Biomedical Engineering and Bioengineering Commons^™

Laminar Flow In Mini-Fluidics Channels Assembly And Its Application In Zebra Fish Embryo Research, Radek Glaser

Radek Glaser

A Mini-Fluidics system was designed to facilitate the muscle growth of the Zebra Fish embryos. This experimental device is made of peristaltic pump, inflow/outflow manifolds, fluid storage tank, series of valves and flexible pipes and the main plate with six mini channels. These closed channels provide pathways for an extremely laminar flow. The Zebra Fish embryos are placed in the channels and exposed to the forces present in the fluid.

Mems Capacitive Strain Sensing Elements For Integrated Total Knee Arthroplasty Prosthesis Monitoring, Boyd Mccutchen Evans Iii

Doctoral Dissertations

Measuring the in vivo load state of Total Knee Arthroplasty (TKA) components is required to understand the structural environment and wear characteristics of the devices. The ability to acquire this information gives tremendous insight into the mechanics of the joint replacement prosthesis. Data corresponding to normal loads, in-plane loads, shear loads, load center, contact area, and the rate of loading is needed to fully understand the kinematics and kinetics of the orthopedic implant. In this research, a novel sensing system has been developed which is capable of fully characterizing three-dimensional strain and stress at a single location.

Capacitance-based sensors were …

Phase Transformations Of Calcium Phosphates Formed In Wet Field Environments, O. M. Clarkin, Mark R. Towler, G. M. Insley, M. E. Murphy

Chemical and Biochemical Engineering Faculty Research & Creative Works

The crystal phase and morphology of calcium phosphate salts precipitated in a wet field environment at temperatures between 30 and 70 °C and pHs between 3 and 8 were examined. Dicalcium Phosphate Dihydrate (DCPD) was the most prevalent phase precipitated. Using accelerated ageing study techniques, precipitates studied were aged, under dry conditions at 50 °C for 8 and 16 days, before being re-examined using XRD, FTIR and SEM techniques. DCPD was found to be most stable when precipitated at 40 °C and 5 pH. Considerably more phase transformation to Octacalcium Phosphate (OCP), Amorphous Calcium Phosphate (ACP) and Hydroxyapatite (HA) was …

Design And Evaluation Of A Non-Intrusive Corn Population Sensor, Haizhou Li

Doctoral Dissertations

Specific objectives of this study were to develop, prototype, and test a corn population sensor. Both intrusive mechanical and non-intrusive capacitive techniques have been used to develop the stalk population sensors in previous research. However, neither could generate consistent performance. The mechanical method required high maintenance and resulted in significant underestimations of stalk counts. The performance of capacitive systems was limited by inadequate sensing distance, especially at low stalk moisture levels.

In this research, the sensitivity of the capacitive sensor was optimized for corn stalks. This system utilized a single-sided capacitive sensor, Wien bridge oscillator, phase-locked loop, and an operational …

Influence Of Two Changes In The Composition Of An Acrylic Bone Cement On Its Handling, Thermal, Physical, And Mechanical Properties, G. Lewis, J. Xu, S. Madigan, Mark R. Towler

Chemical and Biochemical Engineering Faculty Research & Creative Works

This study is a contribution to the growing body of work on the influence of changes in the composition of an acrylic bone cement on various properties of the curing and cured material. The focus is on one commercially-available acrylic bone cement brand, Surgical Simplex®P, and three variants of it and a series of properties, namely, setting time, maximum exotherm temperature, activation energy and frequency factor for the polymerization reaction, diffusion coefficient for the uptake of phosphate buffered saline, at 37°C, ultimate compressive strength (UCS), plane-strain fracture toughness, fatigue life (under fully-reversed tension-compression stress), hardness (H) and elastic modulus (both …

Influence Of Acid Washing On The Surface Morphology Of Ionomer Glasses And Handling Properties Of Glass Ionomer Cements, C. M. Crowley, J. Doyle, Mark R. Towler, N. Rushe, S. Hampshire

Chemical and Biochemical Engineering Faculty Research & Creative Works

Acid washing is known to influence the handling properties of ionomer glasses used in glass ionomer cements due to the production of an ion depleted zone on the surface of the glass particles. The influence of acid washing on the particle size distribution and surface area of four glasses was examined by scanning electron microscopy (SEM), particle size analysis (PSA) and accelerated surface area porosimetry (ASAP) and the working and setting times of cements, produced from the glasses, correlated to changes in surface morphology. A linear relationship was found between the specific surface area of acid-washed SiO₂-Al_{2 …}

Preliminary Work On The Development Of A Novel Detection Method For Osteoporosis, P. Moran, Mark R. Towler, S. Chowdhury, J. Saunders, M. J. German, N. S. Lawson, H. M. Pollock, I. Pillay, D. Lyons

Chemical and Biochemical Engineering Faculty Research & Creative Works

Osteoporosis affects both the organic and mineral phases of bone resulting in a decrease in resistance to fracture. Dual x-ray absorptiometry (DEXA) scans are used for diagnosing osteoporosis, which is conventionally characterized by a decrease in mineral density. Unfortunately, some patients who suffer osteoporotic fractures have normal bone density, because both the organic and the mineral phase are affected. However, there are currently no methods of evaluating the health of the organic phase. Patients undergoing treatment for osteoporosis have reported hardening of their fingernails. As the properties of nail and bone may be linked in a comparable, measurable way, this …

Raman Spectroscopy Of The Human Nail: A Potential Tool For Evaluating Bone Health?, Mark R. Towler, A. Wren, N. Rushe, J. Saunders, N. M. Cummins, P. M. Jakeman

Chemical and Biochemical Engineering Faculty Research & Creative Works

Dual X-ray absorptiometry (DEXA) is the current gold standard for the diagnosis of osteoporosis. However, patients can suffer osteoporotic fractures despite normal bone mineral density, partly because of unmeasured influences of both the protein and mineral phases of bone that are affected in osteoporosis. There is currently no clinically applicable method of evaluating the health of the protein phase. The proteins in human nail (keratin) and bone (collagen) require sulphation and disulphide bond (S-S) formation for structural integrity and disorders of either sulphur metabolism or cystathione beta-synthase can lead to structural abnormalities in these tissues. Raman protein spectra provide a …

Diseño Y Simulación De Un Sistema Controlado De Amortiguación Para La Rodilla De La Prótesis Transfemoral, Luis Alejandro García Chavez, Sahit Andrei Vargas Duque

Ingeniería en Automatización

No abstract provided.

Orthogonal Linear Regression In Roentgen Stereophotogrammetry, Patrick Atkinson, Jesse V. Benny, Brian J. Mccartin

Mechanical Engineering Publications

Rooted in aerial reconnaissance, mathematical photogrammetry has evolved into a mainstay of biomedical image processing. The present paper develops an algorithm for Roentgen stereophotogrammetry, a method of imaging musculoskeletal systems both static and dynamic, which incorporates a number of novel features employing techniques from projective geometry, orthogonal regression and least squares approximation. Theoretical and numerical evidence is presented of the efficacy of the proposed procedure.