Engineering Commons^™

Cfd Analysis For Beyond Bubbly Gas-Liquid Two-Phase Flows In A Large Diameter Pipe, Sungje Hong

Doctoral Dissertations

"Due to the complexity of multiphase flow phenomena, numerical analysis for multiphase turbulent flow is not as reliable as single-phase computational fluid dynamics (CFD). A literature review has revealed that the current efforts on multiphase flow simulation have focused on small diameter channels under very restricted flow conditions and have been conducted without identifying some important procedures. To expand CFD applications to a wide range of two-phase flow conditions in large diameter channels, this study aims to validate the current CFD models for vertical concurrent air-water two-phase flow simulations beyond bubbly flows. First, a numerical model developed to describe dynamical …

Predictive Capabilities Of Laminar-Turbulent Transition Models For Aerodynamics Applications, Jared Alexander Carnes

Doctoral Dissertations

Laminar-turbulent boundary-layer transition has a demonstrable impact on the performance of aerospace vehicles. The ability to accurately predict transition is integral to properly capturing relevant flow physics. Traditionally, computational fluid dynamics simulations are performed fully turbulent, meaning that laminar flow is neglected. This, however, can result in errant predictions of vehicle performance as quantities such as skin-friction drag may be overpredicted. Resultingly, development of Reynolds-averaged Navier-Stokes transition models has seen significant attention over the last decades in order to model transition and realize the performance improvements of laminar flow.

In this work, the behaviors of several different transition-prediction methods are …

Solidification Experiments And Magnetohydrodynamic Models In Electromagnetic Levitation, Gwendolyn Bracker

Doctoral Dissertations

Electromagnetic levitation (EML) is a technique for containerless processing. The unique environment of containerless processing allows for the study of highly reactive melts at elevated temperatures. In containerless processing, the interface between a melt and its container is removed, reducing chemical contamination. In addition, levitation techniques reduce the available heterogeneous nucleation sites, providing greater access to the undercooled region for solidification studies. Levitation techniques provide the environment to study the fundamental behavior and thermophysical properties of liquid metals. During electromagnetic levitation experiments, magnetohydrodynamic flow is driven in the sample by the electromagnetic force field. This flow can have various effects …

Entropy-Based Analysis For Application To Highly Compressible Flows, Ethan A. Vogel

Doctoral Dissertations

Matrix normalizations are a critical component of mathematically rigorous aerodynamics analysis, especially where kinematic and thermodynamic behaviors are of interest. Here, a matrix normalization based around the entropy of a perturbation is derived according to the principles of mathematical entropy analysis and using a general definition of entropy amendable to physical phenomena such as thermal nonequilibrium and caloric and thermal imperfection. This normalization is shown to be closely related to the contemporary Chu energy normalization, expanding the range of validity of that normalization and clarifying the details of its interpretation. This relationship provides a basis for deriving other normalizations. Entropy …

Development And Validation Of A Cross Correlation Function Based Indirect Flow Measurement Technique, Xiong Gao

Doctoral Dissertations

Nuclear Power Plants (NPPs) require the accurate measurement of mass flow rates. Advanced flow meters have been invented and widely applied in several current industries; however, the operation environment in nuclear power plants is especially harsh due to high temperature, high radiation and extremely corrosive conditions.. Several of the advanced reactor designs, such as liquid sodium pool reactors and integral small modular reactors, do not have conventional primary piping systems. These designs necessitate alternative methods to accurately measure primary flow.

Cross Correlation Function (CCF) flow estimation, which was proposed in the 1980s, can estimate the flow velocity indirectly without any …

Magnetic Control Of Transport Of Particles And Droplets In Low Reynolds Number Shear Flows, Jie Zhang

Doctoral Dissertations

“Magnetic particles and droplets have been used in a wide range applications including biomedicine, biological analysis and chemical reaction. The manipulation of magnetic microparticles or microdroplets in microscale fluid environments is one of the most critical processes in the systems and platforms based on microfluidic technology. The conventional methods are based on magnetic forces to manipulate magnetic particles or droplets in a viscous fluid.

