Open Access. Powered by Scholars. Published by Universities.®
- Publication Type
Articles 1 - 2 of 2
Full-Text Articles in Mechanical Engineering
A Dynamic Active Noise Control System For Live Music Attenuation, Elliot James Krueger
A Dynamic Active Noise Control System For Live Music Attenuation, Elliot James Krueger
Graduate Research Theses & Dissertations
This thesis proposes a system design that will be suitable for applying active noise control (ANC) effectively to live musical instruments. The design consists of three parts: a signal separation section, an instrument classification section, and the active noise control section. The signal separation section will split up the music signals. The instrument classification section will identify the signals, and the ANC section will attenuate the music signal based on the previous information from the other sections. The two instruments of focus will be the trombone and tuba for their low frequency and ability to be quite loud in a …
Improved Sensitivity Mems Cantilever Sensor For Terahertz Photoacoustic Spectroscopy, Ronald A. Coutu Jr., Ivan R. Medvedev, Douglas T. Petkie
Improved Sensitivity Mems Cantilever Sensor For Terahertz Photoacoustic Spectroscopy, Ronald A. Coutu Jr., Ivan R. Medvedev, Douglas T. Petkie
Faculty Publications
In this paper, a microelectromechanical system (MEMS) cantilever sensor was designed, modeled and fabricated to measure the terahertz (THz) radiation induced photoacoustic (PA) response of gases under low vacuum conditions. This work vastly improves cantilever sensitivity over previous efforts, by reducing internal beam stresses, minimizing out of plane beam curvature and optimizing beam damping. In addition, fabrication yield was improved by approximately 50% by filleting the cantilever’s anchor and free end to help reduce high stress areas that occurred during device fabrication and processing. All of the cantilever sensors were fabricated using silicon-on-insulator (SOI) wafers and tested in a custom …