Engineering Commons^™

Carbide-Derived Carbon By Electrochemical Etching Of Vanadium Carbides, Luis G.B. Camargo, Benjamin G. Palazzo, Greg Taylor, Zach A. Norris, Yash K. Patel, Jeffrey D. Hettinger, Lei Yu

Jeffrey Hettinger

Carbide-derived Carbon (CDC) has been demonstrated to be an excellent electrode material for electrochemical devices including supercapacitors due to its chemical and electrochemical stability, large specific surface area and controllable pore size and morphology. Currently, CDC is prepared from metal carbides by chlorination in a chlorine gas atmosphere at temperatures of 350°C or higher. In this paper, conversion using electrochemical methods is reported, which can be achieved by oxidizing vanadium carbides (VC or V2C) in aqueous solutions at room temperature and a mild electrode potential to prepare CDC thin film as electrode materials for “on-chip” supercapacitiors. It was found that …

Template Induced Fabrication Of Nitrogen Doped Carbon Sheets As Electrode Materials In Supercapacitors, Tao Huang, Guang-Zhi Tao, Chong-Qing Yang, Deng Lu, Lie Ma, Dong-Qing Wu

Journal of Electrochemistry

Due to the good electrical conductivity, high specific surface area, and excellent chemical/mechanical stability, carbon nanomaterials with two-dimensional morphology have gradually become the hot topic of the research on supercapacitors. Herein, we report for the first time the fabrication of nitrogen doped carbon sheets (NCSs). In our approach, the sheet-like magnisum aluminum (MgAl) layered double hydroxide was used as the hard template, which was mixed with o-phenylene diamine and iron chloride. The following thermal treatment could render the polymerization and carbonization of o-phenylene diamine. The NCSs with ordered hexagonal architectures were formed by final etching process of the thermally treated …

Strategies To Enhance Energy Density For Supercapacitors, Jun-Wei Lang, Xu Zhang, Ru-Tao Wang, Xing-Bin Yan

Journal of Electrochemistry

The biggest advantage of supercapacitor lies in not only the excellent pulse and fast charging-discharging performance, but also the characteristics of long cycle life and wide operating temperature window with no pollution. However, the energy density of supercapacitor is low. In this paper, the working principle, the development status, defects and improvement method of supercapacitors are introduced. Based on the research workes of the supercapacitors with high energy density in our group, combined with the literature reports in recent years, the strategies to promote the energy density of supercarpacitors will be focused. The strategies for the enhancement of energy density …

Porous Carbon Materials Produced By Koh Activation For Supercapacitor Electrodes, Jiang-Lin Ye, Yan-Wu Zhu

Journal of Electrochemistry

Porous carbon materials with high specific surface area and excellent conductivity have wide applications in supercapacitor electrodes. Much effort has been made to synthesize and tailor the microstructures of porous carbon materials via various activation procedures (physical and chemical activations). In particular, the chemical activation using potassium hydroxide (KOH) as an activating reagent is promising because of the well-defined micropore size distribution and ultrahigh specific surface area up to 3000 m²·g^-1 of the resulting porous carbons. Based mainly on the previous works taken by the authors and collaborators in the field, we have summarized the activation mechanism …

Cobalt-Doped Ceria/Reduced Graphene Oxide Nanocomposite As An Efficient Oxygen Reduction Reaction Catalyst And Supercapacitor Material, Shaikh Parwaiz, Kousik Bhunia, Ashok Kumar Das, Mohammad Mansoob Khan Dr, Debabrata Pradhan

Dr. Mohammad Mansoob Khan

Synthesis And Characterization Of Molybdenum Sulfide And For Hydrogen Evolution Reaction And Supercapacitor Applications, Zhuo Wang

