Engineering Commons^™

Interplanetary Mission Design With Applications To Guidance And Optimal Control Of Aero-Assisted Trajectories, Peter J. Edelman

Open Access Dissertations

A method for finding optimal aerogravity-assist tours of the solar system is developed using indirect methods. Two cost functionals are used in the optimization; finding the minimum required maximum lift-to-drag ratio, with and without a convective heating-rate path constraint, and the path which provides the minimum total stagnation point convective heat load. It is found that using present or near-future thermal protection system materials will suffice for certain aerogravity assist trajectories at Mars. Minimum heat load optimal trajectories are found for aerocapture maneuvers at Uranus and Neptune. With a large radius, and short rotational periods, atmospheric rotation must be taken …

Gravity-Assist Trajectories To Venus, Mars, And The Ice Giants: Mission Design With Human And Robotic Applications, Kyle M. Hughes

Open Access Dissertations

Gravity-assist trajectories to Uranus and Neptune are found (with the allowance of impulsive maneuvers using chemical propulsion) for launch dates ranging from 2024 to 2038 for Uranus and 2020 to 2070 for Neptune. Solutions are found using a patched conic model with analytical ephemeris via the Satellite Tour Design Program (STOUR), originally developed at the Jet Propulsion Laboratory (JPL). Delivered payload mass is computed for all solutions for select launch vehicles, and attractive solutions are identified as those that deliver a specified amount of payload mass into orbit at the target body in minimum time. The best cases for each …

A New Approach To Modeling Aviation Accidents, Arjun Harsha Rao

Open Access Dissertations

General Aviation (GA) is a catchall term for all aircraft operations in the US that are not categorized as commercial operations or military flights. GA aircraft account for almost 97% of the US civil aviation fleet. Unfortunately, GA flights have a much higher fatal accident rate than commercial operations. Recent estimates by the Federal Aviation Administration (FAA) showed that the GA fatal accident rate has remained relatively unchanged between 2010 and 2015, with 1566 fatal accidents accounting for 2650 fatalities. Several research efforts have been directed towards betters understanding the causes of GA accidents. Many of these efforts use National …

Modeling Methods For Merging Computational And Experimental Aerodynamic Pressure Data, Jacob Courtney Haderlie

Open Access Dissertations

This research describes a process to model surface pressure data sets as a function of wing geometry from computational and wind tunnel sources and then merge them into a single predicted value. The described merging process will enable engineers to integrate these data sets with the goal of utilizing the advantages of each data source while overcoming the limitations of both; this provides a single, combined data set to support analysis and design. The main challenge with this process is accurately representing each data source everywhere on the wing. Additionally, this effort demonstrates methods to model wind tunnel pressure data …

Numerical Investigation Of Crossflow Instability On The Hifire-5, Matthew T. Lakebrink

Open Access Dissertations

Stability analysis was performed with the Langley Stability and Transition Analysis Code (LASTRAC) on a 38.1% scale model of the HIFiRE-5 elliptic-cone forebody to study crossflow-induced transition in hypersonic boundary layers. A resolution study consisting of three grids (30e6, 45e6, and 91e6 points) indicated that the fine grid was sufficiently resolved. Results were largely insensitive to grid resolution over the acreage and near the attachment line. The percent variation in second-mode properties along the semi-minor axis was less than 1% between the medium and fine grids. The variation in crossflow-wave properties was less than 0.04% between the medium and fine …

Development Of Inverse Methods For Reconstruction Of Flight Environments On Ablators, A. Brandon Oliver

Open Access Dissertations

Obtaining measurements of flight environments on ablative heatshields is both critical for spacecraft development and extremely challenging due to the harsh heating environment and surface recession. Thermocouples installed several millimeters below the surface are commonly used to measure the heatshield temperature response, but an ill-posed inverse heat conduction problem must be solved to reconstruct the surface heating environment from the embedded thermocouple measurements. The material properties of typical ablators make the reconstruction process more challenging when the measurements are deep, but measurements often must be located deep to allow for surface recession. Compounding the complexity of the surface reconstruction problem, …

Supporting Space Systems Design Via Systems Dependency Analysis Methodology, Cesare Guariniello

