Engineering Commons^™

Dynamic Behavior Of A Clamped-Clamped Bi-Stable Laminate For Energy Harvesting, Ajay V. Kumar, Andres F. Arrieta Ph.D., Myungwon Hwang

The Summer Undergraduate Research Fellowship (SURF) Symposium

Multi-stable laminates have many applications in morphing structures, energy harvesting devices, and metamaterials due to the specific characteristics attributed to the exhibited stable states. Changes between stable states allow for large deflections, on-demand variation of the stiffness of compliant structures embedded within these elements, and control of effective dynamic properties in periodic lattices. These changes in state can be accessed via a snap-through instability triggered by introducing a well-defined activation energy. The resulting oscillations could enable broadband energy harvesting via piezoelectric transduction and resistive circuits. In this paper, a clamped-clamped bi-stable laminate is studied to understand the behavior of the …

Strain Energy Absorption Corresponds To Decreased Incidence Of Ventricular Fibrillation In A Commotio Cordis Model, Kayt E. Frisch, Mark S. Link, John Van Weelden

Faculty Work Comprehensive List

A healthy teenage boy is playing high school baseball, when he is struck in the chest by the ball; minutes later, his heart is experiencing ventricular fibrillation (VF) and the only way to resuscitate him is to use a defibrillator. This phenomenon, is known as Commotio Cordis (CC), and occurs as many as 20 times each year in the United States. CC most frequently occurs in sports with small balls (e.g. baseball or lacrosse) and requires a specific set of circumstances–a projectile with a certain amount of energy that impacts directly over the left ventricle of the heart during a …

Parametric And Design Analysis On Thermoelectric Generators, Shouyuan Huang

Open Access Theses

In facing the limited energy source reserves and environmental problems, thermoelectric generators (TEGs) are one of the promising waste heat recovery systems. The modern TEGs for exhaust stream (e.g. from automobiles) can improve the fuel economy by around 5%, taking advantage of the recent developed thermoelectric (TE) materials.

In this work, we aimed at designing a TEG as an add-on module for a gas-phase heat exchanger with maximized power output, and without negative impact (e.g. maintaining a minimum heat dissipation rate from the hot side). We first developed a parametric optimization algorithm using response surface method (RSM) and genetic algorithm …

Second Law Of Thermodynamics Analysis Of An Internal Combustion Engine Fueled With Methane, Muataz Abotabik

Masters Theses

The second law of thermodynamics is a powerful tool for calculating the amount of energy that can be converted to work (i.e., the exergy or availability of a system), which cannot be predicted using the first law. The objectives of this research project are to quantify the availability during the compression, combustion and expansion processes of a spark-ignited engine fueled with methane; and to highlight differences in the thermo-mechanical availability of the ideal and spark-ignition (SI) engine cycles. A cooperative single-cylinder research engine was used to measure the data required for availability analysis at equivalence ratios ranging between 0.83 and …

Go With The Flow –Thermoelectric Energy, Shawn Bell

Middle School Lesson Plans

In this unit, students will learn how thermal energy be transferred and transformed. They will carry out investigations to gather evidence to support an explanation about direct conversion of heat into electrical energy. They will develop a model that shows the components of the system and changes in the system being investigated, and they will use evidence from the investigation to construct an explanation for how the energy flows.

Using The Moment Of Inertia As A Means Of Better Controlling The Speed Of Wind Turbines, Garrett L. Muhlstadt

Honors Program Projects

In the following document, the possibility of using the moment of inertia as a means of speed control for a wind turbine is explored. This document gives an introduction to wind energy and current speed control methods. This information was obtained through databases found at Benner Library. Also, an experiment was used to collect data and determine the relationship between the moment of inertia and angular velocity of a turbine. A model turbine was fabricated and powered by a fan while a Logger Pro program was used to record the angular velocity of the turbine. The moment of inertia of …

Hybrid Diesel-Electric Drivetrain For Small Agricultural Field Machines, Joseph Jackson, Joseph S. Dvorak

Biosystems and Agricultural Engineering Faculty Publications

In this project, a series electric drivetrain sized for small agricultural machinery was developed and tested. Electric drives have noted benefits in simplicity, controllability, integration with other electronics such as those that provide autonomous action, and in efficiency over a wide operating range. Their biggest drawback for agricultural use is the limited capacity of electrical energy storage. A series hybrid drivetrain provides a method to overcome these capacity constraints through the use of chemical energy storage. The series hybrid drivetrain in this research was designed using well-established components. It consisted of a diesel-electric generator, a lead acid battery pack, a …

Cogeneration System Comparison For The Akron Water Treatment Plant, Devin J. Pearcy, Madison R. Morgan

Williams Honors College, Honors Research Projects

Cogeneration is a process of electrical power generation that simultaneously harnesses the heat produced from that electrical generation and uses it to supply heat to a space. The Akron Water Plant was identified as potentially benefitting from this technology for two main reasons. First, they have a large and relatively constant electrical load. Second, they have ownership of a significant amount of natural gas wells at the site.

This report analyzes the economic feasibility of installing a cogeneration plant at the Akron Water Plant (AWP). Data was collected for the plant and its operations, including electricity bills, gas bills, plant …