Open Access. Powered by Scholars. Published by Universities.®
Social and Behavioral Sciences Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Social and Behavioral Sciences
Role Of Cr And P Additions In The Development Of Microstructure And Texture In Annealed Low Carbon Steels, E V. Pereloma, I B. Timokhina, A I. Nosenkov, J J. Jonas
Role Of Cr And P Additions In The Development Of Microstructure And Texture In Annealed Low Carbon Steels, E V. Pereloma, I B. Timokhina, A I. Nosenkov, J J. Jonas
Faculty of Engineering and Information Sciences - Papers: Part A
The recrystallisation behaviour of four warm rolled steels was investigated during annealing. The extra-low carbon (ELC) steel displayed the highest rate of recrystallisation, the steels with additions of chromium and phosphorus (LC(Cr)), (LC(Cr,P)) recrystallised at intermediate rates, while the interstitial-free (IF) steel exhibited the lowest rate. The additions of Cr and Cr/P increased the fraction of g-fibre in the annealing textures compared to that present in the ELC steel; this effect was particularly pronounced up to 50 % recrystallisation. After the completion of recrystallisation, the steel textures were characterized by a dominant g-fibre in the IF steel, while in the …
Effect Of Microstructure On The Stability Of Retained Austenite In Transformation-Induced-Plasiticity Steels, I B. Timokhina, P D. Hodgson, E V. Pereloma
Effect Of Microstructure On The Stability Of Retained Austenite In Transformation-Induced-Plasiticity Steels, I B. Timokhina, P D. Hodgson, E V. Pereloma
Faculty of Engineering and Information Sciences - Papers: Part A
Two Fe-0.2C-1.55Mn-1.5Si (in wt pct) steels, with and without the addition of 0.039Nb (in wt pct), were studied using laboratory rolling-mill simulations of controlled thermomechanical processing. The microstructures of all samples were characterized by optical metallography, X-ray diffraction (XRD), and transmission electron microscopy (TEM). The microstructural behavior of phases under applied strain was studied using a heat-tinting technique. Despite the similarity in the microstructures of the two steels (equal amounts of polygonal ferrite, carbide-free bainite, and retained austenite), the mechanical properties were different. The mechanical properties of these transformation-induced-plasticity (TRIP) steels depended not only on the individual behavior of all …
Widmanstatten Ferrite Plate Formation In Low-Carbon Steels, Dominic Phelan, Rian Dippenaar
Widmanstatten Ferrite Plate Formation In Low-Carbon Steels, Dominic Phelan, Rian Dippenaar
Faculty of Engineering and Information Sciences - Papers: Part A
The mechanism by which Widmanstätten ferrite plates nucleate and grow in low-carbon steels has been studied. In-situ laser scanning confocal microscopy (LSCM) observations, optical microscopy, and electron backscattered diffraction (EBSD) techniques have been used to characterize the relationship between grain boundary allotriomorphs and Widmanstätten ferrite plates. The issue of where Widmanstätten ferrite plates nucleate is one of some debate, with theories including morphological instability and sympathetic nucleation. Evidence has been found that supports the theory of a sympathetic nucleation mechanism being responsible for the formation of Widmanstätten ferrite plates. The EBSD measurements have shown that low-angle misorientations of between 5 …