Open Access. Powered by Scholars. Published by Universities.®

Engineering Science and Materials Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 3 of 3

Full-Text Articles in Engineering Science and Materials

Effectiveness Of Indoor Plants For Passive Removal Of Indoor Ozone, Omed A. Abbass, David J. Sailor, Elliott T. Gall Jul 2017

Effectiveness Of Indoor Plants For Passive Removal Of Indoor Ozone, Omed A. Abbass, David J. Sailor, Elliott T. Gall

Mechanical and Materials Engineering Faculty Publications and Presentations

Indoor vegetation is often proposed as a passive approach for improving indoor air quality. While studies of outdoor environments indicate that vegetation can be an important sink of outdoor ozone, there is scant data in the literature concerning the dynamics of ozone uptake by indoor plants. This study determined ozone deposition velocities (vd) for five common indoor plants (Peace Lily, Ficus, Calathia, Dieffenbachia, Golden Pothos). The transient vd was calculated, using measured leaf areas for each plant, for exposures mimicking three diurnal cycles where ozone concentrations in chamber tests were elevated for 8 h followed by …


Evaluation Of Phase Change Materials For Cooling In A Super-Insulated Passive House, Jeffrey Stephen Lauck Oct 2013

Evaluation Of Phase Change Materials For Cooling In A Super-Insulated Passive House, Jeffrey Stephen Lauck

Dissertations and Theses

Due to factors such as rising energy costs, diminishing resources, and climate change, the demand for high performance buildings is on the rise. As a result, several new building standards have emerged including the Passive House Standard, a rigorous energy-use standard based on a super-insulated and very tightly sealed building envelope. The standard requires that that air infiltration is less than or equal to 0.6 air changes per hour at a 50 Pascal pressure difference, annual heating energy is less than or equal to 15kWh/m2, and total annual source energy is less than or equal to 120 kWh/m2. A common …


Studies Of Bistable Fluid Devices For Particle Flow Control, Gerald H. Hogland Feb 1972

Studies Of Bistable Fluid Devices For Particle Flow Control, Gerald H. Hogland

Dissertations and Theses

This study was directed toward the development of a bistable wall attachment Flip-Flop device which was capable of directionally controlling particle flow. The particles were transported by a fluid stream which under the influence of wall attachment. The dominant criteria in the development of the device was the achievement of the highest recovery of particles at the active output, without destroying the wall attachment of the fluid stream The experiment was conducted in several distinct stages; each of which was concerned with at least one aspect of wa1l attachment or particle flow. Results derived from one test were used to …