In contrast to conventional magnetic separation method, several recent experimental and theoretical studies have demonstrated a different way to manipulate magnetic non-spherical particles by using a uniform magnetic field in the microchannel. However, the fundamental mechanism …

The Effects Of Low Aspect Ratio And Heat Exchanging Internals On The Bubble Properties And Flow Regime In A Pilot-Plant Bubble/Slurry Bubble Column For Fischer-Tropsch Synthesis, Hayder Al-Naseri

Doctoral Dissertations

"Fischer-Tropsch synthesis (F-T) is a process utilized to convert the syngas mixture of CO and H₂ to synthetic fuel and chemicals that executed commercially by using the bubble/slurry bubble column reactor. The experimental results reveal that the investigated parameters, in terms the presence of internals, and reducing the aspect ratio and the solids loading, increase the local gas holdup, interfacial area, bubble passage frequency, and decrease the bubble rise velocity, bubble chord length. Meanwhile, the aspect ratio H/D = 4, and 5 provide enough height to established the fully developed flow regime. As a result of the variation in …

Turbulent Mixers For Protein Folding Experiments, Venkatesh Inguva

Doctoral Dissertations

Protein folding studies require the development of micro-mixers that require less sample, mix at faster rates, and still provide a high signal to noise ratio. Chaotic to marginally turbulent micro-mixers are promising candidates for this application. In this study, various turbulence and unsteadiness generation concepts are explored that avoid cavitation. The mixing enhancements include flow turning regions, flow splitters, and vortex shedding. The relative effectiveness of these different approaches for rapid micro-mixing is discussed. Simulations found that flow turning regions provided the best mixing profile. Various turbulence models are simulated to determine appropriate model of the design requirements. Experimental validation …

Computational Exploration Of Flash-Boiling Internal Flow And Near-Nozzle Spray, Sampath K. Rachakonda

Doctoral Dissertations

Gasoline engines operating under the principle of direct injection are susceptible to flash-boiling due to superheated nature of the fuel and the sub-atmospheric in-cylinder pressures during injection. A review of the literature on flash-boiling sprays shows that a majority of the studies have focused on the far-field regions of the spray, with limited attention given to understanding the influences of the injector geometry and the near-nozzle regions of the spray. Modeling the internal nozzle flow and the primary atomization, on which the far-field spray depends, is a challenge. This thesis, therefore, is aimed at understanding the complex flow through a …

Hydrodynamics Related Performance Evaluation Of Upflow Moving Bed Hydrotreater Reactor (Mbr) Using Developed Experimental Methods And Cfd Simulation, Vineet Alexander

Doctoral Dissertations

"Upflow Moving Bed Hydrotreater (MBR) reactor is used for hydrotreating resid crude oil. It is a two-phase upflow reactor having a catalyst bed with conical bottom, and plena. At industrial conditions the reactor is not performing at its best and encountering issues such as hot spots, catalyst agglomeration inside the catalyst bed leading to frequent shutdown of the reactor. The root cause of these problems are linked to the improper hydrodynamics inside the catalyst bed. To investigate this, the industrial scale MBR is scaled down to a pilot scale and indicative and key hydrodynamic parameters are investigated using developed experimental …

Reduced Order Fluid-Structure Interaction Models For Thin Shells With Non-Zero Gaussian Curvatures To Understand The Response Of Aneurysms To Flow, Gary Han Chang

Doctoral Dissertations

In this thesis, a reduced-order model is constructed to study the physiological flow and wall shear stress conditions for aneurysms. The method of local proper orthogonal decomposition (POD) is used to construct the reduced-order modes using a series of CFD results, which are subsequently improved using a QR-factorization technique to satisfy the various boundary conditions in physiological flow problems. This method can effectively construct a computationally efficient physiological model, which allows us to examine the fluid velocities and wall shear stress distributions over a range of different physiological flow parameters. Aneurysms are the dilation, bulging, or ballooning-out of part of …

