Engineering Commons^™

Barker Bird Animatronic Senior Project Report, Marcus Monroe, Nolan Clapp, Ishan Jandaur, Jonathan Ogden

Mechanical Engineering

This document describes how our F71 Senior Design Project team developed a 3D printed, electronic bird that mimics Disneyland’s first animatronic, the Barker Bird. An animatronic is a mechanical puppet that replicates real life movement with robotic parts. Disney’s Barker Bird is a well-known animatronic that replicates a talking macaw with multiple moving systems. The final prototype completed by our team serves as a teaching tool for CAPED (Cal Poly Amusement Park Engineers and Designers) club members that are interested in the field of animated robots.

3d Printed Architected Materials For Improving Biofilm Carriers For Wastewater Treatment Applications, Bryan Ovelheiro

Environmental & Water Resources Engineering Masters Projects

Wastewater infrastructure in the United States has been in dire need of improvement for quite a while. It was estimated that wastewater treatment systems would need about $57.2 billion to maintain acceptable levels of treatment in the coming years (Christen, 2003). This is just for maintaining the treatment systems in place, without any room for improvement, and it only accounts for about 31.6% of the total waster infrastructure need in this area (Christen, 2003). In fact, without sufficient upgrades, water quality gains achieved through the passing of the Clean Water and Safe Drinking Water acts could be lost (Christen, 2003). …

Optimization Of Prosthetic Hands: Utilizing Modularity To Improve Grip Force, Grasp, And Versatility, Jordan William Harris

UNLV Theses, Dissertations, Professional Papers, and Capstones

It has been demonstrated that although many varieties of upper limb prosthetics exist, commercially available prosthetics are outdated and unsatisfactory. Ineffectiveness and limitations have led to some prosthesis wearers having to own multiple devices, whereas others have given up on them entirely. Even though ample research has been conducted to design and test new hand designs, the industry appears to rest in an overall stagnated state.

It was proposed here, that one problem with prosthetic research is an excess of variables involved in testing, and therefore the improper application of the scientific method. It seems that each time a research …

Wing Deflection Analysis Of 3d Printed Wind Tunnel Models, Matthew G. Paul

Master's Theses

This work investigates the feasibility of producing small scale, low aerodynamic loading wind tunnel models, using FDM 3D printing methods, that are both structurally and aerodynamically representative in the wind tunnel. To verify the applicability of this approach, a 2.07% scale model of the NASA CRM was produced, whose wings were manufacturing using a Finite Deposition Modeling 3D printer. Experimental data was compared to numerical simulations to determine percent difference in wake distribution and wingtip deflection for multiple configurations.

Numerical simulation data taken in the form of CFD and FEA was used to validate data taken in the wind tunnel …

Characterization Of Performance Of A 3d Printed Stirling Engine Through Analysis And Test, Julie Vodhanel

ETD Archive

This thesis involves the fusion of two technologies, Stirling engines and additive
manufacturing. The project began by building a Stirling engine primarily out of 3D printed parts. Methods to measure the power output were designed and built with a combination of 3D printed and off the shelf parts. The Stirling engine was tested to see if there was a correlation to analysis results, and a regenerator was installed to determine the effect on performance for this relatively low temperature engine. Finally, variations in test operation and the use of heat sinks were used to find a combination that will allow …