Computer Engineering Commons^™

A Robust Platform For Mobile Robotics Teaching And Developing Using Arduino’S Integrated Development Environment (Ide) For Programming The Arduino Mega 2560, Sajjad Alhassan

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

In light of the rapid pace at which development happens with modern technology, mobile robots play an important role in our daily lives. This is due to their great importance in facilitating the affairs of life in various economic, commercial, industrial, scientific, and many other fields. In this research and project, we have restructured the microcontroller and system for one of the mobile robots (CEENBOT) that was designed by the University of Nebraska and replaced it with an Arduino Mega 2560.

The purpose of using the Arduino Mega 2560 robot is to provide alternative programming for the CEENBOT platform to …

Low Power Multi-Channel Interface For Charge Based Tactile Sensors, Samuel Hansen

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

Analog front end electronics are designed in 65 nm CMOS technology to process charge pulses arriving from a tactile sensor array. This is accomplished through the use of charge sensitive amplifiers and discrete time filters with tunable clock signals located in each of the analog front ends. Sensors were emulated using Gaussian pulses during simulation. The digital side of the system uses SAR (successive approximation register) ADCs for sampling of the processed sensor signals.

Adviser: Sina Balkır

A Stacking-Based Misbehavior Detection System In Vehicular Communication Networks, Troy Green

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

Over the past few decades communication systems for vehicles have continued to advance. Communications between these vehicles can be classified into safety related and non safety related messages. An example of a safety related message would be one vehicle warning others of an icy road it encountered, where a non safety related communication would be a passenger streaming a movie. In either case it's important to secure the communications so that the system continues to behave as expected. In this thesis we propose a Misbehavior Detection System (MDS), which is a system that monitors messages sent between vehicles, and detects …

A Low-Power, Low-Area 10-Bit Sar Adc With Length-Based Capacitive Dac, Zhili Pan

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

A 2.5 V single-ended 10-bit successive-approximation-register analog-to-digital converter (SAR ADC) based on the TSMC 65 nm CMOS process is designed with the goal of achieving low power consumption (33.63 pJ/sample) and small area (2874 µm^2 ). It utilizes a novel length-based capacitive digital-to-analog converter (CDAC) layout to achieve low total capacitance for power efficiency, and a custom static asynchronous logic to free the dependence on a high-frequency external clock source. Two test chips have been designed and the problems found through testing the first chip are analyzed. Multiple improved versions of the ADC with minor variations are implemented on the …

A Novel Testbed For Evaluation Of Operational Technology Communications Protocols And Their On-Device Implementations, Matthew Boeding

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

Operational Technology (OT) and Infrastructure Technology (IT) systems are converging with the rapid addition of centralized remote management in OT systems. Previously air-gapped systems are now interconnected through the internet with application-specific protocols. This has led to systems that had limited access points being remotely accessible. In different OT sectors, legacy protocols previously transmitted over serial communication were updated to allow internet communication with legacy devices. New protocols such as IEC-61850 were also introduced for monitoring of different OT resources. The IEC-61850 standard’s Generic Object Oriented Substation Event (GOOSE) protocol outlines the representation and communication of a variety of different …

Femtosecond Laser Surface Processing To Create Self-Organized Micro- And Nano-Scale Features On Composite And Ceramic Materials, Nate Koeppe

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

Femtosecond laser surface processing (FLSP) is applied to a range of materials in this thesis. The materials studied were a carbon fiber reinforced polymer (CFRP), a thermosetting polymer, silicon nitride (Si₃N₄), and ceramic alumina. The CFRP is a composite material consisting of a thermosetting polymer and carbon fibers. The CFRP are referred to as a composite and the thermosetting polymer is referred to as a resin in this thesis. Alumina can exist in many different forms. The alumina used is 0.5 mm thick nonporous alumina sheets purchased from McMaster-Carr, and will be referred to as alumina …

One-Bit Algorithm Considerations For Sparse Pmcw Radar, Ethan Triplett

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

Phase Modulated Continuous Wave (PMCW) radar an emerging technology for autonomous cars. It is more flexible than the current frequency modulated systems, offering better detection resolution, interference mitigation, and future development opportunities. The issue preventing PMCW adoption is the need for high sample-rate analog to digital converters (ADCs). Due to device limits, a large increase in cost and power consumption occurs for every added resolution bit for a given sampling rate. This thesis explores radar detection techniques for few-bit and 1-bit ADC measurements. 1-bit quantization typically results in poor amplitude estimation, which can limit detections if the target signals are …

Identification Of Orthologous Gene Groups Using Machine Learning, Dillon Burgess

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

Identification of genes that show similarity between different organisms, a.k.a orthologous genes, is an open problem in computational biology. The purpose of this thesis is to create an algorithm to group orthologous genes using machine learning. Following an optimization step to find the best characterization based on training data, we represented sequences of genes or proteins with kmer vectors. These kmer vectors were then clustered into orthologous groups using hierarchical clustering. We optimized the clustering phase with the same training data for the method and parameter selection. Our results indicated that use of protein sequences with k=2 and scaling the …

Learning Domain Invariant Information To Enhance Presentation Attack Detection In Visible Face Recognition Systems, Jennifer Hamblin

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

Face signatures, including size, shape, texture, skin tone, eye color, appearance, and scars/marks, are widely used as discriminative, biometric information for access control. Despite recent advancements in facial recognition systems, presentation attacks on facial recognition systems have become increasingly sophisticated. The ability to detect presentation attacks or spoofing attempts is a pressing concern for the integrity, security, and trust of facial recognition systems. Multi-spectral imaging has been previously introduced as a way to improve presentation attack detection by utilizing sensors that are sensitive to different regions of the electromagnetic spectrum (e.g., visible, near infrared, long-wave infrared). Although multi-spectral presentation attack …