Open Access. Powered by Scholars. Published by Universities.®
- Institution
- Keyword
-
- #antcenter (1)
- AFLR (1)
- Advanced air mobility (1)
- Advancing front (1)
- Anomaly (1)
-
- Arduplane (1)
- Augmented reality (1)
- Augmented reality system (1)
- Autoregressive (1)
- Catching Heuristics (1)
- Continuous Partially Observable Markov Decision Process (1)
- Control applications (1)
- Convolutional neural networks (1)
- Data recorder (1)
- Dilution (1)
- Drone aircraft (1)
- Dronekit (1)
- Estimation (1)
- Image segmentation (1)
- Image-aided navigation (1)
- Iterative Linear Quadratic Gaussian (1)
- Levenberg (1)
- Local reconnection (1)
- MAVlink (1)
- Machine Learning (1)
- Marquardt (1)
- Mesh refinement (1)
- Metric (1)
- Observers for nonlinear systems (1)
- Outfielder Problem (1)
- Publication
-
- Computer Science Theses & Dissertations (1)
- Department of Computer Science and Engineering: Dissertations, Theses, and Student Research (1)
- Electrical & Computer Engineering Faculty Publications (1)
- Electronic Thesis and Dissertation Repository (1)
- Graduate Theses, Dissertations, and Problem Reports (1)
- Publication Type
Articles 1 - 11 of 11
Full-Text Articles in Computer Engineering
Parallelization Of The Advancing Front Local Reconnection Mesh Generation Software Using A Pseudo-Constrained Parallel Data Refinement Method, Kevin Mark Garner Jr.
Parallelization Of The Advancing Front Local Reconnection Mesh Generation Software Using A Pseudo-Constrained Parallel Data Refinement Method, Kevin Mark Garner Jr.
Computer Science Theses & Dissertations
Preliminary results of a long-term project entailing the parallelization of an industrial strength sequential mesh generator, called Advancing Front Local Reconnection (AFLR), are presented. AFLR has been under development for the last 25 years at the NSF/ERC center at Mississippi State University. The parallel procedure that is presented is called Pseudo-constrained (PsC) Parallel Data Refinement (PDR) and consists of the following steps: (i) use an octree data-decomposition scheme to divide the original geometry into subdomains (octree leaves), (ii) refine each subdomain with the proper adjustments of its neighbors using the given refinement code, and (iii) combine all subdomain data into …
Onboard Autonomous Controllability Assessment For Fixed Wing Suavs, Brian Edward Duvall
Onboard Autonomous Controllability Assessment For Fixed Wing Suavs, Brian Edward Duvall
Mechanical & Aerospace Engineering Theses & Dissertations
Traditionally fixed-wing small Unmanned Arial Vehicles (sUAV) are flown while in direct line of sight with commands from a remote operator. However, this is changing with the increased popularity and ready availability of low-cost flight controllers. Flight controllers provide fixed-wing sUAVs with functions that either minimize or eliminate the need for a remote operator. Since the remote operator is no longer controlling the sUAV, it is impossible to determine if the fixed-wing sUAV has proper control authority. In this work, a controllability detection system was designed, built, and flight-tested using COTS hardware. The method features in-situ measurement and analysis of …
Finite-Time State Estimation For An Inverted Pendulum Under Input-Multiplicative Uncertainty, Sergey V. Drakunov, William Mackunis, Anu Kossery Jayaprakash, Krishna Bhavithavya Kidambi, Mahmut Reyhanoglu
Finite-Time State Estimation For An Inverted Pendulum Under Input-Multiplicative Uncertainty, Sergey V. Drakunov, William Mackunis, Anu Kossery Jayaprakash, Krishna Bhavithavya Kidambi, Mahmut Reyhanoglu
Publications
A sliding mode observer is presented, which is rigorously proven to achieve finite-time state estimation of a dual-parallel underactuated (i.e., single-input multi-output) cart inverted pendulum system in the presence of parametric uncertainty. A salient feature of the proposed sliding mode observer design is that a rigorous analysis is provided, which proves finite-time estimation of the complete system state in the presence of input-multiplicative parametric uncertainty. The performance of the proposed observer design is demonstrated through numerical case studies using both sliding mode control (SMC)- and linear quadratic regulator (LQR)-based closed-loop control systems. The main contribution presented here is the rigorous …
Terramechanics And Machine Learning For The Characterization Of Terrain, Bryan W. Southwell
Terramechanics And Machine Learning For The Characterization Of Terrain, Bryan W. Southwell
Electronic Thesis and Dissertation Repository
An instrumented rover wheel can collect vast amounts of data about a planetary surface. Planetary surfaces are changed by complex geological processes which can be better understood with an abundance of surface data and the use of terramechanics. Identifying terrain parameters such as cohesion and angle of friction hold importance for both the rover driver and the planetary scientist. Knowledge of terrain characteristics can warn of unsafe terrain and flag potential interesting scientific sites. The instrumented wheel in this research utilizes a pressure pad to sense load and sinkage, a string potentiometer to measure slip, and records motor current draw. …
Power-Over-Tether Uas Leveraged For Nearly-Indefinite Meteorological Data Acquisition, Daniel Rico, Carrick Detweiler, Francisco Muñoz-Arriola
Power-Over-Tether Uas Leveraged For Nearly-Indefinite Meteorological Data Acquisition, Daniel Rico, Carrick Detweiler, Francisco Muñoz-Arriola
Department of Computer Science and Engineering: Dissertations, Theses, and Student Research
