Electrical and Computer Engineering Commons^™

Pier Ocean Pier, Brandon J. Nowak

Computer Engineering

Pier Ocean Peer is a weatherproof box containing a Jetson Nano, connected to a cell modem and camera, and powered by a Lithium Iron Phosphate battery charged by a 50W solar panel. This system can currently provide photos to monitor the harbor seal population that likes to haul out at the base of the Cal Poly Pier, but more importantly it provides a platform for future expansion by other students either though adding new sensors directly to the Jetson Nano or by connecting to the jetson nano remotely through a wireless protocol of their choice.

Real Time And High Fidelity Quadcopter Tracking System, Tyler Mckay Hall

Computer Engineering

This project was conceived as a desired to have an affordable, flexible and physically compact tracking system for high accuracy spatial and orientation tracking. Specifically, this implementation is focused on providing a low cost motion capture system for future research. It is a tool to enable the further creation of systems that would require the use of accurate placement of landing pads, payload acquires and delivery. This system will provide the quadcopter platform a coordinate system that can be used in addition to GPS.

Field research with quadcopter manufacturers, photographers, agriculture and research organizations were contact and interviewed for information …

Multispectral Identification Array, Zachary D. Eagan

Computer Engineering

The Multispectral Identification Array is a device for taking full image spectroscopy data via the illumination of a subject with sixty-four unique spectra. The array combines images under the illumination spectra to produce an approximate reflectance graph for every pixel in a scene. Acquisition of an entire spectrum allows the array to differentiate objects based on surface material. Spectral graphs produced are highly approximate and should not be used to determine material properties, however the output is sufficiently consistent to allow differentiation and identification of previously sampled subjects. While not sufficiently advanced for use as a replacement to spectroscopy the …

Electronic Deer Warning System, David Zhuo, Anlang Lu

Computer Engineering

Deer-vehicle collisions (DVCs) are extremely dangerous, often injuring or even killing drivers. Unfortunately, this form of automotive accident is commonplace in the United States. According to the NHTSA, DVCs result in 200 human deaths a year.2

Despite these deadly incidents, there currently are no deployed federal or state systems for preventing DVCs. There are many consumer electronic deer deterrent products, but their long-term effectiveness is questionable.3 In fact, there does not appear to be much research into electronic deer deterrent systems. Aside from constant audio output and electric shock, no other means of electronic deterrent exist. Even if fixed deterrents …

Real-Time Digital Effects Processing Using Ios, Jonah W. Clinard

Computer Engineering

In today’s society, we are seeing incredible improvements in terms of creating smaller technological devices that behave more and more like the personal computers of yesterday. Mobile “Smart” devices, in particular, are becoming incredibly powerful not just in terms of processing power, but in the fact that they are able to provide assistance to users in their everyday lives. Application developers are now able utilize the power and size of these devices, to create and realize ideas that would have been previously viewed as impossible. This project applies the fields of digital signal processing, music, and mobile application development, to …

Rfid Microscope Lab, Patricia Carranza

Computer Engineering

The RFID Microscope Lab is a new exhibit created for the San Luis Obispo Children's Museum. The goal of the project is to create a modern, interactive exhibit that will teach children about different natural specimens through the use of technology. A computer, custom software, and RFID technology, will be used to display facts, microscopic images, and short videos of ten different specimens.

Team Omnimouse, Derek J. Halman, Josh B. Porter, Steven A. Silver, Ian S. Stemper

Computer Engineering

INFORMATION, DATA, FIGURES AND DRAWINGS EMBODIED IN THIS DOCUMENT ARE STRICTLY CONFIDENTIAL AND ARE SUPPLIED ON THE UNDERSTANDING THAT THEY WILL NOT BE DISCLOSED TO THIRD PARTIES WITHOUT THE PRIOR WRITTEN CONSENT OF QUALITY OF LIFE PLUS.

Ultraviolet Led Biofouling Mitigation, Andrew Lam

Computer Engineering

The goal is to determine if low-cost UV LEDs can mitigate marine biofouling on small glass or acrylic camera lenses. A microprocessor-controlled experimental setup to control the illumination of low-cost UV LEDs of various wavelength and packaging was fashioned. The system consists of a programmed microcontroller, a manufactured LED breakout interface, and a submergible UV LED array enclosed in a borosilicate glass tube. A preliminary qualitative assessment of four different UV LEDs was conducted during a three-week deployment of the experimental setup in the raw seawater system at the Cal Poly Center for Costal and Marine Sciences in Avila Beach, …

Obd2 Pid Reader, Andrew Fong

Computer Engineering

The most current standard on automobiles for monitoring data is OBD-II. Using On board diagnostic Parameter ID (OBD PID) codes hobbyists and mechanics have the ability to monitor, chart, and obtain data on cars by communicating to the ECU. The OBD-II connector is often located under the driver’s side inside of the car. The hardware will consist of a generic Bluetooth OBD2 connector and a laptop running windows. The software will be an program exe created by visual basic. The software created in visual basic will allow the user to examine PID codes in order to record and discover new …

Frg Turbojet, Tyler Vitti

Computer Engineering

Members of the Cal Poly SLO campus club FRG work together with students of several different disciplines to build a functional turbojet engine. Engineering approaches include design, fabrication, testing, and computer sensing, control, and integration. The goal of the project is to produce a running turbojet engine monitored and controlled by embedded hardware and specialized PC software. This project is to be used by later groups for further research and development.

Bluebeats, Jake Muir, Aaron Martinez, Mishal Shah, Richard Wissemann

Computer Engineering

Our group’s senior project is called BlueBeats. The BlueBeats product was created in order to provide a wireless audio gateway between Bluetooth enabled devices. Users of BlueBeats can use an Android or computer application to interface with the BlueBeats device. The Android and computer applications allow the user to easily scan for devices, add/remove devices from their personal list, and pair/connect with a selected Bluetooth enabled device. Once the user is connected to the BlueBeats device, he/she has two options. The first option occurs when the user connects the BlueBeats device to a device with speakers (using 3.5mm audio jack …

Kreative Outlets, Travis Crist, Steve Clark, Jason Peressini

Computer Engineering

With the widespread use of smart phones and the advancement of WiFi technologies, people now have the Internet at their fingertips at all times. Home automation and control has the possibility of becoming the next big technology that can utilize the abundant availability of the Internet. This paper documents the findings and results of a project aimed at developing the infrastructure needed for a home automation system that is accessible anywhere. We implemented a system that utilized a web enabled ethernet connection and RF wireless technology to control AC outlets and provide the user with feedback information about the status …

Ultrasonic Shark-Tag Locator System For Iver2 Auv, Nathaniel Garcia

Computer Engineering

The purpose of this project is to develop a system for tracking an ultrasonic underwater transmitter that can be integrated into an IVER2 AUV to allow it to follow and monitor tagged sharks in the ocean for scientific research.

The system consists of a four main components including a shark-tag, two hydrophones, a filter/amplifier & threshold detector circuit, and a microcontroller.

This project, while not completing field testing and integration with the IVER2, is a proof of concept of a system that utilizes passive sonar to determine a bearing from the system to a shark-tag transmitter. Additionally, it devised several …

Global Positioning Logger, Matthew Hall

Computer Engineering

The Global Positioning Logger (GPL) is a mobile embedded device that utilizes GPS technology. The GPS data is used to display current speed and past global locations.