Open Access. Powered by Scholars. Published by Universities.®

Computer Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Computer Engineering

Outdoor Operations Of Multiple Quadrotors In Windy Environment, Deepan Lobo May 2022

Outdoor Operations Of Multiple Quadrotors In Windy Environment, Deepan Lobo

Dissertations

Coordinated multiple small unmanned aerial vehicles (sUAVs) offer several advantages over a single sUAV platform. These advantages include improved task efficiency, reduced task completion time, improved fault tolerance, and higher task flexibility. However, their deployment in an outdoor environment is challenging due to the presence of wind gusts. The coordinated motion of a multi-sUAV system in the presence of wind disturbances is a challenging problem when considering collision avoidance (safety), scalability, and communication connectivity. Performing wind-agnostic motion planning for sUAVs may produce a sizeable cross-track error if the wind on the planned route leads to actuator saturation. In a multi-sUAV …


Heterogeneous Multi-Sensor Fusion For 2d And 3d Pose Estimation, Hanieh Deilamsalehy Jan 2017

Heterogeneous Multi-Sensor Fusion For 2d And 3d Pose Estimation, Hanieh Deilamsalehy

Dissertations, Master's Theses and Master's Reports

Sensor fusion is a process in which data from different sensors is combined to acquire an output that cannot be obtained from individual sensors. This dissertation first considers a 2D image level real world problem from rail industry and proposes a novel solution using sensor fusion, then proceeds further to the more complicated 3D problem of multi sensor fusion for UAV pose estimation.

One of the most important safety-related tasks in the rail industry is an early detection of defective rolling stock components. Railway wheels and wheel bearings are two components prone to damage due to their interactions with the …


Design Of An All-In-One Embedded Flight Control System, Joel D. Elmore Jan 2015

Design Of An All-In-One Embedded Flight Control System, Joel D. Elmore

Theses and Dissertations

This thesis describes an all-in-one flight control system (FCS) that was designed for unmanned aerial vehicles (UAVs). The project focuses on the embedded hardware aspect of a stand-alone system with low-cost and reliability in mind.


Cooperative Remote Sensing And Actuation Using Networked Unmanned Vehicles, Haiyang Chao May 2010

Cooperative Remote Sensing And Actuation Using Networked Unmanned Vehicles, Haiyang Chao

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

This dissertation focuses on how to design and employ networked unmanned vehicles for remote sensing and distributed control purposes in the current information-rich world. The target scenarios are environmental or agricultural applications such as river/reservoir surveillance, wind profiling measurement, and monitoring/control of chemical leaks, etc. AggieAir, a small and low-cost unmanned aircraft system, is designed based on the remote sensing requirements from environmental monitoring missions. The state estimation problem and the advanced lateral flight controller design problem are further attacked focusing on the small unmanned aerial vehicle (UAV) platform. Then the UAV-based remote sensing problem is focused with further flight …