Engineering Commons^™

Additive Manufacturing Of Engineered Cementitious Composites With Ultra-High Tensile Ductility, Amir Bakhshi

Civil Engineering ETDs

One of the critical factors in the development of additive manufacturing in the construction industry is designing suitable materials for 3D printing applications. 3D concrete printing (3DCP) has gained significant attention due to the abundance and availability of concrete. However, concrete is a brittle material and, without proper reinforcement, cannot meet the requirements for structural purposes. Engineered Cementitious Composites (ECC), known for high ductility, and strain-hardening with low fiber contents, can potentially eliminate the need for steel reinforcement in 3D printing without any need for manual placement of reinforcement. A set of systematic tests on ECC mix designs' fresh and …

Estimating Vehicle Infrastructure: Downtown Albuquerque, New Mexico, Zachery Phillip Baiamonte

Architecture and Planning ETDs

Cities have little knowledge about their parking infrastructure despite clear evidence that abundant parking has environmental, economic, and transportation consequences. The objective of this thesis is to illustrate the need to accurately estimate the area dedicated to vehicle infrastructure (parking lots and streets) within urban areas. I focused on a method that estimated the vehicle infrastructure area within the Downtown Core of Albuquerque, New Mexico, by cross-referencing geospatial cadastral data with minimum parking requirements. Three parking space types were identified: 1) parking in structures; 2) surface parking (parking lots and residential driveways); and 3) on-street parking. To illustrate the need …

The Impact Of Murals On Traffic Safety: A Behavior And Crash Analysis, Maria Cecelia Cruz

Civil Engineering ETDs

ABSTRACT

This research analyzed changes in motor vehicle volumes and motor vehicle speeds after the installation of an intersection mural in Albuquerque, NM and changes in crash frequency after mural installations in Philadelphia, PA. Data was collected manually on site for the Albuquerque study and secondary data – including installation dates and physical characteristics – were used for the Philadelphia crash analyses. Statistics were computed to determine trends in motor vehicle speeds and volumes relative to the Albuquerque mural installation. A geographic information system (GIS) spatial analysis and t-test statistical analyses were used to determine which Philadelphia murals saw significant …

Nighttime Pedestrian Fatalities Across The United States And Their Relationship With Built Environment And Socioeconomic Factors: Gis-Based Analysis And Assessment, Amir Tarighi

Civil Engineering ETDs

Fatalities from motor vehicle collisions are the fifth leading cause of years of lost life worldwide (Foreman et al., 2018) and are a great concern for all communities. This road safety crisis has been especially pronounced for U.S. pedestrians over the last decade. National records show that between 2010 and 2019, pedestrian fatalities in the U.S. increased 44% while all other traffic fatalities increased only 4% and more than fifty percent of pedestrian fatalities occurred in dark lighting conditions. This study analyzed the relationship between pedestrian fatality locations at night and five demographic characteristics of those locations including population density, …

Evaluating Public Transit Accessibility In Albuquerque, New Mexico: A Fixed-Route Bus Service Analysis, Risa E. Gutierrez

Civil Engineering ETDs

This research analyzed how residential accessibility to fixed-route bus service in Albuquerque, New Mexico varies by distance, income level, and headway. A literature review investigated components of travel that might deter people from using public transit such as travel distance, sidewalk condition or availability, bus headway, lack of active travel in today’s society, personal and traffic safety, and access equity. Geographic Information System (GIS) mapping was used to determine if low-income neighborhoods have better or worse access to ABQ Ride bus stops relative to medium- or high-income neighborhoods. Residential land use was divided into three economic classes based on 2018 …

Evaluating Sustainable & Equitable Financing For Pedestrian Infrastructure Maintenance And How The Quality Of Pedestrian Infrastructure Affects The Choice To Walk, Alexis Corning Padilla

Civil Engineering ETDs

In many communities, pedestrian infrastructure is poorly maintained. One challenge is finding sustainable and equitable funding since many municipalities across the country require adjacent property to maintain and repair sidewalks adjacent to their property. These policies are difficult to enforce, may place a high cost on lower-income households, and may be partly responsible for the poor condition of many sidewalks. Therefore, in the first part of this research, we evaluated three alternatives for financing the maintenance of sidewalks in Albuquerque, New Mexico: increasing the gross receipts tax, the gasoline excise tax, or the property tax. We concluded that any of …

Is Transportation Planning Effective? A Critical Review Of Long-Range Regional Transportation Planning In The United States, Razieh Nadafianshahamabadi

