Open Access. Powered by Scholars. Published by Universities.®
Engineering Science and Materials Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Publication
Articles 1 - 3 of 3
Full-Text Articles in Engineering Science and Materials
Sintering Of Cu–Al2o3 Nano-Composite Powders Produced By A Thermochemical Route, Zeljko J. Kamberovic
Sintering Of Cu–Al2o3 Nano-Composite Powders Produced By A Thermochemical Route, Zeljko J. Kamberovic
Zeljko J Kamberovic
This paper presents the synthesis of nano-composite Cu–Al2O3 powder by a thermochemical method and sintering, with a comparative analysis of the mechanical and electrical properties of the obtained solid samples. Nano-crystalline Cu–Al2O3 powders were produced by a thermochemical method through the following stages: spray-drying, oxidation of the precursor powder, reduction by hydrogen and homogenization. Characterization of powders included analytical electron microscopy (AEM) coupled with energy dispersive spectroscopy (EDS), differenttial thermal and thermogravimetric (DTA–TGA) analysis and X-ray diffraction (XRD) analysis. The size of the produced powders was 20–50 nm, with a noticeable presence of agglomerates. The composite powders were characterized by …
Synthesis And Sintering Of Cu-Al2o3 Nanocomposite Powders Produced By A Thermochemical Route, Zeljko J. Kamberovic
Synthesis And Sintering Of Cu-Al2o3 Nanocomposite Powders Produced By A Thermochemical Route, Zeljko J. Kamberovic
Zeljko J Kamberovic
By hydrometallurgy and powder metallurgy along with prognosis of physical- chemical properties, a synthesis of new improved materials can be successfully performed with in advance pre-set properties which is conditioned by a quality of starting powders i.e. by improving their structure. In accordance with that, this paper presents synthesis of the nanocomposite Cu-Al2O3 powder by thermochemical method and sintering with a comparative analysis of the mechanical and electrical properties of obtained solid samples. Nanocrystaline Cu-Al2O3 powders were produced by thermochemical method through following stages: spray-drying, oxidation of precursor powder, reduction by hydrogen and homogenisation. Characterization of powders included differential-thermal and …
Bubble Electrospinning For Mass Production Of Nanofibers, Yong Liu, Ji-Huan He
Bubble Electrospinning For Mass Production Of Nanofibers, Yong Liu, Ji-Huan He
Ji-Huan He
A new bottom-up gas-jet electrospinning process for mass production is presented. A bubble-induced cone on the surface of polymer solution is equivalent to the Taylor cone in traditional electrospinning, which is a must for producing nanofibers. In this study bubbles are produced by compressed air or nitrogen through a nozzle settled in the bottom of the solution. Multiple jets are observed during the electrospinning process as predicted for it is easy to many bubble-induced cones on the solution surface. The new electrospinning mechanism can be used for mass production of nanofibers.