Urban Studies and Planning Commons^™

Development Of The Idaho Statewide Travel Demand Model Trip Matrices Using Cell Phone Od Data And Origin Destination Matrix Estimation, Ben Stabler

PSU Transportation Seminars

As part of the initial phase of development for the Idaho Statewide Travel Demand Model, Parsons Brinckerhoff developed a base year auto and truck trip matrix using AirSage cell phone OD data, a statewide network in Cube, traffic counts, and origin-destination matrix estimation (ODME) procedures. To begin, the 4000+ statewide zone system was aggregated into a 700 super zone system for collecting the cell phone OD data. Next, the cell phone data was collected for the month of September 2013 for the following market segments: Average weekday resident HBW, HBO, NHB, and visitor NHB trips. The cell phone trips were …

Locating Truck Data Collection Sites In Oregon Using Representation Optimal Sampling, Kenneth Dueker, William A. Rabiega, Bruce Rex

Center for Urban Studies Publications and Reports

The Oregon Department of Transportation collects data on the performance of the highway system by sampling traffic volume, vehicle classification, truck weights, pavement conditions, etc. The selection of efficient and accurate locations for collecting data is important. This report addresses the larger sampling problem by focusing on locations for collecting truck weight data. Sites selected for weight-in-motion/automatic vehicle identification (WIM/AVI) within the Crescent/HELP project are assessed to determine their locational suitability for truck weight data collection. A method, Representation Optimal Sampling (ROS), to aid in site selection is reported here. Sampling configurations of six and twelve station using ROS are …

Rerouting Mode Choice Models: ​H​Ow Including Realistic Route Options Can Help Us Understand Decisions To Walk Or Bike, Joseph Broach

PSU Transportation Seminars

For a number of reasons—congestion, public health, greenhouse gas emissions, energy use, demographic shifts, and community livability to name a few—the importance of walking and bicycling as transportation options will only continue to increase. Currently, policy interest and infrastructure funding for nonmotorized modes far outstrip our ability to successfully model bike and walk travel. In the past five years, we have learned a lot about where people prefer to bike and walk, but what can that tell us about whether people will bike or walk in the first place? The research presented here is designed to start bridging the gap …

Influence Of Road Cross Section On Access Spacing, Karen K. Dixon, Yanfen Zhou, J. L. Gattis

TREC Final Reports

This report presents a study on the influences of select cross-sectional-related design elements (specifically median configurations and bicycle lanes) and their impact on crash severity and type, as well as the associated driver gap acceptance for turning maneuvers at midblock driveway locations on urban arterials. The primary goal of this proposed research is to better understand how the median and bicycle lane configurations can influence safety and operations at driveway locations. The research team utilized crash data, traffic data, and roadway information from driveway locations in the U.S. states of Oregon, Arkansas and Oklahoma. The project team supplemented the data …

Bicycle Traffic Count Factoring: An Examination Of National, State And Locally Derived Daily Extrapolation Factors, Josh Frank Roll

Dissertations and Theses

Since nearly the beginning of the wide spread adoption of the automobile, motorized traffic data collection has occurred so that decision makers have information to plan the transportation system. Widespread motorized traffic data collection has allowed for estimating traffic volumes using developed extrapolation methods whereby short-term counts in sample locations can be expanded to longer periods. As states and local planning agencies make investments in bicycle infrastructure and count programs develop, similar extrapolation methods will be needed. The only available guidance on extrapolating bicycle counts comes from the National Bicycle and Pedestrian Documentation Project (NBPDP), yet no validation of these …

Traffic Data Selection: An Evaluation Of Siting Criteria For Permanent Traffic Recorders, Richard Ledbetter, Kenneth Dueker, Milan Krukar, Vern Tabery

Center for Urban Studies Publications and Reports

Traffic volume data are needed for design and construction zone traffic management. In addition, continuous traffic volume data (collected by automatic traffic recorders) is needed to factor short counts (24 hours or more) collected at key sites on the states highway network.

This study evaluates the procedures used by the Oregon Department of Transportation for collecting continuous traffic volume data to determine: (1) if the current location and number of automatic traffic recorders (ATRs) on Oregon's highway network is adequate for estimating monthly seasonal factors, and (2) if the current procedure of using group means, based on geographical regions, to …