Engineering Commons^™

Grain Boundary Diffusion In Ionic Crystals, Kulwant Singh Sabharwal

Doctoral Dissertations

"The diffusion of ¹³¹I in single crystals and along the tilt grain boundaries of pure and calcium chloride doped (142±5 ppm) bicrystals of sodium chloride, grown by Czochralski technique, was investigated using a microtome sectioning technique. Results on bulk diffusion in pure NaCl agree well with the results of earlier investigators and are represented by the D=(504 cm²/sec)exp (-2.27 ev/kT). Enhanced diffusion of ¹³¹I is observed along the grain boundaries and the presence of the dopant lowers the grain boundary diffusivity over the entire temperature range of 430ºC - 570ºC studied in the present investigation. Thermal activation and electrical polarization …

A Learning Receiver For Communication In Three-Component Multipath Channels, Richard Paul Brueggemann

Doctoral Dissertations

"An adaptive receiver is designed for transmissions through a time-varying multipath channel which may include both specular and diffuse components. The design is based on the theory of unsupervised learning machines and the receiver is a recursive structure which does not grow in complexity with each new observation, but is Bayes' optimal at each instant of time. The multipath medium is modelled as an aggregate of L conditionally independent transmission paths, each consisting of random and/or fixed reflections, and is identified in terms of three components: (1) indirect diffuse scatter, (2) indirect specular reflection, and (3) direct transmission. The channel …

The Effect And Compensation Of Time-Base Perturbations In Analog Recording Systems, Clifford D. Skouby

Doctoral Dissertations

"The mean square error between recorded and reproduced signals is used as an error measure to determine the effects of time-base perturbations on an analog singal. The mean square error caused by time-base perturbations is shown to be proportional to the product of the square of the signal bandwidth and the time-base error variance for the case of low pass signal. When the signal is band pass, there is shown to be an additional error term which is proportional to the square of the signal center frequency and the time-base error variance.

Calculations are also carried out to determine the …

Computer Assisted Teaching Of Steel Design, Wendelin Henry Mueller Iii

Doctoral Dissertations

"A method for use in creating a university level course is presented. The specifics of each of the steps is given in general terms to allow its application to as many different topics as possible. This method is then specifically applied in the formation of a fundamental steel design course using the American Institute of Steel Construction Specification. The reasoning utilized in each phase of development is documented. A lecture style presentation complemented by a series of student oriented computer programs was chosen for use. The details of the course material in outline form is given along with the computer …

Synthesis And Properties Of Cadmium Manganese Ferrites, B. W. Jong

Doctoral Dissertations

"The formation sequence of (Cd,Mn,Fe) (Mn,Fe)₂O₄ from the individual oxides,x CdO + (1-x) MnCO₃ + α-Fe₂O₃,was found by X-Ray diffraction. Cd(Mn,Fe)₂O₄ was formed completely from CdO·Fe₂O₃ and CdO·Fe₂O₄ at 900°C and reacted with MnFe₂O₄ for 0 < x < 0.5 and with α-Fe₂O₃ for 0.5 < x < 1.0 to form a single phase of (Cd,Mn,Fe) (Mn,Fe)₂O₄ at 1150°C. This is the first time that the details involved in the formation sequence of CdMn-ferrite have been shown. A mixture of 0.5 CdO + 0.5 MnCO₃ + α-Fe₂O₃ was calcined at 900°C for 2 hrs forming Cd(Mn,Fe)₂O₄ with no Cd present in the other phases. Sintering was accomplished at 1150°C for 30 minutes forming a single phase of Cd₀.₅Mn₀.₅Fe₂O₄ with a bulk sintered density of 98-99% of the X-Ray density. The rate of changing density followed the relationship, p = K ln t + c, at temperatures between 1050°C and 1300°C. Magnetic properties of CdₓMn₁₋ₓFe₂O₄ were affected by composition x. A relationship, B = gx + h, was found between maximum magnetic flux density B and composition x at room temperature for 0 <̲ x <̲ 0.3. This was rationalized by a modification of Néel's theory. The maximum magnetic flux density decreased with increasing cadmium concentration for 0.3 < x <̲ 0.5. This decrease was attributed to the changing direction of the magnetic moment in the octahedral site sub-lattice according to the superexchange theory. No magnetic properties were observed due to the formation of a compensated antiferromagnetic phase for 0.5 < x <̲ 1.0. Maximum magnetic flux density increased with bulk density, while the coercive force decreased with the grain growth and the initial permeability increased with the bulk density and grain size. A stator core used for a-c electric motor application was formed by pre-sintering at 900⁰C for 2 hrs. Slots were then sawed with a tungsten carbide blade and final sintering was accomplished at 1150⁰C for 1 hr"--Abstract, pages iii-iv.

Hydro-Thermal Generation Unit Commitment And Dispatch Using A Dynamic Programming Approach, Warren Dean Graham

Doctoral Dissertations

"The problem of thermal unit commitment is solved with dynamic programming. A practical example is given which solves the problem for a six generator system over a one year time span. This long range solution is used with a hydro optimization procedure to give an optimized hydro-thermal unit commitment solution. From this, a worth of hydro value is computed for each month, which may be used in the daily dispatching of thermal units and hydro. Applications of the program are also shown for aiding in generator maintenance scheduling and evaluating purchase power contracts with neighboring utilities. Error analysis is made …