Open Access. Powered by Scholars. Published by Universities.®

Social and Behavioral Sciences Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 30 of 37

Full-Text Articles in Social and Behavioral Sciences

Ddasaccident811, Hd-Aid May 2014

Ddasaccident811, Hd-Aid

Global CWD Repository

The accident occurred outside of cleared and marked area, in the bank of Panj River, just 3m away from water line. TL left his helmet and map case in the cleared area (found later in systematic technical survey lane), stepped over the marking and proceeded passing through the uncleared dangerous area towards to river. The foot prints on the ground are clearly visible where TL stepped over the marking. The distance (straight line) between this place and place of explosion is 77m.


Ddasaccident796, Hd-Aid Dec 2011

Ddasaccident796, Hd-Aid

Global CWD Repository

At 10.02 AM, During the transfer of the fuses from Searcher [Victim No.2] to ISS [Victim No.1], one fuse fall on the soil and detonate close to the right foot of the ISS. Injures occurred.


Ddasaccident786, Hd-Aid Apr 2011

Ddasaccident786, Hd-Aid

Global CWD Repository

THREE demining experts from the Cambodian Mine Action Centre were killed over the weekend in Kampong Speu province when several hundred shells being stored in a temporary location exploded.


Ddasaccident724, Hd-Aid Dec 2010

Ddasaccident724, Hd-Aid

Global CWD Repository

On 21 Dec 2011, the deminer [the Victim] started his work as usual in the assigned task for him to continue the clearance of the Mine Line (SML) which was laid as a cluster with one AT mine (M19) guarded by 3 APs M35 and after recovering and defusing one AT (19) and 2 APs (M35 / no defusing), the deminer started his work for the second period at 8:45 and he reported one signal to the team leader. The team leader left him to proceed with the proper procedures to recover and defuse the mine and at 8:55 hrs …


Ddasaccident703, Hd-Aid Sep 2010

Ddasaccident703, Hd-Aid

Global CWD Repository

The deminer was working in the centre lane in the main minefield 346 and he recovered 6 M14 APs. At 12:15 hrs he started to approach AP M14 and he located one cluster then he moved to the next one, and while he was conducting visual check stage, he did not follow the proper procedure to remove the grass ,instead of using grass cutter to remove the grass he used his bared hand to pull the grass which accidentally caused the blast.


Ddasaccident628, Hd-Aid Sep 2009

Ddasaccident628, Hd-Aid

Global CWD Repository

Deminer was clearing the first 60 cm of one cluster heading toward the centre mine after he cleared the 1st 60 cm by one 1m width with no signals he moved his base stick a head to clear the next 60 cm, then he stepped on the area which considered to be cleared by the same deminer, accidently his foot went down due to the soil collapse under his foot (loose soil), the mine was in a depth of about 30 cm that when the deminer foot dived in the loosen soil he applied a pressure on the mine which …


Ddasaccident619, Hd-Aid Nov 2008

Ddasaccident619, Hd-Aid

Global CWD Repository

The primary cause of this accident is listed as Victim Inattention because the investigators imply that the Victim deliberately walked into the uncleared area. The secondary cause is listed as a Field Control Inadequacy because the field supervisors did nothing to prevent him doing so.


Ddasaccident692, Hd-Aid Oct 2008

Ddasaccident692, Hd-Aid

Global CWD Repository

The investigation team concluded that the contributing factor to this accident was Carelessness of deminer in terms of use of bayonet by left hand which was in contrary to his habit.


Ddasaccident697, Hd-Aid Aug 2008

Ddasaccident697, Hd-Aid

Global CWD Repository

It is the conclusion of investigation team that the carelessness of involved ATL, deviation from AMAS and [Demining group]’s SOP and use of dark visor during disarming operation on the fuse are the contributing factors to this accident. Additionally the rule of supervision is vital in preventing such accidents.


Ddasaccident631, Hd-Aid Jul 2008

Ddasaccident631, Hd-Aid

Global CWD Repository

On 1st July 2009 MU-16 of [Demining group] started clearance operation on mentioned task, On 08 July 2009 at 0919hrs while [the Victim] was investigating a signal in his clearance lane, he found two bullets. He re-checked the spot and found the same signal, this process repeated for three times. Finally he found a root stump in the excavation trench with a thickness of around 2.5 cm and started to remove it, because it was blocking further excavation there. However the deminer had proper tool in his toolkit to cut such obstacles, but he tried to out it with his …


Ddasaccident788, Hd-Aid Sep 2007

Ddasaccident788, Hd-Aid

Global CWD Repository

On September 09, 2007 at 1130 hrs an accident happened on [the Victim] section leader of Section No.01 of the mentioned team while he was looking for stones to mark the cleared area. The accident happened on a portion of unclear area while he touched a stone. As a result of the accident he lost his left hand from the wrist and his right hand thumb. Also his right eye injured and he got a slight injury on his chest too.


