Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Computer Engineering
Design Project: 3d Printer/Injection Molder Hybrid, Lee Paolucci, Luke Everhart, Brandon Leap, Karson Lorey
Design Project: 3d Printer/Injection Molder Hybrid, Lee Paolucci, Luke Everhart, Brandon Leap, Karson Lorey
Williams Honors College, Honors Research Projects
In the realm of rapid, small-scale prototyping, there are a few main factors that drive decisions to invest resources in technology to make that prototyping possible. Cost and ease of use are two of the most influential when looking at most SMEs (Small to Medium-sized Enterprises). The U.S. Small Business Administration defines an SME as smaller than 1,250 employees. According to An Assessment of Implementation of Entry-Level 3D Printers from the Perspective of Small Businesses, 59% of small manufacturers had implemented 3D printers as of 2014. However, no matter what technology is used in rapid prototyping, there are common …
Penetration Testing In A Small Business Network, Lee Kandle
Penetration Testing In A Small Business Network, Lee Kandle
Williams Honors College, Honors Research Projects
Penetration testing on a business network consisting of three routers, one switch, and one computer. Access Control Lists (ACLs) on the routers act as the firewall(s) for the network. 10 of the twelve ACLs do not deny any form of traffic to reflect the lax security standards common in small networks. Router 1 acts as the primary router of the Attacker/Pen Tester. Router 2 represents the edge router for the business and Router 3 is the inner router closest to end-user devices. Switch 1 is connected to Router 3 with one computer connected to the switch acting as an end-user. …