Computer Engineering Commons^™

Chatgpt As Metamorphosis Designer For The Future Of Artificial Intelligence (Ai): A Conceptual Investigation, Amarjit Kumar Singh (Library Assistant), Dr. Pankaj Mathur (Deputy Librarian)

Library Philosophy and Practice (e-journal)

Abstract

Purpose: The purpose of this research paper is to explore ChatGPT’s potential as an innovative designer tool for the future development of artificial intelligence. Specifically, this conceptual investigation aims to analyze ChatGPT’s capabilities as a tool for designing and developing near about human intelligent systems for futuristic used and developed in the field of Artificial Intelligence (AI). Also with the helps of this paper, researchers are analyzed the strengths and weaknesses of ChatGPT as a tool, and identify possible areas for improvement in its development and implementation. This investigation focused on the various features and functions of ChatGPT that …

Non-Obstetrical Robotic-Assisted Laparoscopic Surgery In Pregnancy: A Systematic Literature Review., Courtney Capella, Joseph Godovchik, Thenappan Chandrasekar, Huda B. Al-Kouatly

Department of Urology Faculty Papers

Urologic and gynecologic surgeons are the top utilizers of robotic surgery; however, non-obstetrical robotic-assisted laparoscopic surgery (RALS) in pregnant patients is infrequent. A systematic literature review was performed to ascertain the frequency, indication and complications of RALS in pregnancy. Results showed thirty-eight pregnancies from eleven publications between 2008-2020. Five cases were for urologic indication and thirty-three for gynecologic indication. Minimal surgical alterations were required. Although no adverse maternal-fetal outcomes were reported, there are not enough cases published to determine safety. This review demonstrates the feasibility of RALS for the pregnant population in the hands of competent robotic surgeons.

Improving 3d Printed Prosthetics With Sensors And Motors, Rachel Zarin

Honors Projects

A 3D printed hand and arm prosthetic was created from the idea of adding bionic elements while keeping the cost low. It was designed based on existing models, desired functions, and materials available. A tilt sensor keeps the hand level, two motors move the wrist in two different directions, a limit switch signals the fingers to open and close, and another motor helps open and close the fingers. All sensors and motors were built on a circuit board, programmed using an Arduino, and powered by a battery. Other supporting materials include metal brackets, screws, guitar strings, elastic bands, small clamps, …