Engineering Commons^™

Hard Hat Ambient Liability Observer (Halo), Hunter Hykes, Nathan Kish, Brian Thomson

Williams Honors College, Honors Research Projects

Capturing workplace incident information is a growing area of concern for most companies. To assist with this, the design team proposed the H.A.L.O. This design uses time-of-flight sensors connected to LEDs to create a proximity-based hazard warning system. It also records incident data using an accelerometer and micro-SD card. This helps workers avoid some of the most common workplace injuries, slips, trips, and falls and accidental collisions.

Students have created a design with engineering, and marketing requirements that accomplish this task. The proposed design allows for this monitoring and mitigation systems to be attached to hard hats. Team members developed …

Vehicle Operator Attention Monitor, Matthew Krispinsky, Matt Marsek, Matthew Mayfield, Brian Call

Williams Honors College, Honors Research Projects

Motor vehicle operators’ attention levels can be monitored to improve driver safety. By recording and analyzing the drivers eye gaze, hand position, vehicle speed and engine rpm the driver’s attention can be determined. A Raspberry Pi will be the main processing unit. Data will be pulled and analyzed from the OBD-II port on vehicle speed and engine rpm. The system will be powered from a 12V, 4A pin on the OBD-II port connected to the car battery. A webcam will be used to track the pupil location and determine when the driver is looking at the road. A battery powered …

Process Control Laboratory Skid Refurbishment, Danny Crowder

Williams Honors College, Honors Research Projects

This project evaluates a salvaged process control skid for potential refurbishment and educational re-use. In-lab work evaluated the existing skid. Several process control elements have been recommended for replacement, including the process tank (due to corrosion), the pressure transmitter (operability/corrosion), the flow meters (mechanical) and the control system (age). The control valves, temperature elements and transmitters, pump, holding tanks, and the electrical heat exchanger should be salvaged. An I/P converter and pressure relief valve should be added to the pneumatic feed. Enclosing of all electrical components should be prioritized. An electrical schematic for a new control system should be implemented. …

Pothole Reporting System, Alissa L. Mcgill, Brian G. Simmons, Sean D. Querry, Elizabeth J. Hammell

Williams Honors College, Honors Research Projects

The purpose of this project is to create a pothole detection device that can be attached to the underside of a commercial vehicle. Potholes cost motorists around 6.4 billion dollars annually, thus demonstrating the need for a system to aid with the detection and reporting of potholes. The four systems we needed to consider for the implementation of this project were the power system, the sensing system, the data processing system, and the reporting and logging system. Power pulled from the vehicle will enable the sensors and data processing module. The data processing module will analyze the readings from the …