Engineering Commons^™

Design And Development Of Test Rigs To Experimentally Investigate Flow Loss And Heat Transfer In A Stirling Engine Heater Head, Pawan K. Yadav

Graduate Theses, Dissertations, and Problem Reports

The Stirling engines are attractive alternative for combined heat and power (CHP) systems, especially for high efficiency power generation using different heat sources. The hot side heat exchanger or heater head (HH) is one of the indispensable components of Stirling engines which transfers the heat from outside of the system into the working fluid. For development of a low cost, highly efficient and reliable CHP system, a novel HH has been designed and additively manufactured from Inconel 625. For the investigation of flow loss and heat transfer through this Stirling engine heater head, two benchtop test rigs were designed, developed, …

Investigation Of Combustion Characteristics Of A Heavy-Duty Diesel Engine Retrofitted To Natural Gas Spark Ignition Operation, Jinlong Liu

Graduate Theses, Dissertations, and Problem Reports

The conversion of existing diesel engines to natural-gas spark ignition operation by adding a gas injector in the intake manifold for fuel delivery and replacing the diesel fuel injector with a spark plug to initiate and control the combustion process can reduce U.S. dependence on petroleum imports and curtail engine-out emissions. As the conventional diesel combustion chamber (i.e., flat head and bowl-in-piston) creates high turbulence, the engine can operate leaner, which would increase its efficiency and reduce emissions. However, natural gas combustion in such retrofitted engines presents differences compared to that in conventional spark ignited engines. Subsequently, the main goal …

Experimental Design, Testing, And Evaluation Of Methods To Improve The Efficiency And Reduce Emissions From A Small Two-Stroke Natural Gas Engine, Christopher Joseph Ulishney

Graduate Theses, Dissertations, and Problem Reports

Decentralized power generation is a research area of interest due to possible improvements in electrical generation efficiency and grid resilience. Two-stroke engines are simple, inexpensive, power dense systems that could serve as the prime-movers for combined heat and power (CHP) systems. In addition, such systems could be fueled on natural gas (NG) that is readily available to serve as a reliable fuel source in most households. However, most two-stroke engines are inefficient and produce excessive emissions. This research focused on methods to simultaneously improve engine efficiency and decrease emissions from a 34 cc air-cooled, two-stroke engine retrofitted to operate on …

An Experimental Investigation Of The Cooling System For A Free Piston Stirling Engine, Akshay Milind Gupte

Graduate Theses, Dissertations, and Problem Reports

Free-Piston Stirling Engine (FPSE) has been identified as a good candidate for combined heat and power application (CHP). FPSE being highly efficient and environmentally friendly promises to facilitate the increasing demand in waste heat energy recovery systems. FPSE system consists of three important components: (1) hot side heat exchanger; (2) regenerator; and (3) cold side heat exchanger. The cold side heat exchanger is a crucial part as it enables to maintain an optimal temperature of the working fluid by rejecting heat.

This research contributes to the design of heat exchanger test rig and experimental measurement of cooling heat exchanger. The …