Biomedical Engineering and Bioengineering Commons^™

Characterizing Locomotor Disturbance Perception In Young Adults, Daniel James Liss

Graduate Theses, Dissertations, and Problem Reports

Falls during walking are a leading cause of injuries across aging. Many of these falls are due to slips and trips. The ability to perceive disturbances to ongoing motion may play an important role in the control of walking balance. However, disturbance perception has been investigated in standing balance, but its role in walking balance due to slip- and trip-like disturbances remains largely unknown. Characterizing locomotor disturbance perception in young adults may lead to a more comprehensive understanding of sensorimotor walking balance control.

This work defined locomotor disturbance perception in response to slip and trip-like disturbances in young adults. We …

Effects Of Seat And Axle Position On Pain, Pathology, And Independence In Pediatric Manual Wheelchair Users With Spinal Cord Injury, Hannah Frank

Theses and Dissertations

Manual wheelchair (MWC) users with spinal cord injury (SCI) rely heavily on their upperextremities to complete daily occupations. Due to repetitive shoulder use during wheelchair mobility and propulsion, MWC users are at greater risk of shoulder pain and shoulder pathology, and thus decreased independence, and lower quality of life. The relative fit of the wheelchair and its parameters are critical and can further impact the user’s propulsion biomechanics. Parameters such as seat angle and axle position may put the user in detrimental shoulder positions for longer periods of time, impacting health outcomes even more. Although the effects of wheelchair setup …

Atv Dynamics And Pediatric Rider Safety, James T. Auxier Ii

Theses and Dissertations--Biomedical Engineering

It has been observed through numerous academic and governmental agency studies that pediatric all-terrain vehicle ridership carries significant risk of injury and death. While no doubt valuable to safety, the post-hoc approach employed in these studies does little to explain the why and how behind the risk factors. Furthermore, there has been no prolonged, widespread, organized, and concerted effort to reconstruct and catalog the details and causes of the large (20,000+) number of ATV-related injuries that occur each year as has been done for road-based motor vehicle accidents. This dissertation takes the opposite approach from a meta-analysis and instead examines …

Improved Orthopaedic Repairs Through Mechanically Optimized, Adhesive Biomaterials, Stephen Wheeler Linderman

McKelvey School of Engineering Theses & Dissertations

Despite countless surgical advances over the last several decades refining surgical approaches, repair techniques, and tools to treat tendon and tendon-to-bone injuries, we are still left with repair solutions that rely on fairly crude underlying mechanical principles. Musculoskeletal soft tissues have evolved to transfer high loads by optimizing stress distribution profiles across the tissue at each length scale. However, instead of mimicking these natural load transfer mechanisms, conventional suture approaches are limited by high load transfer across only a small number of anchor points within tissue. This leads to stress concentrations at anchor points that often cause repair failure as …

Kinematics During Knee Extension, Lunge, And Chair Rise, Center For Orthopaedic Biomechanics, Kevin Shelburne, Phd, Michael D. Harris, Phd, Vasiliki Kefala, Donald R. Hume, Bradley S. Davidson, A. J. Cyr, R. H. Kim, A. A. Ali, E. M. Mannen

Living Kinematics of the Knee

No abstract provided.

Predictive Modeling Of Hip Dislocation: Assessment Of Surgical And Patient Factors To Reduce The Occurrence Of Hip Instability And Adverse Clinical Outcomes, Daniel N. Huff

Electronic Theses and Dissertations

Instability and dislocation remain leading indications for revision of primary Total Hip Arthroplasty (THA). Many studies have addressed the links between implant design and propensity for dislocation, however a comprehensive review of the ability of modern THA constructs to protect against joint instability is needed.

Accordingly, the objective of this study is to provide objective data about THA risks to be considered in the treatment algorithm to protect against adverse joint loading conditions and joint instability. Adverse loading conditions were assessed in a population of activities of daily living using data from telemetric hip implant representation in an FE simulation …

Characterizing Anisotropy In Fibrous Soft Materials By Mr Elastography Of Slow And Fast Shear Waves, John Larson Schmidt

McKelvey School of Engineering Theses & Dissertations

The general objective of this work was to develop experimental methods based on magnetic resonance elastography (MRE) to characterize fibrous soft materials. Mathematical models of tissue biomechanics capable of predicting injury, such as traumatic brain injury (TBI), are of great interest and potential. However, the accuracy of predictions from such models depends on accuracy of the underlying material parameters. This dissertation describes work toward three aims. First, experimental methods were designed to characterize fibrous materials based on a transversely isotropic material model. Second, these methods are applied to characterize the anisotropic properties of white matter brain tissue ex vivo. Third, …