Open Access Dissertations

The increasing size and complexity of space systems and space missions pose severe challenges to space systems engineers. When complex systems and Systems-of-Systems are involved, the behavior of the whole entity is not only due to that of the individual systems involved but also to the interactions and dependencies between the systems. Dependencies can be varied and complex, and designers usually do not perform analysis of the impact of dependencies at the level of complex systems, or this analysis involves excessive computational cost, or occurs at a later stage of the design process, after designers have already set detailed requirements, …

Information Inference For Cyber-Physical Systems With Application To Aviation Safety And Space Situational Awareness, Sangjin Lee

Open Access Dissertations

Due to the rapid advancement of technologies on sensors and processors, engineering systems have become more complex and highly automated to meet ever stringent performance and safety requirements. These systems are usually composed of physical plants (e.g., aircraft, spacecraft, ground vehicles, etc.) and cyber components (e.g., sensing, communication, and computing units), and thus called as Cyber-Physical Systems (CPSs). For safe, efficient, and sustainable operation of a CPS, the states and physical characteristics of the system need to be effectively estimated or inferred from sensing data by proper information inference algorithms. However, due to the complex nature of the interacting multiple-heterogeneous …

Analytical Methods For Gravity-Assist Tour Design, Nathan J. Strange

Open Access Dissertations

This dissertation develops analytical methods for the design of gravity-assist space- craft trajectories. Such trajectories are commonly employed by planetary science missions to reach Mercury or the Outer Planets. They may also be used at the Outer Planets for the design of science tours with multiple flybys of those planets’ moons. Recent work has also shown applicability to new missions concepts such as NASA’s Asteroid Redirect Mission.

This work is based in the theory of patched conics. This document applies rigor to the concept of pumping (i.e. using gravity assists to change orbital energy) and cranking (i.e. using gravity assists …

Implementing And Testing A Panel-Based Method For Modeling Acoustic Scattering From Cfd Input, S. Hales Swift

Open Access Dissertations

Exposure of sailors to high levels of noise in the aircraft carrier deck environment is a problem that has serious human and economic consequences. A variety of approaches to quieting exhausting jets from high-performance aircraft are undergoing development. However, testing of noise abatement solutions at full-scale may be prohibitively costly when many possible nozzle treatments are under consideration. A relatively efficient and accurate means of predicting the noise levels resulting from engine-quieting technologies at personnel locations is needed. This is complicated by the need to model both the direct and the scattered sound field in order to determine the resultant …

An Experimental Investigation Of Self-Excited Combustion Dynamics In A Single Element Lean Direct Injection (Ldi) Combustor, Rohan M. Gejji

Open Access Dissertations

The management of combustion dynamics in gas turbine combustors has become more challenging as strict NOx/CO emission standards have led to engine operation in a narrow, lean regime. While premixed or partially premixed combustor configurations such as the Lean Premixed Pre-vaporized (LPP), Rich Quench Lean burn (RQL), and Lean Direct Injection (LDI) have shown a potential for reduced NOx emissions, they promote a coupling between acoustics, hydrodynamics and combustion that can lead to combustion instabilities. These couplings can be quite complex, and their detailed understanding is a pre-requisite to any engine development program and for the development of predictive capability …

Physical Properties, Evaporation And Combustion Characteristics Of Nanofluid-Type Fuels, Saad Tanvir

Open Access Dissertations

Nanofluids are liquids with stable suspension of nanoparticles. Limited studies in the past have shown that both energetic and catalytic nanoparticles once mixed with traditional liquid fuels can be advantageous in combustion applications, e.g., increased energy density and shortened ignition delay. Contradictions in existing literature, scarcity of experimental data and lack of understanding on how the added nanoparticles affect the physical properties as well as combustion characteristics of the resulting fuel motivated us to launch a detailed experimental and theoretical investigation.

The surface tension of ethanol and n-decane based nanofluid fuels containing suspended nanoparticles were measured using the pendant drop …

Particle Modeling Of Non-Equilibrium Field Emission Driven Rf Microplasmas, Siva Sashank Tholeti

Open Access Dissertations

Non-equilibrium microplasmas at atmospheric pressures have been investigated for active flow control, micropropulsion and electronic display applications to name a few. The operational voltages for these microplasmas are on the order of kilovolts. When the electric field at the electrodes reaches GV/m or tens of GV/m either due to reduced interelectrode spacing and surface irregularities or due to carefully designed nanostructures on the electrodes, quantum processes such as field emission and field ionization come into effect. These can potentially reduce the operational voltages of microplasma devices by an order of magnitude. Due to the rarefied and non-equilibrium nature of these …

