Open Access. Powered by Scholars. Published by Universities.®

Architecture Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Architecture

Characteristics Of A Viscous Damper: Finding The Damping Coefficient, Roman Lara Iv, Tiffany Wang Jun 2019

Characteristics Of A Viscous Damper: Finding The Damping Coefficient, Roman Lara Iv, Tiffany Wang

Architectural Engineering

The authors of this report are undergraduate Architectural Engineering students at California Polytechnic State University in San Luis Obispo. This report documents the implementation, design, and experimentation of a damper with unknown properties. This experimentation data will be used to find the damping coefficient of a viscous damper alongside damping characteristics. Using knowledge from previous courses, this report focuses on dynamic responses through an assumed viscous damper. Through forced oscillatory motion testing with specified frequency and amplitude using the seismic shake table and equipment, compactDAQ instrumentation, and damper, values can be pulled from the data experimentation, which can be used …


Performance-Based Analysis Of A Reinforced Concrete Shear Wall Building, Garrett Richard Hagen Jun 2012

Performance-Based Analysis Of A Reinforced Concrete Shear Wall Building, Garrett Richard Hagen

Master's Theses

PERFORMANCE-BASED ANALYSIS OF A REINFORCED CONCRETE SHEAR WALL BUILDING

Garrett Richard Hagen

In this thesis, a special reinforced concrete shear wall building was designed per ASCE 7-05, and then the performance was investigated using the four analysis procedures outlined in ASCE 41-06. The proposed building was planned as a 6-story office building in San Francisco, CA. The structural system consisted of a two-way flat plate and reinforced concrete columns for gravity loads and slender structural walls for seismic loads. The mathematical building models utilized recommendations from ASCE 41-06 and first-principle mechanics. Moment-curvature analysis and fiber cross-section elements were used in …