Engineering Commons^™

Effects Of Blowing Ratio On Heat Transfer To The Throat Region Of A Porous-Walled Nozzle, Joseph L. Lenertz

Theses and Dissertations

This experiment analyzed the effects of blowing ratio on heat transfer to the throat region of a porous-walled nozzle, using the AFIT low speed shock tube. Heat flux data were taken from both sides of a two-dimensional Mach 2.0 Re-m=5.2x10⁷ nozzle using thin film resistance thermometers. One side was transpiration-cooled by secondary air injection through a sintered wall, while the other side served as a control. Control results were validated using empirical relations, and cooled side results showed up to a 14% reduction in heat transfer coefficient at blowing ratios of only 0.51%. The linear nature of cooling effectiveness …

An Investigation Of The Afit 2-Inch Shock Tube As A Flow Source For Supersonic Testing, Kevin M. Vlcek

Theses and Dissertations

An investigation of the AFIT high pressure shock tube was conducted to determine how closely it followed ideal shock tube theory and to determine the available test times for an attached Mach 3 nozzle. The driver section was five feet (1.52 m) long and the driven section was 25 feet (7.62 m) long. The driver gas used for this study was helium while the driven gas was atmospheric air. The pressure rise measured behind the incident shock wave was, on average, 30% lower than predicted by the ideal shock tube relations. Behind the reflected shock, the pressure rise was 65% …

An Investigation Of The Formation Of Turbulent Water And Abrasive Water Jets, Md. Ekramul Hasan Khan

Dissertations

This study is concerned with the development of a knowledge base for the selection of nozzle geometry by investigating the mechanism of formation and behaviors of water and abrasive water jets. A numerical prediction of turbulent water flow inside various nozzles is developed. The analysis is based on the numerical solution of conservation equations of continuity and momentum as well as equations of turbulent kinetic energy and dissipation for 2-dimensional axisymmetric flow by using a finite element package, FIDAP.

The technique for determining velocities and forces of water jet and abrasive water jet with the Laser Transit Anemometer and Piezoelectric …