Open Access. Powered by Scholars. Published by Universities.®
Engineering Science and Materials Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 10 of 10
Full-Text Articles in Engineering Science and Materials
An Investigation On The Solid Electrolyte Interphase Of Silicon Anode For Li-Ion Batteries Through Force Curve Method, Jie-Yun Zheng, Hao Zheng, Rui Wang, Hong Li, Li-Quan Chen
An Investigation On The Solid Electrolyte Interphase Of Silicon Anode For Li-Ion Batteries Through Force Curve Method, Jie-Yun Zheng, Hao Zheng, Rui Wang, Hong Li, Li-Quan Chen
Journal of Electrochemistry
Non-aqueous electrolyte has been widely used in commercial Li-ion batteries. Optimized choices are proceeding among the various types of salts and solvents in an effort to achieve higher performance of electrolyte. However, the electrolyte will be reduced in low potential and the reductive product will be deposited on the surface of anode to form a passivating layer, solid electrolyte interphase (SEI). Herein an atomic force microscopy (AFM) based method was introduced to study the structure and mechanical property of SEI on silicon thin film anode during the first cycle. Silicon has been known as the most potential candidate anode for …
Electrochemical Performance Of Al-Doped Spinel Limn2O4 Cathode Material For Li-Ion Batteries, Yong-Long Wang, Wen-Ge Wang, Qian Zhang, Xin Wang, Jian-Sheng Cao, Shi-Hai Ye
Electrochemical Performance Of Al-Doped Spinel Limn2O4 Cathode Material For Li-Ion Batteries, Yong-Long Wang, Wen-Ge Wang, Qian Zhang, Xin Wang, Jian-Sheng Cao, Shi-Hai Ye
Journal of Electrochemistry
Spinel LiMn2O4, a cathode material for Li-ion batteries, is featured as good high-rate performance, low cost and environmental friendly. The pristine and Al-doped LiMn2O4 samples were prepared by sol-gel method. The structure and micromorphology of the as-prepared samples were characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM). The results demonstrated that the as-prepared LiMn2O4 samples had a typical cubic spinel structure and were composed of sphere-like particles with a diameter range of 300 ~ 500 nm. Galvanostatic charge-discharge tests showed that the LiMn2O4 samples doped …
Electrochemical Performance Of Fe3o4/C Composites As Negative Material For Lithium-Ion Batteries, Jun-Jie Cai, Shu Yao, Ze-Sheng Li, Hui Meng, Pei-Kang Shen
Electrochemical Performance Of Fe3o4/C Composites As Negative Material For Lithium-Ion Batteries, Jun-Jie Cai, Shu Yao, Ze-Sheng Li, Hui Meng, Pei-Kang Shen
Journal of Electrochemistry
The Fe3O4/Carbon composites have been synthesized through coprecipitation pathway and by insitu aniline polymerization as a carbon source. Structural characterization and morphological study of the composites were investigated by using XRD, SEM and TEM techniques. The results showed that the nanosized Fe3O4 particles (40 ~ 80 nm) were encapsulated in the amorphous carbon. During the electrochemical tests, the Fe3O4/C composites exhibited high capaticity and excellent cycle ability, the retention of capaticity was about 1000 mAh?g-1 after 30 cycles of charge/discharge tests at 50 mA?g-1.
Electrochemical Performance Of Yf3-Coated Li(Li0.22Ni0.17Mn0.61)O2 Cathode Material For Li-Ion Batteries, Xin Feng, Guo-Ran Li, Shi-Hai Ye, Xue-Ping Gao
Electrochemical Performance Of Yf3-Coated Li(Li0.22Ni0.17Mn0.61)O2 Cathode Material For Li-Ion Batteries, Xin Feng, Guo-Ran Li, Shi-Hai Ye, Xue-Ping Gao
Journal of Electrochemistry
The Li(Li0.22Ni0.17Mn0.61)O2 was prepared with oxalic co-precipitation and coated with an YF3 layer by a chemical deposition method. The as-prepared and YF3-coated Li-rich materials were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDS). The results demonstrate that the as-prepared and YF3-coated Li(Li0.22Ni0.17Mn0.61)O2 materials have a typical layered structure and are composed of sphere-like particles with a diameter of 100~200 nm. Galvanostatic charge-discharge tests show that the discharge capacity of the YF3-coated Li(Li0.22 …
The Sol-Gel Synthesis And Electrochemical Performance Of Li_3v_2(Po_4)_3/C Cathode Material For Lithium Ion Battery, Li-Ying Liu, Lian Chen, Hai-Yan Zhang, Yu-Chun Zhai
The Sol-Gel Synthesis And Electrochemical Performance Of Li_3v_2(Po_4)_3/C Cathode Material For Lithium Ion Battery, Li-Ying Liu, Lian Chen, Hai-Yan Zhang, Yu-Chun Zhai
Journal of Electrochemistry
Li3V2(PO4)3/C was synthesized by sol-gel method with citric acid as chelate and C sources.Physical and electrochemical performances of as-prepared materials were characterized through XRD,SEM and galvanostatic charge-discharge tests,etc.The results showed that products produced by calcining at 800 ℃ for 12 h had a single phase crystal structure and relatively small particle sizes with uniform distribution.At 0.1 C,0.5 C and 1 C,the initial specific discharge capacities were 153.0,143.1 and 130.6 mAh·g-1,respectively,and capacity efficiencies were 93.1%,85.4% and 77.3% after 50 cycles,respectively.Charge efficiencies were all above 80% and discharge voltages were higher.
