Engineering Commons^™

An Analog Cmos Particle Filter, Trevor Watson

Masters Theses

Particle filters are used in a variety of image processing and machine learning applications. Their main use in these applications is to gather information about a system of objects, by using partial or noisy observations collected from sensors. These observations are used to associate points of interest in the observations with objects and maintain this association through a series of observations.

In this paper I will investigate the performance of a particle filter implemented in 130nm analog CMOS hardware. The design goal of the particle filter is low-microwatt power consumption. Using analog hardware, rather than digital ASICs or CPUs I …

Design And Evaluation Of A Sub-1-Volt Read Flash Memory In A Standard 130 Nanometer Cmos Process, David Andrew Basford

Masters Theses

Nonvolatile memory design is a discipline that employs digital and analog circuit design techniques and requires knowledge of semiconductor physics and quantum mechanics. Methods for programming and erasing memory are discussed here, and simulation models are provided for Impact Hot Electron Injection (IHEI), Fowler-Nordheim (FN) tunneling, and direct tunneling. Extensive testing of analog memory cells was used to derive a set of equations that describe the oating-gate characteristics. Measurements of charge retention also revealed several leakage mechanisms, and methods for mitigating leakage are presented.

Fabrication of ash memory in a standard CMOS process presents significant design challenges. The absence of …

Design And Implementation Of A Low‐Power Wireless Respiration Monitoring Sensor, Ifana Mahbub

Doctoral Dissertations

Wireless devices for monitoring of respiration activities can play a major role in advancing modern home-based health care applications. Existing methods for respiration monitoring require special algorithms and high precision filters to eliminate noise and other motion artifacts. These necessitate additional power consuming circuitry for further signal conditioning. This dissertation is particularly focused on a novel approach of respiration monitoring based on a PVDF-based pyroelectric transducer. Low-power, low-noise, and fully integrated charge amplifiers are designed to serve as the front-end amplifier of the sensor to efficiently convert the charge generated by the transducer into a proportional voltage signal. To transmit …

A Sub-Threshold Low-Power Integrated Bandpass Filter For Highly-Integrated Spectrum Analyzers, Benjamin David Roehrs

Masters Theses

Low-power analog filter banks provide frequency analysis with minimal space requirements, making them viable solutions for integrated remote audio- and vibration-sensing applications. In order to achieve a balance between the length of deployable service and system performance, a critical requirement of such remote sensor networks is low-power consumption, due to the constraints imposed by on-board battery cells.

In this work, the design and implementation of a sub-threshold complementary metal-oxide semiconductor (CMOS) integrated low-power tunable analog filter channel for Oak Ridge National Laboratory is presented. Project specifications required a tunable, high-order, monolithic bandpass filter channel with small chip area and low …