Automotive Engineering Commons^™

Design, Fabrication And Analysis Of An Auxiliary Power Unit On A Heavy-Duty Truck To Power The Hvac Systems Of The Truck During Driver Off-Duty Conditions, Rohan Milind Kalurkar

Dissertations, Master's Theses and Master's Reports

Currently, one of the biggest challenges the world is facing is energy insufficiency. One of the contributors to energy consumption in United States are the idling semi-trailer trucks. In May 2001, President Bush issued The National Energy Policy in which he directed The Environmental Protection Agency (EPA) and Department of Transportation (DOT) to reduce the idling of trucks. This was done in order to reduce energy consumption by lowering fuel consumption and emissions coming out of semi-trailer trucks in the United States of America.

This project deals with the efforts of installing an Auxiliary Power Unit (APU) as a device …

Experimental Study, Modelling And Controller Design For An Rcci Engine, Naga Nithin Teja Kondipati

Dissertations, Master's Theses and Master's Reports

Low Temperature Combustion (LTC) has got widespread attention over the past two decades in the field of Automotive Research and Development due to it’s potential for achieving higher efficiencies with near-zero engine out NOx and soot emissions. Among all the LTC strategies Reactivity controlled compression ignition (RCCI) has shown the most promising results due to it’s precise control over combustion phasing and heat release rate. However, RCCI being a dual-fuel stratified combustion, precise control over the injection timing of direct injected fuel and in-cylinder fuel reactivity of the mixture needs to be controlled effectively in order to achieve gross indicated …