Engineering Science and Materials Commons^™

Bubble-Induced Inverse Gas-Liquid-Solid Fluidized Bed, Xiliang Sun

Electronic Thesis and Dissertation Repository

Gas-liquid-solid fluidized beds have been widely applied in wastewater treatment, however, the current method of wastewater process has several limitations. Hence, an improved method is in demand. A 3.5 height and 0.1534m inner diameter column was used to study the hydrodynamic characteristics of a bubble-induced three-phase inverse fluidized bed. Air, water and three types of low-density particles were employed as gas, liquid and solid phases.

The hydrodynamic properties in the bubble-induced three-phase fluidized bed were investigated to provide the basic information for the industrial process, such as flow regime, bed expansion ratio and phase holdups. A flow regime map containing …

Process-Structure-Property Relationships For High Pressure Die-Cast Magnesium Alloys, Pouya Sharifi

Electronic Thesis and Dissertation Repository

The primary goal of this study was to conduct experiments and simulation modeling to determine the relevant filling and solidification process parameters that influence microstructural features of the high-pressure die-cast magnesium alloy AM60. This work continues from the previous research that has been carried out by Dr. Jeff Wood’s research group over the last sixteen years.

Metallographic and spherical microindentation were used to analyze the influence of microstructural features on the flow stress for both skin (finer grain sizes) and core (larger grain sizes) of high pressure die castings (HPDC), as well as different regions of gravity cast stepped-plate. It …

Study On The Mechanical Behavior Of Directly Compounded Long Glass Fiber Reinforced Polyamide 6 Composites, Yuchao Liu

Electronic Thesis and Dissertation Repository

With great lightweight potential, high performance-to-cost ratio and mass productivity, direct-compounded long fiber thermoplastics (D-LFT) have drawn great attention from the automotive industry. With better mechanical properties and higher service temperature, polyamide 6 (PA6) was used to replace polypropylene (PP) which is almost the exclusively used matrix for the D-LFT process currently. The investigation was performed on this new material with a focus on the effect of fiber content, processing parameters, temperature and tailored reinforcement on mechanical behavior. The results show that the mechanical properties of this new material are sensitive to the variation of fiber content and service temperature …