Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Evaluation Of Additively Manufactured Lattices Under High Strain Rate Impact, Derek G. Spear
Evaluation Of Additively Manufactured Lattices Under High Strain Rate Impact, Derek G. Spear
Theses and Dissertations
Several additively manufactured lattice designs and configurations were evaluated under compression loads under various strain rates from quasi-static to highly dynamic. These experiments examined how the mechanical behavior of the lattice changed based on the lattice design properties and the applied strain rates. The modulus of elasticity, yield strength, plateau stress, and toughness were observed to decrease with an increase in strain rate, revealing that the lattice designs exhibit a negative strain rate sensitivity. A new lattice flow stress model was developed to account for the mechanical response of the lattice and was incorporated into a computational model for simulation. …
A Reduced Order Model Of The Celestial Icosahedron As The Substructure For A Lighter Than Air Vehicle, Torin C. Quick
A Reduced Order Model Of The Celestial Icosahedron As The Substructure For A Lighter Than Air Vehicle, Torin C. Quick
Theses and Dissertations
A finite element approach was used to investigate a novel reduced order model to determine the minimum structure dimensionality to support vacuum for a VLTAV. This modeling technique represented the individual segments of the substructure as curved beams with clamped radially-resisted boundary conditions. The full structure was then modeled as a bare structure and structure with skin to validate the results of the reduced order model. The beam geometry for the material Ultem 9085 was determined through this process leading to the 3-D printing of the structure. It was then experimentally tested under uniaxial compression complimented with a FEA model.
Improving Manufacturability And Reducing Cracking In Additively Manufactured Tungsten Alloys, Christopher P. Fassio
Improving Manufacturability And Reducing Cracking In Additively Manufactured Tungsten Alloys, Christopher P. Fassio
Theses and Dissertations
Additively Manufactured tungsten suffers from low () densities due to high concentrations of microcracks as the printed layers cool past tungsten's high ductile to brittle transition temperature. In this study, tungsten-rhenium and tungsten rhenium hafnium carbide compositions were evaluated on density and tensile strength. In addition to varying the compositions of each alloy, printing parameters and post-processing methods were also compared. Print parameters varied for all compositions on an MLab 200R C using included the laser scan strategy, hatch spacing, scan speed, laser power, and print bed material. Post processing techniques of the WRe compositions included hot isostatic pressing and …