Mechanical Engineering Commons^™

Estimation Of The Fatigue Life Of Additively Manufactured Metallic Components Using Modified Strain Life Parameters Based On Surface Roughness, Peter Grohs

Masters Theses

In this study, a method is developed to estimate the effects of surface roughness on the fatigue life of additively manufactured titanium Ti6Al4V, aluminum 7075–T6, and steel 4340 alloys through modified strain life parameters using finite element analysis (FEA). This method is highly beneficial to the fatigue analysis of as-built additively manufactured metal components, which possess rough surfaces that reduce fatigue life significantly but are challenging to analyze directly using finite element simulation because of complex geometries, i.e., modeling an exact surface profile is arduous.

An effective stress concentration factor, incorporating roughness data, is defined to quantify their effects on …

Algorithm For Geodetic Positioning Based On Angle-Of-Arrival Of Automatic Dependent Surveillance-Broadcasts, Richard Allen Gross

Masters Theses

This paper develops a non-precision, three-dimensional, geodetic positioning algorithm for airborne vehicles. The algorithm leverages the proliferation of Automatic Dependent Surveillance – Broadcast (ADS-B) equipped aircraft, utilizing them as airborne navigation aids to generate an RF Angle-of-Arrival (AOA) and Angle-of-Elevation (AOE) based geodetic position. The resulting geodetic position can serve as a redundant navigation system for use during locally limited Global Navigation Satellite System (GNSS) availability, be used to validate on-board satellite navigation systems in an effort to detect local spoofing attempts, and be used to validate ADS-B position reports.

The navigation algorithm is an implementation of an Extended Kalman …

Laser Machining Countersinks In Carbon Fiber Reinforced Polymer, Leon James Neely Hill

Masters Theses

“Laser machining countersinks with a frequency doubled Q-switched diode pumped Nd:YAG laser is demonstrated. Tests were conducted in 0.100" thick IM7 prepreg CFRP with [0,90]3S orientation. The HAZ is minimized to avoid stress concentrations in the epoxy matrix. A chamber and filtration system was designed and built to contain the byproducts produced in the machining process. The variables investigated are the number of repetitions in the offset path, the plunge rate, and the line energy. The research was performed over one baseline study, one parameter space exercise, two full factorial experiments, and one repeatability study. Assessment was done under an …