Rehabilitating Asymmetric Gait Using Asymmetry, Tyagi Ramakrishnan

USF Tampa Graduate Theses and Dissertations

Human gait is a complex process that involves the coordination of the central nervous and muscular systems. A disruption to the either system results in the impairment of a person’s ability to walk. Impairments can be caused by neurological disorders such as stroke and physical conditions like amputation. There is not a standardized method to quantitatively assess the gait asymmetry of affected subjects. The purpose of this research is to understand the fundamental aspects of asymmetrical effects on the human body and improve rehabilitation techniques and devices. This research takes an interdisciplinary approach to address the limitations with current rehabilitation …

The Development Of A Platform Interface With The Use Of Virtual Reality To Enhance Upper-Extremity Prosthetic Training And Rehabilitation, Ashley D. Knight

USF Tampa Graduate Theses and Dissertations

This dissertation focuses on the investigation and development of an effective prosthetic training and rehabilitation platform with the use of virtual reality to facilitate an effective process to return amputees to the highest level of independence and functioning possible.

It has been reported that approximately 10 million people live with a limb loss worldwide, with around 30% being an upper-extremity amputee. The sudden loss of a hand or arm causes the loss of fine, coordinated movements, reduced joint range of motion (ROM), proprioceptive feedback and aesthetic appearance, all which can be improved with the use of a prosthesis and proper …

Wheelchair Fatigue Reducer, Aaron Miller, Dennis Andre Norfleet

Chancellor’s Honors Program Projects

No abstract provided.

Markerless Radiostereogammetry Of The Shoulder Joint In Humans: Comparisons Of Scapulohumeral Kinematics Between Individuals With Healthy And Supraspinatus-Impaired Shoulders, Ashley N. Hannon

Electronic Thesis and Dissertation Repository

The purpose of this collection of studies was to further develop the knowledge of shoulder motion in order to better understand joint function through direct measurement of 3D scapulohumeral joint kinematics using a technique of high accuracy. Markerless, bi-planar fluoroscopic radiostereometric analysis using a generic shoulder model was developed in this thesis, reducing the amount of radiation exposure to subjects. The studies compared kinematic data of the scapulohumeral joint in six degrees of freedom with a precise, in-vivo measuring technique. Data were collected on young and older healthy individuals, individuals with a torn supraspinatus and post-surgical intervention.

Although this generic …

Biomechanical Investigation Of Elite Place-Kicking, Chase M. Pfeifer

Department of Mechanical and Materials Engineering: Dissertations, Theses, and Student Research

Many studies aim to understand the fundamentals of kicking commonly displayed by soccer players [4,6,10,16,17,18,24,25,28,29,30,34,36,38,40]. Of those studies, most are limited to a two-dimensional (2D) analysis using high-speed cameras for position tracking or utilizing electromyography to observe the activity of select muscles [4,6,18,25,29,36]. The few studies that investigate kicking using a three-dimensional (3D) model are limited in their position tracking capabilities and focus mainly on joint flexion potentials and foot speed.

This dissertation is a comprehensive biomechanical analysis (kinematic and EMG) of the field-goal place-kicking techniques of four elite kickers in American football. Data were compared and contrasted with ball …

Role Of Sensation In Altered Phalanx Grip Force In Persons With Stroke, Leah R. Enders

Theses and Dissertations

Many individuals experience hand impairment after stroke leading to decreased ability to perform daily living activities. Previous research studies have investigated how stroke survivors' pinch grip control differs from healthy individuals, even though many individuals can only grasp with power grip after stroke. Furthermore, many stroke survivors experience tactile sensory deficit in their paretic limb in addition to motor deficit. It is currently unknown how stroke induced tactile sensory deficit affects power grip force directional control, which is important in terms of preventing object slippage and power grip normal force generation. Additionally it is unknown if power grip could be …

Skeletal Muscle Contraction Simulation: A Comparison In Modeling, Jonathan M. Ford

USF Tampa Graduate Theses and Dissertations

Computer generated three-dimensional (3-D) models are being used at increasing rates in the fields of entertainment, education, research, and engineering. One of the aspects of interest includes the behavior and function of the musculoskeletal system. One such tool used by engineers is the finite element method (FEM) to simulate the physics behind muscle mechanics. There are several ways to represent 3-D muscle geometry, namely a bulk, a central line of action and a spline model. The purpose of this study is to exmine how these three representations affect the overall outcome of muscle movement. This is examined in a series …

Evaluation Of Transfer Technologies To Preserve Shoulder Function In Sci, Karen Michelle Mann

USF Tampa Graduate Theses and Dissertations

This study investigated a series of independent unassisted and device-assisted transfers from a wheelchair to vehicle mock-up and vice versa while simultaneously capturing kinematic, kinetic and electromyographic (EMG) data of impaired volunteers. The study provides a venue for observation and evaluation of upper extremity (UE) joint stresses, muscular force and functional demands associated with transfers in persons with spinal cord injury (SCI) to ultimately prevent UE injury, minimize excessive stress, preserve functionality and limit pain. If people with SCI lose function of their UEs, due to pain and/or degeneration, they must then rely on others for everyday tasks.

Five paraplegic …