Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Engineering

Characterizationn Of Polumer-Based Mems Pyroelectic Infrared Detector, Mark E. Allard Mar 2007

Characterizationn Of Polumer-Based Mems Pyroelectic Infrared Detector, Mark E. Allard

Theses and Dissertations

AFRL/MLPJE had developed a novel thermal sensing material termed protein-impregnated-polymer (PIP). Thus far, a proof-of-concept has been demonstrated using a macro-sized pixel (0.64 mm2) as a bolometric detector. In an effort to better characterize this novel thermal sensing material, experimental data was used to determine figures of merit (FOMs) comparative to off-the-shelf thermal detectors. Microelectromechanical (MEMS) pixels were designed and used as the support structure for an inkjet-deposited droplet of the PIP. During the material characterization, two observations were made: PIP is a pyroelectric material, and the polymer (polyvinyl alcohol (PVA)) without the protein was found to be …


Biological Cell Identification By Integrating Micro-Fluidics, Electrical Impedance Spectroscopy And Stochastic Estimation, Karl R. Schwenn Mar 2007

Biological Cell Identification By Integrating Micro-Fluidics, Electrical Impedance Spectroscopy And Stochastic Estimation, Karl R. Schwenn

Theses and Dissertations

The integration of micro-fluidics, electrical impedance spectroscopy and stochastic estimation will lead to a device with enhanced detection capabilities. The goal of this thesis was to build a micro-fluidic electrical impedance measurement device that can be used in combination with a stochastic estimator to accurately identify living cells. A microdevice capable of making impedance measurements on individual living cells was designed and built using a series of standard microelectronic fabrication techniques. A microchannel was patterned in SU-8 photoresist between two gold microelectrodes on a two inch Pyrex 7740 wafer. The design process, the fabrication techniques for the microchannel, the fluid …


Passive Geolocation Of Low Power Emitters In Urban Environments Using Tdoa, Myrna B. Montminy Mar 2007

Passive Geolocation Of Low Power Emitters In Urban Environments Using Tdoa, Myrna B. Montminy

Theses and Dissertations

Low-power devices are commonly used by the enemy to control Improvised Explosive Devices (IEDs), and as communications nodes for command and control. Quickly locating the source of these signals is difficult, especially in an urban environment where buildings and towers can cause interference. This research presents a geolocation system that combines several geolocation and error mitigation methods to locate an emitter in an urban environment. The proposed geolocation system uses a Time Difference of Arrival (TDOA) technique to estimate the location of the emitter of interest. Using sensors at known locations, TDOA estimates are obtained by cross-correlating the signal received …


Modeling, Simulation, And Estimation Of Optical Turbulence, Byron P. Formwalt Mar 2007

Modeling, Simulation, And Estimation Of Optical Turbulence, Byron P. Formwalt

Theses and Dissertations

This dissertation documents three new contributions to simulation and modeling of optical turbulence. The first contribution is the formalization, optimization, and validation of a modeling technique called successively conditioned rendering (SCR). The SCR technique is empirically validated by comparing the statistical error of random phase screens generated with the technique. The second contribution is the derivation of the covariance delineation theorem, which provides theoretical bounds on the error associated with SCR. It is shown empirically that the theoretical bound may be used to predict relative algorithm performance. Therefore, the covariance delineation theorem is a powerful tool for optimizing SCR algorithms. …