Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Aerospace Engineering
Mechanical Properties And Tension-Tension Fatigue Behavior Of A Novel Additively Manufactured Polymer Matrix Composite At Room And Elevated Temperature, Grayson M. Harber
Mechanical Properties And Tension-Tension Fatigue Behavior Of A Novel Additively Manufactured Polymer Matrix Composite At Room And Elevated Temperature, Grayson M. Harber
Theses and Dissertations
The tension-tension fatigue behavior of a novel additively manufactured AM carbon fiber reinforced polymer matrix composite was studied. This novel material system consists of T1100 carbon fibers, and a UV photocured resin developed by Continuous Composites and Sartomer. Tensile properties and tension-tension fatigue were investigated for the 090 fiber orientation as well as for the ±45 fiber orientation. Specimens with 0/90 fiber orientation were tested at ambient laboratory temperature 23 °C and at elevated temperature 150 °C, while the specimens with the ±45 fiber orientation were tested only at ambient laboratory temperature. Tension-tension fatigue testing was carried out with a …
Manufacturing Of A Ceramic Turbine Rotor For A Compact Jet Engine, Bryan T. Leicht
Manufacturing Of A Ceramic Turbine Rotor For A Compact Jet Engine, Bryan T. Leicht
Theses and Dissertations
The primary goal of this study was to develop a low-cost, timely, scalable manufacturing method that produced a ceramic turbine that can be tested as a drop-in replacement on a JetCat P400 small scale gas turbine engine. This research compared two processes for manufacturing a ceramic turbine utilizing a pour casting method and 3D printing using stereolithography ceramic manufacturing (SLCM). The pour casting method used Silicon Nitride to create a cast turbine using a sacrificial 3D printed mold. The SLCM method evaluated producing an alumina turbine using an ADMATEC Admaflex 300 SLCM printer to directly print a ceramic turbine. This …
Thermal Considerations For Film Cooling Materials With Anisotropic Thermal Conductivity, Carol E. Bryant
Thermal Considerations For Film Cooling Materials With Anisotropic Thermal Conductivity, Carol E. Bryant
Theses and Dissertations
Higher performance requirements and reduced core sizes are driving increases in turbine inlet temperature in gas turbine engines, surpassing the melting point of advanced materials. Newer materials, such as composites, are being introduced into the hot sections of gas turbine engines. Components in the hot section use film cooling to prevent melting. One unique aspect of some high-temperature composites is they have a bulk anisotropic thermal conductivity, therefore heat flow differs relative to traditional metallic components. Film cooling designs can be revolutionized by leveraging anisotropy in high-temperature materials. The purpose of this research is to examine thermal considerations for using …