Mechanical Engineering Commons^™

Contributions Of Proximal And Distal Moments To Axial Tibial Rotation During Walking And Running, T. L. Bellchamber, Antonie J. Van Den Bogert

Mechanical Engineering Faculty Publications

The purpose of this study was to determine the cause and effect relationship between tibial internal rotation and pronation of the foot during walking and heel–toe running. This would allow predictions of orthotic effectiveness in reducing knee pain related to excessive internal tibial rotation. Kinematic and force plate data were collected from twenty subjects performing ten running and ten walking trials across a force plate. Using a least-squares algorithm, attitude matrices for each segment in each frame were obtained and the angular velocity vector of the tibia was calculated. The intersegmental moment at the ankle was calculated from ground reaction …

Tibiocalcaneal Kinematics Of Barefoot Versus Shod Running, Alex Stacoff, Benno M. Nigg, Christoph Reinschmidt, Antonie J. Van Den Bogert, Arne Lundberg

Mechanical Engineering Faculty Publications

Barefoot running kinematics has been described to vary considerably from shod running. However, previous investigations were typically based on externally mounted shoe and/or skin markers, which have been shown to overestimate skeletal movements. Thus, the purpose of this study was to compare calcaneal and tibial movements of barefoot versus shod running using skeletal markers. Intracortical bone pins with reflective marker triads were inserted under standard local anesthetic into the calcaneus and tibia of five healthy male subjects. The subjects ran barefoot, with a normal shoe, with three shoe soles and two orthotic modifications. The three-dimensional tibiocalcaneal rotations were determined using …

The Influence Of Orthotic Devices And Vastus Medialis Strength And Timing On Patellofemoral Loads During Running, R. R. Neptune, I. C. Wright, Antonie J. Van Den Bogert

Mechanical Engineering Faculty Publications

Objective. To use a musculoskeletal model and simulation of running to examine: (1) the influence of two commonly prescribed treatments for patellofemoral pain (vastus medialis oblique strengthening and orthoses) and (2) the functional significance of timing differences between vastus medialis oblique and vastus lateralis on lateral patellofemoral joint loads.

Design. A three-dimensional musculoskeletal model of the lower extremity was used to simulate running at 4 m/s.

Background. Repetitive and excessive joint loading is often associated with overuse injuries that require clinical treatments to reduce pain and restore function. Affecting one in four runners, patellofemoral pain is one …

The Influence Of Foot Positioning On Ankle Sprains, I. C. Wright, R. R. Neptune, Antonie J. Van Den Bogert, B. M. Nigg

Mechanical Engineering Faculty Publications

The goal of this study was to examine the influence of changes in foot positioning at touch-down on ankle sprain occurrence. Muscle model driven computer simulations of 10 subjects performing the landing phase of a side-shuffle movement were performed. The relative subtalar joint and talocural joint angles at touchdown were varied, and each subject-specific simulation was exposed to a set of perturbed floor conditions. The touchdown subtalar joint angle was not found to have a considerable influence on sprain occurrence, while increased touchdown plantar flexion caused increased ankle sprain occurrences. Increased touchdown plantar flexion may be the mechanism which causes …

Quantification Of In Vivo Acl Elongation During Dynamic Joint Movements: A New Methodology, Scott G. Mclean, Antonie J. Van Den Bogert

Mechanical Engineering Faculty Publications

Anterior cruciate ligament (ACL) injuries are common in movement tasks incorporating sudden changes in velocity, such as sidtestepping. Current techniques adopted to quantify ACL strain are invasive as well as limited to slow, quasi-static move- ments. This paper presents a method for non-invasive measurement of ACL elongation during dynamic movement tasks, validation of the method, and demonstrates its applicability to the analysis of sidestep movements

Movement Coupling At The Ankle During The Stance Phase Of Running, Alex Stacoff, Benno M. Nigg, Christoph Reinschmidt, Antonie J. Van Den Bogert, Arne Lundberg, Edgar Stüssi, Jachen Denoth

Mechanical Engineering Faculty Publications

The purpose of this study was to quantify movement coupling at the ankle during the stance phase of running using bone-mounted markers. Intracortical bone pins with reflective marker triads were inserted under standard local anaesthesia into the calcaneus and the tibia of five healthy male subjects. The three-dimensional rotations were determined using a joint coordinate system approach. Movement coupling was observed in all test subjects and occurred in phases with considerable individual differences. Between the shoe and the calcaneus coupling increased after midstance which suggested that the test shoes provided more coupling for inversion than for eversion. Movement coupling between …

Effects Of Foot Orthoses On Skeletal Motion During Running, A. Stacoff, C. Reinschmidt, B. M. Nigg, Antonie J. Van Den Bogert, A. Lundberg, J. Denoth, E. Stüssi

Mechanical Engineering Faculty Publications

Objective. To quantify the effects of medial foot orthoses on skeletal movements of the calcaneus and tibia during the stance phase in running.

Design. Kinematic effects of medial foot orthoses (anterior, posterior, no support) were tested using skeletal (and shoe) markers at the calcaneus and tibia.

Background. Previous studies using shoe and skin markers concluded that medially placed orthoses control/reduce foot eversion and tibial rotation. However, it is currently unknown if such orthoses also affect skeletal motion at the lower extremities.

Methods. Intracortical Hofman pins with reflective marker triads were inserted under standard local anesthetic into the calcaneus …