Open Access. Powered by Scholars. Published by Universities.®
- Keyword
-
- Spallation (2)
- 3D PEG (1)
- Ablation (1)
- Aerothermodynamics (1)
- Atmospheric entry (1)
-
- Capacitive deionization (1)
- Chemical Kinetics (1)
- Coarse-grained (1)
- Combustion (1)
- Deposition of Protein (1)
- Diffusion (1)
- Dissipation Scales (1)
- External Intermittency (1)
- Free-Stream Turbulence (1)
- Gradient of Protein (1)
- Henry’s Law (1)
- High-speed imaging (1)
- Ionic liquids (1)
- Lagrangian Particle Trajectory (1)
- Material Response (1)
- Mechanism Reduction (1)
- Molecular dynamics (1)
- NOx (1)
- Particle-laden flows (1)
- Pressure-Driven Oxygen Dissolution (1)
- Proper orthogonal decomposition (1)
- Radiation Heat Transfer (1)
- Rotary bell atomization (1)
- Salt Adsorption Capacity (1)
- Salt Adsorption Rate (1)
Articles 1 - 8 of 8
Full-Text Articles in Chemical Engineering
Impact Of Spallation And Internal Radiation On Fibrous Ablative Materials, Raghava Sai Chaitanya Davuluri
Impact Of Spallation And Internal Radiation On Fibrous Ablative Materials, Raghava Sai Chaitanya Davuluri
Theses and Dissertations--Mechanical Engineering
Space vehicles are equipped with Thermal Protection Systems (TPS) that encounter high heat rates and protect the payload while entering a planetary atmosphere. For most missions that interest NASA, ablative materials are used as TPS. These materials undergo several mass and energy transfer mechanisms to absorb intense heat. The size and construction of the TPS are based on the composition of the planetary atmosphere and the impact of various ablative mechanisms on the flow field and the material. Therefore, it is essential to quantify the rates of different ablative phenomena to model TPS accurately. In this work, the impact of …
Coarse-Grained Dynamically Accurate Simulations Of Ionic Liquids At Vacuum-Interface, Tyler D. Stoffel
Coarse-Grained Dynamically Accurate Simulations Of Ionic Liquids At Vacuum-Interface, Tyler D. Stoffel
Theses and Dissertations--Mechanical Engineering
Ionic liquids, possessing improved properties in many areas of technical application, are excellent candidates as components in development of next-generation technology, including ultra-high energy batteries. If they are thus applied, however, extensive interfacial analysis of any selected ionic configuration will likely be required. Molecular dynamics (MD) provides an advantageous route by which this may be accomplished, but can fall short in observing some phenomena only present at larger time/length scales than it can simulate. Often times this is approached by coarse-graining (CG), with which scope of simulation can be significantly increased. However, coarse-grained MD systems are generally known to produce …
NoX Formation In Light-Hydrocarbon, Premixed Flames, Robert T. Hughes
NoX Formation In Light-Hydrocarbon, Premixed Flames, Robert T. Hughes
Theses and Dissertations--Mechanical Engineering
This study explores the reactions and related species of NOx pollutants in methane flames in order to understand their production and consumption during the combustion process. To do this, several analytical simulations were run to explore the behavior of nitrogen species in the pre-flame, post- flame, and reaction layer regions. The results were then analyzed in order to identify all "steady-state" species in the flame as well as the determine all the unnecessary reactions and species that are not required to meet a defined accuracy. The reductions were then applied and proven to be viable.
Intermittency Effects On The Universality Of Local Dissipation Scales In Turbulent Boundary Layer Flows With And Without Free-Stream Turbulence, Sabah Falih Habeeb Alhamdi
Intermittency Effects On The Universality Of Local Dissipation Scales In Turbulent Boundary Layer Flows With And Without Free-Stream Turbulence, Sabah Falih Habeeb Alhamdi
Theses and Dissertations--Mechanical Engineering
Measurements of the small-scale dissipation statistics of turbulent boundary layer flows with and without free-stream turbulence are reported for Reτ ≈ 1000 (Reθ ≈ 2000). The scaling of the dissipation scale distribution is examined in these two boundary conditions of external wall-bounded flow.
Results demonstrated that the local large-scale Reynolds number based on the measured longitudinal integral length-scale fails to properly normalize the dissipation scale distribution near the wall in these two free-stream conditions, due to the imperfect characterization of the upper bound of the inertial cascade by the integral length-scale. When a length-scale based on Townsend's …
Pressure-Driven Stabilization Of Capacitive Deionization, Landon S. Caudill
Pressure-Driven Stabilization Of Capacitive Deionization, Landon S. Caudill
Theses and Dissertations--Mechanical Engineering
The effects of system pressure on the performance stability of flow-through capacitive deionization (CDI) cells was investigated. Initial data showed that the highly porous carbon electrodes possessed air/oxygen in the micropores, and the increased system pressure boosts the gases solubility in saline solution and carries them out of the cell in the effluent. Upon applying a potential difference to the electrodes, capacitive-based ion adsorption occurs in competition with faradaic reactions that consume oxygen. Through the addition of backpressure, the rate of degradation decreases, allowing the cell to maintain its salt adsorption capacity (SAC) longer. The removal of oxygen from the …
Characterization Of Rotary Bell Atomizers Through Image Analysis Techniques, Jacob E. Wilson
Characterization Of Rotary Bell Atomizers Through Image Analysis Techniques, Jacob E. Wilson
Theses and Dissertations--Mechanical Engineering
Three methods were developed to better understand and characterize the near-field dynamic processes of rotary bell atomization. The methods were developed with the goal of possible integration into industry to identify equipment changes through changes in the primary atomization of the bell. The first technique utilized high-speed imaging to capture qualitative ligament breakup and, in combination with a developed image processing technique and PIV software, was able to gain statistical size and velocity information about both ligaments and droplets in the image data. A second technique, using an Nd:YAG laser with an optical filter, was used to capture size statistics …
Diffusion-Mediated Deposition Of Proteins, Ruiqian Zhan
Diffusion-Mediated Deposition Of Proteins, Ruiqian Zhan
Theses and Dissertations--Mechanical Engineering
Gradients of proteins play a prominent role in many biological processes, from development of multicellular organisms to chemical signaling in the immune system. Deposition of surface gradients is a way to permanently modifying a surface’s properties, resulting in the creation of novel materials which have widespread applications in biologically relevant fields, such as directed cell growth, production of biocompatible implantable materials, and creation of functional biosensors. These types of surfaces can also be used as an ex vivo tool to help understand many biological processes by mimicking the environment in gradient-related phenomena in a controllable way. However, despite the large …
Modeling Of Spallation Phenomenon In An Arc-Jet Environment, Raghava Sai Chaitanya Davuluri
Modeling Of Spallation Phenomenon In An Arc-Jet Environment, Raghava Sai Chaitanya Davuluri
Theses and Dissertations--Mechanical Engineering
Space vehicles, while entering the planetary atmosphere, experience high loads of heat. Ablative materials are commonly used for a thermal protection system, which undergo mass removal mechanisms to counter the heat rates. Spallation is one of the ablative processes, which is characterized by the ejection of solid particles from the material into the flow. Numerical codes that are used in designing the heat shields ignore this phenomenon. Hence, to evaluate the effectiveness of spallation phenomenon, a numerical model is developed to compute the dynamics and chemistry of the particles. The code is one-way coupled to a CFD code that models …