Civil Engineering ETDs

The Federal-Aid Highway Act requires urban areas with a population greater than 50,000 to create Metropolitan Planning Organizations (MPOs) to ensure that funding for transportation projects and programs are based on a continuing, cooperative, and comprehensive planning process. A major responsibility of each MPO is the creation of a long-range transportation plan (LRTP) that addresses the transportation needs of a metropolitan region over the next twenty years or more. While long-range regional transportation planning goals have grown to include a wide range of concerns and technical methods for evaluating planning scenarios have advanced substantially over the past 50 years, there …

Autonomous Vehicle Traffic Impact Scenario Analysis: Central New Mexico Case Study, Razieh Nadafianshahamabadi

Shared Knowledge Conference

Autonomous Vehicles (AVs) are on their way to becoming a significant part of our transportation systems and cities. Previous studies have mainly focused on how much AVs could improve traffic flow and reduce congestion or improve safety. Reducing congestion and the cost of travel time is also expected to increase travel demand, but by how much is not well understood. This study, located in Albuquerque, New Mexico, uses an integrated travel demand and land-use modeling system to evaluate how AVs may affect congestion, travel demand and land use. Our modeling system considers how traffic patterns, travel demand and land use …

Sustainable And Equitable Financing For Pedestrian Infrastructure Maintenance, Alexis Corning Padilla

Shared Knowledge Conference

In many communities, pedestrian infrastructure is discontinuous, inaccessible to those with physical disabilities, and poorly maintained. Correcting these problems would be a first step in providing infrastructure to achieve the active travel and related transportation goals of many communities. One nearly universal challenge to maintaining sidewalks in a state of good repair and addressing environmental justice concerns is an adequate, sustainable and equitable source of funding. Municipal governments across the country maintain and repair their streets and roadways; however, most require residents to maintain and repair public sidewalks adjacent to their property. These policies are difficult to enforce and may …

Understanding Asphalt Concrete Aging Using Nanoindentation, Hasan M. Faisal

Civil Engineering ETDs

Asphalt concrete (AC) is created by mixing liquid asphalt binder with solid aggregates. When asphalt binder is mixed with aggregates, it creates a thin film (about 7-16 microns thick) around the aggregate surface. Fine aggregate (smaller than 0.075 mm size) get entrapped within the binder film or mixed with the binder, and create a phase called mastic. Both asphalt film and mastic play significant roles in aging of asphalt pavement. To this day, tests were performed mainly on the bulk liquid asphalt, but not on the film or mastic. In this study, for the first time, nanoindentation tests were done …

Achieving Public Health And Climate Change Goals: What Do We Need To Know About The Transportation System?, Mohammad Tayarani

Civil Engineering ETDs

The overall aim of this dissertation is evaluating what new knowledge can be gained about the environmental and public health outcomes of regional transportation planning strategies by implementing a suite of more spatially and temporally detailed transportation and air quality models. This new knowledge can be used to better understand the potential health effects of emissions exposure while also guiding the development of new transportation and land-use plans, and related policies that have the potential to achieve large reductions in pollution exposure and green house gas emissions at local and regional level.

Characterization And Modeling Of Asphalt Concrete For Dynamic Properties And Performances, A S M A. Rahman

Civil Engineering ETDs

The recently developed mechanistic-empirical pavement design guide (MEPDG, also known as Pavement M-E design method) uses the nationally calibrated, binder viscosity-based dynamic modulus predictive model for the design and analysis of asphalt pavements. In this study, this model is assessed for its appropriateness for asphalt-aggregate mixtures typically used in New Mexico. In essence, this study investigates the predictability issue of complex modulus of New Mexico mixes. A total of 54 Superpave mixes with different aggregate gradations, air voids, and binder grades were collected from the mixing plants and from the pavement construction sites. The loose asphalt mixtures were then compacted, …

Practical Considerations In Determining Timber Pile Depth Using The Sonic Echo Method, Ali F. Jwary

Civil Engineering ETDs

The Federal Highway Administration indicates that about 85,000 bridges in the United States have no original contract documents with information about the type, depth, geometry and material of their foundations (FHWA, 2010). Furthermore, the National Bridge Inventory (NBI) provides information about 86,133 bridges nationwide that are rated as scour critical because of unknown foundation condition. In New Mexico, there are more than 281 bridges with unknown foundations, which are owned by the New Mexico Department of Transportation; 71 of these are timber bridges. These data indicate a serious problem that needs decisive action to assess the unknown bridge foundation characteristics …