Engineering Commons^™

Dual Graphene Patch Antenna For Ka Band Satellite Applications, Mohammed Amin Rabah, Mohammed Bekhti

International Journal of Aviation, Aeronautics, and Aerospace

Currently; grapheme offers a new opportunity to use in space technology and this is due to its amazing properties like conductivity, strength, flexibility and transparency which allows us to exploit new generation of ultra-fast nanoscale components; Since future wireless communication techniques are geared towards the use of the high frequency spectrum and many recent research prove this trend. This letter presents a proposal for design of a dual graphene-based antenna to use in new communication techniques in Ka band, where the proposed antenna can work for uplink and dowlink frequencies at same time since it has return loss less then …

A Comparative Aerodynamic Study Of Nonplanar Wings, Mondher Yahyaoui

International Journal of Aviation, Aeronautics, and Aerospace

In this work four nonplanar wing configurations were studied using the vortex-lattice method: the wing-winglet, the C-wing, the biplane, and the box wing. It has been shown that linear twist, which is more practical in aeronautical construction, is more than adequate to achieve the higher values of span efficiency factor obtained by a completely optimized twist distribution along the span camber, the latter being in general highly varying and thus not very practical. It has also been shown that moderate sweep can slightly increase the span efficiency factor and further reduce vortex drag. The increase is more important for the …

Comparison Of Flow Field In The Proximity Of A Single Planar & Wrap-Around Fin, Nayhel Sharma, Palak Saini, Hrishabh Chaudhary, Gurteg Nagi, Rakesh Kumar Dr.

International Journal of Aviation, Aeronautics, and Aerospace

Abstract

This paper analyses the results of the computational analysis between a single planar and a wrap-around fin mounted on a semi-cylindrical body. A free-stream Computational Fluid Dynamics (CFD) model was simulated for both cases in the Mach 0.4-3.0M range at 0°Angle of attack, in which, the behavior of flow around the fin was investigated using a turbulence model of higher order discretization. The post-processing shows all the possible views of the flow dynamics around the fins, as well as the missile body. The aerodynamic drag and the rolling moment characteristics of the planar and the wrap-around fin have been …

Aviation Automation And Cns/Atm-Related Human-Technology Interface: Atsep Competency Considerations, Adeyinka Olumuyiwa Osunwusi

International Journal of Aviation, Aeronautics, and Aerospace

Abstract

The aviation industry has, no doubt, undergone profound transformations ever since the first powered aircraft flight on December 17, 1903. An especially noticeable aspect of the transformations is in the area of automation. Remarkably, aviation operations are becoming increasingly automated and it is expected that the wind of change sweeping through the industry will be getting stormier as new technologies emerge especially within the context of the emerging prospects of intelligent technologies, which may ultimately enthrone complete automated or technology-based intelligent decision making. Perhaps, in no sphere of the aviation system has there been, in recent times, a much …

Determination Of Aerodynamic Forces And Control Requirement During Ground Effect, Ambuj Srivastava

International Journal of Aviation, Aeronautics, and Aerospace

The current work delivers the effect of ground proximity on longitudinal aerodynamic forces and the elevator deflection required for trimming the aircraft. The academic understanding states that the with the increasing proximity to the ground,downwash progressively reduces.The methodology adopts the approximation of linear decrement for the estimation of the residual downwash at any height above ground within the unit wingspan. The proposed method utilizes non-dimensional height above ground for the approximation of effective downwash angle in the presence of ground. The approximately predicted effective downwash angle is subsequently utilized to estimate the effect of ground proximity on longitudinal forces, trim …

A New Model For Lifting Condensation Levels Estimation, Nihad E. Daidzic Ph.D., Sc.D.

International Journal of Aviation, Aeronautics, and Aerospace

Knowledge of and the ability to predict lifting condensation levels (LCL) is important ingredient in weather predictions, cloud formation, planetary albedo and Earth’s energy balance. It is also essential topic in aviation safety and flight operations. In this article, we derive a new model of LCL and compare it to some older commonly-used models. This includes also the recently published Romps’ (2017) model. The new model presented here includes dependence, however weak, of the surface atmospheric pressure and the specific humidity on the LCL height and temperature. Such is not the case with widely used models and expressions by Espy …

Optimization And Analysis Of An Elite Electric Propulsion System, Mehakveer Singh, Kapil Yadav, Satnam Singh, Vikas Chumber, Harikrishna Chavhan

International Journal of Aviation, Aeronautics, and Aerospace

Abstract- Electric propulsion has a promising system to create new possibilities in this technological era as well as control the harmful gaseous emission. This paper put a vision on several parameters of electric propulsion. The engine’s performance is comparable to the current propulsion devices and provides a lightweight solution to the robust technologies’ dependent on chemical energy sources. There are a plethora of factors which is enhanced by electric propulsion such as, overall efficiency, capabilities, and robustness of future air vehicles as well as mainly overcome from exhaust hazards. Electric propulsion systems have the potential of utilizing the electrically-driven propulsion …

Design Guidelines For Supersonic Aircrafts In Civil Aviation, Tridib Banerjee Mr.