A Cross-Sectional And Mixed-Method Assessment Of Safety Culture And Safety Climate At A Regional Airline, Micah S. Walala

Open Access Dissertations

The researcher applied a mixed methods approach to conduct a cross-sectional assessment of the safety culture, safety climate, and SMS at a regional airline in the United States. Data collection techniques were comprised of interview, on-line-survey, and a focus group activity. Participants in the current study were maintenance technicians, flight attendants, dispatchers, pilots, and managers. Results indicated significant differences of perception of safety climate, safety culture, and Safety Management System between the maintenance technicians and flight attendants. The length of time a participant had worked at the subject airline and age of the participant appeared to be significant factors of …

Preliminary Design Tools In Turbomachinery: Non-Uniformly Spaced Blade Rows, Multistage Interaction, Unsteady Radial Waves, And Propeller Horizontal-Axis Turbine Optimization, Yujun Leng

Open Access Dissertations

Turbomachinery flow fields are inherently unsteady and complex which makes the related CFD analyses computationally intensive. Physically based preliminary design tools are desirable for parametric studies early in the design stage, and to provide deep physical insight and a good starting point for the later CFD analyses. Four analytical/semi-analytical models are developed in this study: 1) a generalized flat plate cascade model for investigating the unsteady aerodynamics of a blade row with non-uniformly spaced blades; 2) a multistage interaction model for investigating rotor-stator interactions; 3) an analytical solution for quantifying the impeller wake convection and pressure wave propagating between a …

Incorporation Of Gnss Multipath To Improve Autonomous Rendezvous, Docking And Proximity Operations In Space, Benjamin W. Ashman

Open Access Dissertations

Automated rendezvous and docking (AR&D;) operations are important for many future space missions, such as the resupply of space stations, repair and refueling of large satellites, and active removal of orbital debris. These operations depend critically on accurate, real-time knowledge of the relative position and velocity between two space vehicles. Unfortunately, Global Navigation Satellite System (GNSS) capabilities remain severely limited in close proximity to large space structures due to significant multipath effects and signal blockage. Although GNSS is used for the initial stages of approach, other instruments such as laser, radar and vision-based systems, are required to augment GNSS during …

A Transfer Network Linking Earth, Moon, And The Triangular Libration Point Regions In The Earth-Moon System, Lucia R. Capdevila

Open Access Dissertations

In the near future, several space applications in the Earth-Moon system may require a spacecraft to hold a stable motion, but the transfer trajectory infrastructure to access such stable motions has not been fully investigated yet. The triangular libration points, L 4and L5, in the Earth-Moon system have long been thought of as ideal locations for a communications satellite. Recently, Distant Retrograde Orbits (DROs) and Near-Rectilinear Halo Orbits (NRHOs) near the Moon have been identified as motion of interest for manned and unmanned missions with a focus on operations in cislunar space. The triangular libration points, as well as …

Coupled Orbit-Attitude Mission Design In The Circular Restricted Three-Body Problem, Davide Guzzetti

Open Access Dissertations

Trajectory design increasingly leverages multi-body dynamical structures that are based on an understanding of various types of orbits in the Circular Restricted Three-Body Problem (CR3BP). Given the more complex dynamical environment, mission applications may also benefit from deeper insight into the attitude motion. In this investigation, the attitude dynamics are coupled with the trajectories in the CR3BP. In a highly sensitive dynamical model, such as the orbit-attitude CR3BP, periodic solutions allow delineation of the fundamental dynamical structures. Periodic solutions are also a subset of motions that are bounded over an infinite time-span (assuming no perturbing factors), without the necessity to …

A Study On Flow Development In An Apu-Style Inlet And Its Effect On Centrifugal Compressor Performance, Fangyuan Lou

Open Access Dissertations

The objectives of this research were to investigate the flow development inside an APU-style inlet and its effect on centrifugal compressor performance. The motivation arises from the increased applications of gas turbine engines installed with APU-style inlets such as unmanned aerial vehicles, auxiliary power units, and helicopters. The inlet swirl distortion created from these complicated inlet systems has become a major performance and operability concern. To improve the integration between the APU-style inlet and gas turbine engines, better understanding of the flow field in the APU-style inlet and its effect on gas turbine is necessary.

A research facility for the …