Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Mushy-Zone Rayleigh Number To Describe Macrosegregation And Channel Segregate Formation During Directional Solidification Of Metallic Alloys, Surendra N. Tewari, R. Tiwari, G. Magadi
Mushy-Zone Rayleigh Number To Describe Macrosegregation And Channel Segregate Formation During Directional Solidification Of Metallic Alloys, Surendra N. Tewari, R. Tiwari, G. Magadi
Chemical & Biomedical Engineering Faculty Publications
A recently defined mushy-zone Rayleigh number (R-aM) that includes side-branching contributions to the mushy-zone permeability has been examined for its correlation with the longitudinal macrosegregation and channel segregate formation. The Rayleigh number shows (1) a strong correlation between the extent of longitudinal macrosegregation and increase in the mushy-zone convection and (2) a good ability to predict the formation of channel segregates during directional solidification.
Synchronous Motor Phase Control By Vector Addition Of Induced Winding Voltages, Daniel J. Simon, Dennis L. Feucht
Synchronous Motor Phase Control By Vector Addition Of Induced Winding Voltages, Daniel J. Simon, Dennis L. Feucht
Electrical and Computer Engineering Faculty Publications
We propose a simple low-cost approach to the winding-sensed control of three-phase synchronous permanent-magnet motors. Our approach results from a straightforward but elegant application of vector-based motor theory. The method therefore does not depend on the differential equations that describe the motor dynamics, and it does not depend on the particular motor parameters. The single method we derive applies to both wye- and delta-configured motors. We vectorially sum the voltage waveforms at the motor terminals in a certain way and use their zero crossings to produce a correctly phased six-step switch sequence. We discuss the implementation for both wye- and …
A Comparison Between Growth Morphology Of "Eutectic" Cells/Dendrites And Single-Phase Cells/Dendrites, Surendra N. Tewari, S. V. Raj, L. E. Locci
A Comparison Between Growth Morphology Of "Eutectic" Cells/Dendrites And Single-Phase Cells/Dendrites, Surendra N. Tewari, S. V. Raj, L. E. Locci
Chemical & Biomedical Engineering Faculty Publications
Directionally solidified (DS) intermetallic and ceramicbased eutectic alloys with an in-situ composite microstructure microstructure containing finely distributed, long aspect ratio, fiber, or plate reinforcements are being seriously examined for several advanced aero-propulsion applications. In designing these alloys, additional solutes need to be added to the base eutectic composition in order to improve their high temperature strength, and provide for adequate toughness and resistance to environmental degradation. Solute addition, however, promotes instability at the planar liquid-solid interface resulting in the formation of two-phase eutectic “colonies.”[1–4] Because morphology of eutectic colonies is very similar to the single-phase cells and dendrites, the stability …