International Journal of Aviation, Aeronautics, and Aerospace

There exists no publication currently available to the scholars that address in detail, every aspect of designing a modern supersonic aircraft for civil aviation. This paper aims to resolve that issue. It reviews all the existing work that has been done on the topic so far and builds upon that. It incorporates multiple disciplines and takes into account the closely inter-coupled effects of each component on one-another. It also analyses in detail the various environmental and modern regulatory challenges like sonic boom and means to overcome them. It further addresses the challenges like logistics, cabin crew radiation exposure, and cost …

A Thrust Equation Treats Propellers And Rotors As Aerodynamic Cycles And Calculates Their Thrust Without Resorting To The Blade Element Method, Phillip -. Burgers

International Journal of Aviation, Aeronautics, and Aerospace

The lift generated by a translating wing of known translational speed, lift coefficient and area is calculated by a simple equation. A propeller or rotor generating thrust share the same aerodynamic principles but their different kinematics cause the calculation of their thrust to be laborious. This paper derives a thrust equation from an algebraic expansion of the Prandtl’s dynamic pressure term q_∞by adding the rotational kinetic energy of a propeller or rotor to the existing translational kinetic energy term. This thrust equation can be applied directly to propellers and rotors and assumes these to operate as cycles with …

A Trust In Air Traffic Controllers (T-Atc) Scale, Bradley S. Baugh, Scott R. Winter

International Journal of Aviation, Aeronautics, and Aerospace

Trust is a concept that cannot be easily measured. Further, trust is domain-specific. Trust is a foundational aspect of safe flight operations in the National Airspace System, and while there has been much attention to trust in teams and trust in automation, there appears to be a gap in knowledge of a pilot’s trust in air traffic controllers. The purpose of this study was to develop and validate the Trust in Air Traffic Controllers (T-ATC) scale, a summative scale to measure a pilot’s trust in air traffic controllers. This study followed a three-step methodology. In steps one and two, words …

Fatigue Identification And Management In Flight Training: An Investigation Of Collegiate Aviation Pilots, Flavio A. Coimbra Mendonca Mr, Julius Keller, Chientsung Lu

International Journal of Aviation, Aeronautics, and Aerospace

Objective: The purpose of this study was to evaluate collegiate aviation students’ self-awareness of their fatigue issues; to investigate possible causes of fatigue afflicting collegiate aviation students; and to investigate the collegiate aviation students’ lifestyle and perceptions of personal solutions to fatigue.

Background: Pilot fatigue is a significant safety hazard in aviation operations. Several factors can contribute to fatigue, including inadequate sleep, long work hours, and inadequate nutritional habits. Some factors, such as social and academic activities, could be unique for Title 14 Code of Federal Regulations (CFR) Part 141 collegiate aviation pilots. Previous studies have addressed fatigue in …

Computation Of Eclipse Time For Low-Earth Orbiting Small Satellites, Sumanth R M

International Journal of Aviation, Aeronautics, and Aerospace

This paper addresses a method for computing eclipse and daylight time for satellites in LEO. Continuous health-monitoring of the satellite is required for the success the mission. For this, the satellites are primarily powered by solar energy but during the eclipse time, the satellite’s functioning is affected as it cannot generate power during this period and also, its temperature drops rapidly. To tackle these issues, computing eclipse time for satellites becomes essential so as to plan for sizing its secondary power source for continuous functioning. In this work, eclipse time is being computed and it is shown that eclipse time …

Effect Of Chemical Reactions On The Fluidic Thrust Vectoring Of An Axisymmetric Nozzle, Rachid Chouicha, Mohamed Sellam, Said Bergheul

International Journal of Aviation, Aeronautics, and Aerospace

Abstract:

During the last years, several thrust control systems of aerospace rocket engines have been developed. The fluidic thrust vectoring is one of them; it is simple in design and offers a substantial gain in weight and in performance. Most of studies related to this device were carried out with cold gas. It’s quite legitimate to expect that the thermophysical properties of the gases may affect considerably the flow behavior. Besides, the effects of reacting gases at high temperatures, under their effects all flow parameters like to vary.

This study aims to develop a new methodology that allows studying and …

Aerodynamic Design And Exploration Of A Blended Wing Body Aircraft At Subsonic Speed, Sam Dakka Dr, Oliver Johnson

International Journal of Aviation, Aeronautics, and Aerospace

Blended Wing Body (BWB) is a novel aircraft concept which provides many different aerodynamic benefits over conventional aircrafts design. This research investigated the BWB design, L/D characteristics, surface pressure distribution and span-wise lift distribution of a BWB aircraft at low to medium subsonic speeds. A BWB model was designed, manufactured and tested in a subsonic wind tunnel to validate the CFD simulation. The results gained from the investigation proved that BWB has a L/D improvement of 9.4% than conventional aircrafts and 21% increase at medium subsonic speeds (Mach 0.6) compared to lower subsonic speeds of 25 m/sec. It was found …

Big Five Technologies In Aeronautical Engineering Education: Scoping Review, Ruth Martinez-Lopez

International Journal of Aviation, Aeronautics, and Aerospace

The constant demands that technology creates in aerospace engineering also influence education. The identification of the technologies with practical application in aerospace engineering is of current interest to decision makers in both universities and industry. A social network approach enhances this scoping review of the research literature to identify the main topics using the Big Five technologies in aerospace engineering education. The conceptual structure of the dataset (n=447) was analyzed from different approaches: at macro-level, a comparative of the digital technology identified by cluster analysis with the number of co-words established in 3 and 8 and, a keyword central structure …