Electronic Theses & Dissertations

To meet the constantly rising requirement of energy other than traditional fossil fuel and environment protection, it is a perfect time to development low cost, and efficient materials for clean energy production. Hydrogen generation by water splitting is one of the cleanest ways to produce cheaper energy. Hydrogen evolution reaction (HER) is one of the key steps in water splitting process. Ideally, the thermodynamic potential for HER should be at 0 V (vs. SHE). However, without an efficient catalyst, this reaction occurred at higher potential, called overpotential. A good HER catalyst is needed to lower the overpotential and hence to …

Novel Composites Between Nano-Structured Nickel Sulfides And Three-Dimensional Graphene For High Performance Supercapacitors, Xiaomin Wang, Huanglin Dou, Zhen Tian, Jiujun Zhang

Journal of Electrochemistry

In this paper, a three-dimensional graphene (3DG) network grown on nickel foam was employed as a template for synthesizing graphene-based composite materials of supercapacitor electrode. The composites (crystal Ni₃S₂ nanorods on the surface of 3DG (abbreviated as Ni₃S₂/3DG)) were obtained through a one-step hydrothermal reaction. The morphological and structural evolution of the Ni₃S₂/3DG composites were investigated by SEM, TEM, XRD and Raman spectroscopy. Detailed electrochemical characterization showed that the Ni₃S₂/3DG-coated electrodes exhibited both a specific capacitance as high as 1825 F·g^-1 at 5 mV·s …

Electrochemical Synthesis Of Porous Polyaniline Electrodes Using Hkust-1 As A Template And Their Electrochemical Supercapacitor Property, Qiong Luan, Chun-Feng Xue, Hong-Ye Zhu, Fu-Juan Yang, Xu-Li Ma, Xiao-Gang Hao

Journal of Electrochemistry

Excellent electrode plays vital important role in the performance of supercapacitors. Polyaniline (PANI) with good conductivity is often used to prepare electrode. However, its available surface is limited and results in a poor supercapacitance in many cases. It is desirable to fabricate an electrode containing electroactive PANI with high surface area deriving from its porous structure. Here, the metal-organic framework (MOF) material with high surface area was selected as a hard template for synthesizing porous PANI. Microporous PANI composite electrodes (Micro-PANI/CC) were fabricated by depositing aniline on to carbon cloth (CC) pre-coated with MOF material of HKUST-1 using a unipolar …

Preparation And Electrochemical Properties Of Attapulgite-Supported Nitrogen-Doped Carbon@Nico2O4Composites For Supercapacitors, Hui Wan, Zong-Rong Ying, Xin-Dong Liu, Jian-Jian Lu, Wen-Wen Zhang

Journal of Electrochemistry

In this work, the attapulgite-supported nitrogen-doped carbon (ANC) was prepared by in-situ chemically polymerizing polyaniline coating upon attapulgite, followed by high temperature heat treatment, and then NiCo₂O₄was reacted onto the surface of ANC by a combination of hydrothermal reaction and calcination to synthesize ANC@NiCo₂O₄ composites. The chemical composition and morphology of the samples were characterized by Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and N₂ adsorption/desorption. The electrochemical properties were evaluated by means of constant current charge discharge (GCD) and cyclic voltammetry (CV). …

Flexible Polycaprolactone (Pcl) Supercapacitor Based On Reduced Graphene Oxide (Rgo)/Single-Wall Carbon Nanotubes (Swnts) Composite Electrodes, Hyeon Taek Jeong, Yong-Ryeol Kim, Byung Chul Kim

Australian Institute for Innovative Materials - Papers

The reduced graphene oxide (rGO)/single-wall carbon nanotubes (SWNTs) composites are coated onto the polycaprolactone (PCL) substrate via spray coating technique to prepare a flexible supercapacitor. The electrochemical properties of the flexible PCL supercapacitor as a function of bending cycles and angles are evaluated using cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and galvanostatic charge/discharge tests. The EIS and charge/discharge curves of the flexible PCL supercapacitor exhibit capacitive behavior even after prolonged bending cycles up to 500. The highest capacitance value of the unbent PCL supercapacitor is 52.5 F g-1 which retained 65% after 500 bending with 6000th galvanostatic charge/discharge cycles.