Use of unmanned aerial systems (UASs) in agriculture has risen in the past decade. These systems are key to modernizing agriculture. UASs collect and elucidate data previously difficult to obtain and used to help increase agricultural efficiency and production. Typical commercial off-the-shelf (COTS) UASs are limited by small payloads and short flight times. Such limits inhibit their ability to provide abundant data at multiple spatiotemporal scales. In this paper, we describe the design and construction of the tethered aircraft unmanned system (TAUS), which is a novel power-over-tether UAS leveraging the physical presence of the tether to launch multiple sensors along …
Work-In-Progress: Augmented Reality System For Vehicle Health Diagnostics And Maintenance, Yuzhong Shen, Anthony W. Dean, Rafael Landaeta
Work-In-Progress: Augmented Reality System For Vehicle Health Diagnostics And Maintenance, Yuzhong Shen, Anthony W. Dean, Rafael Landaeta
Electrical & Computer Engineering Faculty Publications
This paper discusses undergraduate research to develop an augmented reality (AR) system for diagnostics and maintenance of the Joint Light Tactical Vehicle (JLTV) employed by U.S. Army and U.S. Marine Corps. The JLTV’s diagnostic information will be accessed by attaching a Bluetooth adaptor (Ford Reference Vehicle Interface) to JLTV’s On-board diagnostics (OBD) system. The proposed AR system will be developed for mobile devices (Android and iOS tablets and phones) and it communicates with the JLTV’s OBD via Bluetooth. The AR application will contain a simplistic user interface that reads diagnostic data from the JLTV, shows vehicle sensors, and allows users …
Augmented Reality In A Dynamic Drone Based Environment, Christopher Davis
Augmented Reality In A Dynamic Drone Based Environment, Christopher Davis
Honors Theses
Augmented Reality (AR) and Unmanned Ariel Vehicles (UAVs) are fast advancing technologies, and this research seeks to combine them to offer an effective, user friendly approach for monitoring infrastructure. Drones provide a means to easily access otherwise difficult to reach locations and visualize useful information with Augmented Reality. A UAV employs a wide-angle view and, when paired with AR, this will enable the user to better complete their task by effortlessly providing the critical information they need in the most intuitive way possible. This research is particularly applicable for civil applications such as construction and monitoring of difficult to access …
Nonlinear Least Squares 3-D Geolocation Solutions Using Time Differences Of Arrival, Michael V. Bredemann
Nonlinear Least Squares 3-D Geolocation Solutions Using Time Differences Of Arrival, Michael V. Bredemann
Mathematics & Statistics ETDs
This thesis uses a geometric approach to derive and solve nonlinear least squares minimization problems to geolocate a signal source in three dimensions using time differences of arrival at multiple sensor locations. There is no restriction on the maximum number of sensors used. Residual errors reach the numerical limits of machine precision. Symmetric sensor orientations are found that prevent closed form solutions of source locations lying within the null space. Maximum uncertainties in relative sensor positions and time difference of arrivals, required to locate a source within a maximum specified error, are found from these results. Examples illustrate potential requirements …
Semantic Segmentation Of Aerial Imagery Using U-Nets, Terence J. Yi
Semantic Segmentation Of Aerial Imagery Using U-Nets, Terence J. Yi
Theses and Dissertations
In situations where global positioning systems are unavailable, alternative methods of localization must be implemented. A potential step to achieving this is semantic segmentation, or the ability for a model to output class labels by pixel. This research aims to utilize datasets of varying spatial resolutions and locations to train a fully convolutional neural network architecture called the U-Net to perform segmentations of aerial images. Variations of the U-Net architecture are implemented and compared to other existing models in order to determine the best in detecting buildings and roads. A final dataset will also be created combining two datasets to …
Real-Time Urban Weather Observations For Urban Air Mobility, Kevin A. Adkins, Mustafa Akbas, Marc Compere
Real-Time Urban Weather Observations For Urban Air Mobility, Kevin A. Adkins, Mustafa Akbas, Marc Compere
International Journal of Aviation, Aeronautics, and Aerospace
Cities of the future will have to overcome congestion, air pollution and increasing infrastructure cost while moving more people and goods smoothly, efficiently and in an eco-friendly manner. Urban air mobility (UAM) is expected to be an integral component of achieving this new type of city. This is a new environment for sustained aviation operations. The heterogeneity of the urban fabric and the roughness elements within it create a unique environment where flight conditions can change frequently across very short distances. UAM vehicles with their lower mass, more limited thrust and slower speeds are especially sensitive to these conditions. Since …
Fast Decision-Making Under Time And Resource Constraints, Kyle Gabriel Lassak
Fast Decision-Making Under Time And Resource Constraints, Kyle Gabriel Lassak
Graduate Theses, Dissertations, and Problem Reports
Practical decision makers are inherently limited by computational and memory resources as well as the time available in which to make decisions. To cope with these limitations, humans actively seek methods which limit their resource demands by exploiting structure within the environment and exploiting a coupling between their sensing and actuation to form heuristics for fast decision-making. To date, such behavior has not been replicated in artificial agents. This research explores how heuristics may be incorporated into the decision-making process to quickly make high-quality decisions through the analysis of a prominent case study: the outfielder problem. In the outfielder problem, …