Materials Science and Engineering Commons^™

Towards Sustainable Production Of Chemicals And Fuels From The Fast Pyrolysis Of Waste Polyolefin Plastics, Ulises Gracida Alvarez

Dissertations, Master's Theses and Master's Reports

The increasing amount of plastic waste (PW) generation has become an important concern due to the leveled-off recycling rates. Therefore, governmental agencies around the world, including state governments in the United States, have proposed initiatives to minimize the amount of PW that is landfilled and encourage recycling or energy recovery. Circular economy is a strategy that attempts on reusing PW to produce new polymers while avoiding its disposal and the use of virgin material. Chemical recycling raises an interesting technology prospect due to the potential reduction of pollutant emissions and the establishment of a circular economy through the production of …

Nondestructive Evaluation Of Salvage White Spruce, Tyler Hovde

Dissertations, Master's Theses and Master's Reports

Knowledge of wood quality in dead standing trees is an important topic with recent increases in defoliation across North America. Obtaining wood quality information for defoliated trees would help stakeholders in the timber products industry sort and sell salvaged material for the highest possible value. This research investigates the ability to measure wood quality of white spruce (Picea glauca) after spruce budworm (Choristoneura fumiferana) attack using acoustic nondestructive evaluation. We compared stress wave velocities measured on standing trees to trees’ visual appearance. After harvest and processing of selected trees into bolts, standing-tree stress wave velocities were compared to bolt acoustic …

An Investigation Of Waste Glass-Based Geopolymers Supplemented With Alumina, Mary U. Christiansen

Dissertations, Master's Theses and Master's Reports - Open

An increased consideration of sustainability throughout society has resulted in a surge of research investigating sustainable alternatives to existing construction materials. A new binder system, called a geopolymer, is being investigated to supplement ordinary portland cement (OPC) concrete, which has come under scrutiny because of the CO2 emissions inherent in its production.

Geopolymers are produced from the alkali activation of a powdered aluminosilicate source by an alkaline solution, which results in a dense three-dimensional matrix of tetrahedrally linked aluminosilicates. Geopolymers have shown great potential as a building construction material, offering similar mechanical and durability properties to OPC. Additionally, geopolymers have …

The Use Of Life-Cycle Analysis To Reduce The Environmental Impact Of Materials In Manufacturing, Megan A. Kreiger

Dissertations, Master's Theses and Master's Reports - Open

This thesis is composed of three life-cycle analysis (LCA) studies of manufacturing to determine cumulative energy demand (CED) and greenhouse gas emissions (GHG). The methods proposed could reduce the environmental impact by reducing the CED in three manufacturing processes.

First, industrial symbiosis is proposed and a LCA is performed on both conventional 1 GW-scaled hydrogenated amorphous silicon (a-Si:H)-based single junction and a-Si:H/microcrystalline-Si:H tandem cell solar PV manufacturing plants and such plants coupled to silane recycling plants. Using a recycling process that results in a silane loss of only 17 versus 85 percent, this results in a CED savings of 81,700 …