Civil and Environmental Engineering Commons^™

Developing Corridor-Level Truck Travel Time Estimates And Other Freight Performance Measures From Archived Its Data, Christopher M. Monsere, Michael Wolfe, Heba Alawakiel, Max Taylor Stephens

TREC Final Reports

The objectives of this research were to retrospectively study the feasibility for using truck transponder data to produce freight corridor performance measures (travel times) and real-time traveler information. To support this analysis, weigh-in-motion data from each of the twenty-two stations in Oregon were assembled, processed, and uploaded in the WIM data archive is housed under the Portland Transportation Archive Listing (PORTAL) umbrella at Portland State University’s Intelligent Transportation Systems Lab. Nearly 42,000,000 truck records were successful uploaded to the archive dating back to July 2005. Two separate algorithms necessary for this research were scripted, tested, and validated. The closest stations …

Environmental Durability Of Reinforced Concrete Deck Girders Strengthened For Shear With Surface Bonded Carbon Fiber-Reinforced Polymer, Christopher Higgins, Matthew R. Dawson, Mikal M. Mitchell, Gautam Sopal, A. Ekin Senturk

TREC Final Reports

This research investigated the durability of carbon fiber-reinforced polymer composites (CFRP) used for shear strengthening reinforced concrete deck girders. Large beams were used to avoid accounting for size effects in the data analysis. The effort included determining the role of freeze-thaw, moisture, and fatigue on structural performance and developing analytical design procedures that account for durability.

The results showed that moisture infiltration behind the CFRP, combined with freeze-thaw, was critical in reducing shear panel stiffness and shear capacity. Long-term moisture exposure alone produced only a minor decrease in shear capacity. Freeze-thaw, combined with fatigue, had little effect on shear capacity …

Practical Approximations To Quantify The Impact Of Time Windows And Delivery Sizes On Vmt Multi-Stop Tours, Miguel A. Figliozzi

Civil and Environmental Engineering Faculty Publications and Presentations

This paper studies approximations to the average length of Vehicle Routing Problems (VRP). The approximations are valuable for strategic and planning analysis of transportation and logistics problems. The research focus is on VRP with varying number of customers, demands, and locations. This modeling environment can be used in transport and logistics models that deal with a distribution center serving an area with daily variations in the demand. The routes are calculated daily based on what freight is available. New approximations and experimental settings are introduced. Average distance travelled is estimated as a function of the number of customers served and …

Finite Element Modeling Of Nondestructive Test Methods Used For Detection Of Delamination In Hot Mix Asphalt Pavements, Dante Mejia Munoz

Open Access Theses & Dissertations

For the simulation of detection of delamination this study focus on three NDT methods: Impact Echo, Impulse Response and Ultrasonic Surface Waves. The was evaluated and then a parametric study was elaborated.

Application Of Lrfd Geotechnical Principles For Pile Supported Bridges In Oregon: Phase 1, Trevor D. Smith, Peter Dusicka

TREC Final Reports

Bridge foundations must be designed based on acceptable risks of failure. To secure rapid implementation of Load Resistance Factor Design (LRFD) principles for foundation design, the American Association of State Highway and Transportation Officials (AASHTO) and the Federal Highway Administration (FHWA) are requiring their use through AASHTO code. The Bridge Section of the Oregon Department of Transportation (ODOT) has responsibility for satisfactory design of all the bridge structures across the state’s highway system. The widespread geotechnical adoption of the LRFD code throughout state DOTs has been difficult in the case of deep foundations due to regional differences and in some …