System For Manufacturing Facilities, Terance J. Harper, William J. Hutzel, James C. Foreman, Aaron L. Adams, Athula Kulatunga
A Novel Microgrid Demand-Side Management System For Manufacturing Facilities, Terance J. Harper, William J. Hutzel, James C. Foreman, Aaron L. Adams, Athula Kulatunga
Purdue Polytechnic Masters Theses
Thirty-one percent of annual energy consumption in the United States occurs within the industrial sector, where manufacturing processes account for the largest amount of energy consumption and carbon emissions. For this reason, energy efficiency in manufacturing facilities is increasingly important for reducing operating costs and improving profits. Using microgrids to generate local sustainable power should reduce energy consumption from the main utility grid along with energy costs and carbon emissions. Also, microgrids have the potential to serve as reliable energy generators in international locations where the utility grid is often unstable.
For this research, a manufacturing process that had approximately …
Assessing The Engineering Performance Of Affordable Net-Zero Energy Housing, Jordan P. Wallpe
Assessing The Engineering Performance Of Affordable Net-Zero Energy Housing, Jordan P. Wallpe
Purdue Polytechnic Masters Theses
The purpose of this research was to evaluate affordable technologies that are capable of providing attractive, cost-effective energy savings to the housing industry. The research did so by investigating the 2011 Solar Decathlon competition, with additional insight from the Purdue INhome. Insight from the Purdue INhome verified the importance of using a three step design process to design a net-zero energy building. In addition, energy consumption values of the INhome were used to compare and contrast different systems used in other houses.
Evaluation of unbiased competition contests gave a better understanding of how a house can realistically reach net-zero. Upon …