Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Design, Fabrication, Structural Testing, And Numerical Analysis Of A Small Scale Composite Wing, Jacob David Gaunt, Juan Carlos Flores, Vincent Andrew Perry
Design, Fabrication, Structural Testing, And Numerical Analysis Of A Small Scale Composite Wing, Jacob David Gaunt, Juan Carlos Flores, Vincent Andrew Perry
Aerospace Engineering
A small scale composite wing based on a design found on an experimental aircraft was designed, constructed, and tested dynamically and statically. The wing was constructed similarly to an experimental aircraft wing. The performed static test was intended to produce pure bending. Strain gages were used to measure strains on the wing structure. The strains were converted to stresses to aid in analysis. The static test results suggested that the wing was actually under torsion. Four structural modes were found from the static test. A finite element analysis model was made to compare experimental results to numerical analytical results. The …
Kinetic And Finite Element Modeling For Firing Brick, Daniel Mckinney
Kinetic And Finite Element Modeling For Firing Brick, Daniel Mckinney
All Theses
Kinetic modeling and simulation were used to optimize the firing cycle for brick. This was done to develop a tool for the brick industry to reduce fuel consumption and emissions during firing. A kinetic model was built using shrinkage data from dilatometer measurements and mass loss data from thermogravimetry measurements in order to predict the density as a function of temperature and time. The density of brick was related to the absorption coefficient (C/B), an ASTM standard which is related to the durability of the brick. The kinetic model was used to optimize the firing curve using a rate controlled …