Engineering Commons^™

Class F And Inverse Class F Power Amplifier Subject To Electrical Stress Effect, Giji Skaria

Electronic Theses and Dissertations

This study investigated the Class F and inverse Class F RF power amplifier operating at 5.8 GHz. The major challenging issue in design and implementation of CMOS power transistor is the breakdown voltage especially in sub-micron CMOS technologies. In order to eliminate this problem a Cascode topologies were implemented to reduce the Drain-toSource voltage (stress). A Cascode Class F & Inverse Class F RF power amplifier were designed, and optimized in order to improve efficiency and reliability using 0.18µm CMOS technology process. A 50% decrease in the stress has been achieved in the Cascode class-F and Inverse class F amplifiers. …

Cmos Rf Cituits Sic] Variability And Reliability Resilient Design, Modeling, And Simulation, Yidong Liu

Electronic Theses and Dissertations

The work presents a novel voltage biasing design that helps the CMOS RF circuits resilient to variability and reliability. The biasing scheme provides resilience through the threshold voltage (VT) adjustment, and at the mean time it does not degrade the PA performance. Analytical equations are established for sensitivity of the resilient biasing under various scenarios. Power Amplifier (PA) and Low Noise Amplifier (LNA) are investigated case by case through modeling and experiment. PTM 65nm technology is adopted in modeling the transistors within these RF blocks. A traditional class-AB PA with resilient design is compared the same PA without such design …

Design And Simulation Of Cmos Active Mixers, Allen Gibson

Electronic Theses and Dissertations

This paper introduces a component of the Radio Frequency transceiver called the mixer. The mixer is a critical component in the RF systems, because of its ability for frequency conversion. This passage focuses on the design analysis and simulation of multiple topologies for the active down-conversion mixer. This mixer is characterized by its important design properties which consist of conversion gain, linearity, noise figure, and port isolation. The topologies that are given in this passage range from the most commonly known mixer design, to implemented design techniques that are used to increase the mixers important design properties as the demand …

Signal Integrity In Deep Submicron Cmos Chip Design, Jignesh Suresh Sonchhatra

Retrospective Theses and Dissertations

Advancement in CMOS technology has become a driving force in the advancement of today's IC design arena. In the past few years, considerable research has been done on the CMOS devices and circuits. Constant efforts have been made to realize smaller and smaller devices by reducing the channel length of the transistors and scaling down various other device parameters. Consequently, various problems have arisen such as interconnect delay, signal integrity and signal coupling.

The purpose of this thesis is to review and understand current problems in IC design and come up with various solutions to them. Efforts have been made …