Engineering Commons^™

Mil-Std-188-125-1, High-Altitude Emp Protection For Fixed Ground-Based Facilities

George H Baker

MIL-STD-188-125-1 establishes minimum requirements and design objectives for high-altitude electromagnetic pulse (HEMP) hardening of fixed ground-based facilities that perform critical, time-urgent command, control, communications, computer, and intelligence (C4I) missions. The standard prescribes minimum performance requirements for low-risk protection from mission-aborting damage or upset due to HEMP environments. It also addresses minimum testing requirements for demonstrating that prescribed performance has been achieved and for verifying that the installed protection subsystem provides the operationally required hardness for the completed facility. Covered fixed ground-based facility types include subscriber terminals and data processing centers, transmitting and receiving communications stations, and relay facilities. Use of …

Mil-Std-188-125-2, High-Altitude Emp Protection For Transportable Systems

George H Baker

This standard establishes minimum requirements and design objectives for high-altitude electromagnetic pulse (HEMP) hardening of transportable1 ground-based systems that perform critical, time-urgent command, control, communications, computer, and intelligence (C4I) missions. Systems required to fully comply with the provisions of the standard will be designated by the Joint Chiefs of Staff, a Military Department Headquarters, or a Major Command.

The standard prescribes minimum performance requirements for low-risk protection from mission-aborting damage or upset due to HEMP threat environments. The standard also addresses minimum testing requirements for demonstrating that prescribed performance has been achieved and for verifying that the installed protection measures …

A Unified Topological Approach To Electromagnetic Environmental Effects Protection, George H. Baker, J. Philip Castillo, Edward F. Vance

George H Baker

The presentation recommends an approach for unifying electronic system protection designs for a wide spectrum of electromagnetic environments. A general electromagnetic topological construct is developed as the basis for a consistent shielding and terminal protection methodology. Spectral characteristics of multiple interfering electromagnetic sources, both internal and external, are described. Effects addressed include EMI/EMC, lightning, nuclear EMP, and RF weapons. Protection practices for individual effects are discussed and means for integrating these into a single protection topology.

Nuclear Emp Hardening Approach As The Basis For Unified Electromagnetic Environmental Effects Protection, George H. Baker Iii

George H Baker

Operation DESERT STORM demonstrated the clear military advantage that was provided by our sophisticated electronic C4I and weapons systems. High tech means so dominate the battlefield that the outcome of future conflicts could be decided by electronics attrition rather than human casualties. However, the electromagnetic threat landscape is highly complex. The already formidable list of environments (EMI, lighting, ESD, EMP, HERO, TEMPEST, EW, etc.) is lengthened by emerging threats from high power microwave (HPM) and ultra-wide band (UWB) electromagnetic weapons. Many of these environments overlap in the frequency and amplitude of the electrical stresses they create.

The large number of …

Progress In The Development Of Hemp Protection Standards For C3i Facilities, George H. Baker, Clinton R. Gordon

George H Baker

DoD is involved in EMP standards development efforts which culminate 25 years of research. This paper previews an EMP protection standard for fixed, ground-based communication facilities. The standard uses a low-risk hardening approach which depends on an electromagnetic barrier comprised of a conducting shield to prevent harmful transients from reaching communication electronics. The standard is the first of its kind and is being instituted as MIL-STD-188-125.