Eulerian Cfd Modeling Of Multiphase Internal Injector Flow And External Sprays, Eli T. Baldwin

Doctoral Dissertations

The improvement of combustion systems which use sprays to atomize liquid fuel requires an understanding of that atomization process. Although the secondary break up mechanisms for the far-field of an atomizing spray have been thoroughly studied and well understood for some time, understanding the internal nozzle flow and primary atomization on which the far-field spray depends has proven to be more of a challenge. Flow through fuel injector nozzles can be highly complex and heavily influenced by factors such as turbulence, needle motion, nozzle imperfections, nozzle asymmetry, and phase change. All of this occurs within metallic injectors, making experimental characterization …

Aeroelastic Analysis Of A Wind Turbine Blade Using The Harmonic Balance Method, Jason Charles Howison

Doctoral Dissertations

Most current wind turbine aeroelastic codes rely on the blade element momentum method with empirical corrections to compute aerodynamic forces on the wind turbine blades. While efficient, this method relies on experimental data and does not allow designers much flexibility for alternative blade designs. Unsteady solutions to the Navier-Stokes equations offer a significant improvement in aerodynamic modeling, but these are currently too computationally expensive to be useful in a design situation. However, steady-state solutions to the Navier-Stokes equations are possible with reasonable computation times. The harmonic balance method provides a way to represent unsteady, periodic flows through coupled a set …

A Computational Study On Extension Of Non-Contact Modulation Calorimetry, Xiao Ye

Doctoral Dissertations

ABSTRACT A COMPUTATIONAL STUDY ON EXTENSION OF NON-CONTACT MODULATION CALORIMETRY May 2015 XIAO YE B.S., SOUTHEAST UNIVERSITY M.S., UNIVERSITY OF MASSACHUSETTS, AMHERST Ph. D., UNIVERSITY OF MASSACHUSETTS, AMHERST Directed by: Professor Robert W. Hyers Accurate thermophysical properties of high temperature metallic liquids are important for both industrial applications and scientific research. For the former, as predictive numerical simulations play an increasingly important role in pivotal industries, such as casting, welding and sintering, the lack of precise thermophysical properties, especially at high temperatures, hamper their further applications. On the other hand, from the stand point of basic metals physics, being able …

Essentially Analytical Theory Closure For Space Filtered Thermal-Incompressible Navier-Stokes Partial Differential Equation System On Bounded Domains, Mikhail Alexandrovich Sekachev

Doctoral Dissertations

Numerical simulation of turbulent flows is identified as one of the grand challenges in high-performance computing. The straight forward approach of solving the Navier-Stokes (NS) equations is termed Direct Numerical Simulation (DNS). In DNS the majority of computational effort is spent on resolving the smallest scales of turbulence, which makes this approach impractical for most industrial applications even on present-day supercomputers. A more feasible approach termed Large Eddy Simulation (LES) has evolved over the last five decades to facilitate turbulent flow predictions for reasonable Reynolds (Re) numbers and domain sizes. LES theory uses the concept of convolution with a spatial …

Liquid Jet Experiments And Simulations For A Verification And Validation Study, Lee Paul Tschaepe

Doctoral Dissertations

The velocity field for two vertical parallel water jets impinging into a large stationary volume of water is mapped using ultrasonic interrogation. Thermal mapping of the vertical parallel water jets at high Reynolds numbers has been performed. The velocity data and associated statistics are related to the measurement volume and the ultrasonic Doppler measurement technique. The data are also compared to the literature for twin jets. The interaction of parallel jets is of interest to liquid metal reactor design. Liquid metal fast reactor (LMFR) coolant enters the bottom of the fuel bundles and exits through the top of the bundles. …