High-Rate Cyclic Properties Of Hollow Carbon Hemisphere As Anode Materials For Lithium Ion Batteries, Guang-Hui Zhang, Zao-Xue Yan, Hong-Li Zou, Pei-Kang Shen
High-Rate Cyclic Properties Of Hollow Carbon Hemisphere As Anode Materials For Lithium Ion Batteries, Guang-Hui Zhang, Zao-Xue Yan, Hong-Li Zou, Pei-Kang Shen
Journal of Electrochemistry
High surface area hollow carbon hemispheres ( HCHs) covered with hard carbon layers have been synthesized by using polystyrene spheres ( PSs) as templates under hydrothermal method combined with the intermittent microwave heating ( IMH) method. The morphologies of the materials are characterized by SEM and TEM. The electrochemical properties of the HCHs are tested. Comparing with graphite and mesocarbon microbeads ( MCMB) ,the HCHs show higher capacity and excellent cyclic life performance.
Synthesis And Electrochemical Properties Of Li_3v_2(Po_4)_3/C Cathode Materials For Lithium Ion Battery, Li-Ying Liu, Hai-Yan Zhang, Lian Chen, Yu-Chun Zhai
Synthesis And Electrochemical Properties Of Li_3v_2(Po_4)_3/C Cathode Materials For Lithium Ion Battery, Li-Ying Liu, Hai-Yan Zhang, Lian Chen, Yu-Chun Zhai
Journal of Electrochemistry
Cathode material Li3V2( PO4) 3 /C for Lithium-ion battery was synthesized by combination of ball milling and baking. Physical and electrochemical performances of as-prepared materials were characterized through XRD,EIS and galvanostatic cell cycling. The results show that the products were monoclinic Li3 V2 ( PO4) 3 with well-developed crystal structure. At 0. 1C,0. 25C and 0. 5C,the initial discharge capacities were 150. 6,134. 1 and 107. 1 mAh·g-1 ,respectively. Capacity retention rates were 87. 3% after 130 cycles at 0. 25C and 87. 2% after 105 cycles at 0. 5C. Charge-discharge efficiencies were all above 80% and the average discharge …
Nano/Micro-Structured Electrode Materials For Lithium-Ion Batteries, Yu-Guo Guo, Zhong-Li Wang, Xing-Long Wu, Wei-Ming Zhang, Li-Jun Wan
Nano/Micro-Structured Electrode Materials For Lithium-Ion Batteries, Yu-Guo Guo, Zhong-Li Wang, Xing-Long Wu, Wei-Ming Zhang, Li-Jun Wan
Journal of Electrochemistry
Nanostructured materials are currently of interest as high performance anodes and cathodes for rechargeable lithium-ion batteries because of their novel nano-size effects and significantly enhanced kinetics. This review paper describes some recent developments in this field,addressing the size effects,morphology effects,as well as the functions of carbon coating layers toward lithium storage. Several"kinetically stabilized"nano/microstructured electrode materials and high-rate electrode materials with mixed-conducting networks based on the work of the authors are highlighted for illustration.
Structure And Electrochemical Characteristics Of Lifepo_4 Prepared By The Polyacrylates-Pyrolysis-Reduction Method For Li-Ion Batteries, Li-Hong Yu, Yu-Liang Cao, Xiao-Fei Zhang, Han-Xi Yang, Xin-Ping Ai
Structure And Electrochemical Characteristics Of Lifepo_4 Prepared By The Polyacrylates-Pyrolysis-Reduction Method For Li-Ion Batteries, Li-Hong Yu, Yu-Liang Cao, Xiao-Fei Zhang, Han-Xi Yang, Xin-Ping Ai
Journal of Electrochemistry
The cathode material of olivine LiFePO_(4) was prepared by a novel method of polyacrylate-pyrolysis-reduction.XRD demonstrates that the material have the olivine structure.SEM photo shows an average particle-size of about 100 nm with a well distribution.Electrochemical test of cycling at a constant current reveals the discharge capacity of 138 mAh/g and a good cycling stability.It is a novel practicable technology to prepare LiFePO_(4) by using polyacrylate-pyrolysis-reduction method.
Preparation And Characterization Of Mcm-41/ Pvdf-Hfp Composite Microporous Polymer Electrolytes For Li-Ion Batteries, Zuo-Feng Chen
Preparation And Characterization Of Mcm-41/ Pvdf-Hfp Composite Microporous Polymer Electrolytes For Li-Ion Batteries, Zuo-Feng Chen
Journal of Electrochemistry
MCM-41/vinylidine fluoride-hexafluropropene copolymer (PVdF-HFP) composite microporous polymer electrolytes were prepared with mixed solvent of N, N-Dimethylformamide (DMF) and acetone. The influence of MCM-41 and nano-SiO_(2) on the porous structure of the microporous polymer electrolytes were studied with SEM. The results show that MCM-41 could take the place of the plasticizer in the process of making pores, and bring the preparation of microporous membranes easily. The preliminary electrochemical tests showed that the ion conductivity of composite microporous polymer electrolyte with 10% MCM-41 was about 10~(-3) S cm~(-1), and the performance of batteries was improved. The mesoporous MCM-41selected in the paper possesses …