Ddasaccident553, Hd-Aid Jan 2007

Ddasaccident553, Hd-Aid

Global CWD Repository

On the day of the accident the team consisted of 10 members: Site Supervisor, Team Leader, 6 x searchers, medic and driver. [The Victim]. acting Team Leader, was supervising three searchers in the area of Box C3, [Names removed] who were conducting visual search of the area. [Name removed] was standing in the visually cleared area to the rear of the searchers supervising the surface search operations. At approximately 1008hrs, an uncontrolled explosion occurred in box C3, involving [the Victim]. At the time of the accident all team members were wearing PPE (jacket and visor).


Ddasaccident525, Hd-Aid Nov 2005

Ddasaccident525, Hd-Aid

Global CWD Repository

The primary cause of this accident is listed as “Deminer inattention” because the Victim slipped into the cleared area. Questions arise about the suitability of his footwear. The secondary cause is listed as a “Management control inadequacy” because the management of the demining group declined to make the accident details available. Although this is sometimes done to protect the Victims, in this case the Victim’s name was among the limited detail made available. It is possible that the managers have chosen to avoid transparency because they are afraid that the circumstances of the accident would reflect badly on their organisation.


Ddasaccident520, Hd-Aid Dec 2004

Ddasaccident520, Hd-Aid

Global CWD Repository

Details of this accident have been withheld by the demining NGO that employed the Victim. A spreadsheet including the Victim’s name and very brief details of the accident was made available in 2007. Some details can be inferred from the information released. For example, the limited injury implies that the victim’s PPE was being worn in the correct manner.


Ddasaccident458, Hd-Aid Mar 2004

Ddasaccident458, Hd-Aid

Global CWD Repository

[The Victim] was going away from the lane. At about 10 m distance from [Name removed], who approached the base line, he slipped with his left foot below the tape into a non-examined part of the minefield and activated a PMA-3. The working path was narrower there because of a larger rock. After the explosion, [the Victim] fell into the working path, but with his legs lying in the non-examined part. Deminer [Name removed] pulled him out into the cleared part. The tip of the left shoe was damaged. It was taken off.


Ddasaccident421, Hd-Aid Sep 2003

Ddasaccident421, Hd-Aid

Global CWD Repository

The accident happened 21 September 2003. The truck was carrying deminers to work along the cleared section of the road. At 09:00 in the morning, the truck crossed into the uncleared area by a short distance and its left side front wheel detonated a TM-57 AT mine.


Ddasaccident428, Hd-Aid Aug 2002

Ddasaccident428, Hd-Aid

Global CWD Repository

Referring to demining sequence, deminer no. 1 conducted vegetation removal drill (skipped tripwire drill due to none of tripwire); upon completion of the vegetation removal drill, deminer no. 2 [ the victim] conducted detector drill. These drills had been repeated two to three times already to the time of accident occurred. Mr. [name excised], the victim's peer, told that he found deminer no. 1 removed the cut salvages once then the second time and then he heard an explosion and found [the victim] falling backward into the cleared area. Then he called section commander for help, section commander called to …


Ddasaccident461, Hd-Aid Jan 2002

Ddasaccident461, Hd-Aid

Global CWD Repository

Stood on PMN mine, after accidentally stepping over the front of lane marker. Mine did not function properly and so injuries not consistent with those expected from type of mine.


Ddasaccident367, Hd-Aid Sep 2001

Ddasaccident367, Hd-Aid

Global CWD Repository

Approximately 70cm past this 1.2m x 1.2m area was a visual PMR2A. [The Victim] had an indication from his metal detector and was investigating this reading. He had cut the vegetation and was in the process of turning around to get his detector to pin point the reading when he placed the outside of his left foot on the mine and it detonated.


Ddasaccident014, Hd-Aid Aug 2000

Ddasaccident014, Hd-Aid

Global CWD Repository

The group operated using a one-man drill and a two-man team with the resting deminers in a designated rest-area. Working time varied between 30 minutes and an hour depending on "the weather conditions". The last MACC QA visit had been seven days before. [There was no mention of metal-detectors in the report, so it is presumed that a "sapping drill was being used.]


Ddasaccident262, Hd-Aid Oct 1999

Ddasaccident262, Hd-Aid

Global CWD Repository

After lunch four of the deminers were tasked to build a bridge over a creek to allow better access to the area being cleared. The remaining deminer and the supervisor cleared a one metre wide lane in order to examine a tripwire that had been spotted outside the working area. When they got close to the tripwire the supervisor took over clearance and worked for 20 minutes. Then he "stood up, turned around and requested two more small pickets to mark his lane". While doing this he "lost his footing" and took a step backwards over his base stick with …


Ddasaccident218, Hd-Aid Apr 1998

Ddasaccident218, Hd-Aid

Global CWD Repository

The investigator concluded that the accident occurred as a result of the victim's "total disregard of the inherent dangers of the area and [his] failure to conform to normal work procedures.


Ddasaccident139, Hd-Aid Nov 1997

Ddasaccident139, Hd-Aid

Global CWD Repository

The investigators concluded that the victim was feeling unwell and had requested leave, so he might not have been concentrating when he stepped into an uncleared area. He might also have stepped on a missed mine.


Ddasaccident139, Hd-Aid Nov 1997

Ddasaccident139, Hd-Aid

Global CWD Repository

The investigators checked the Team's detectors and found five to be not "in proper working condition". The victim used one of these detectors. At the end of the working day the victim was taking his equipment to the store and either stepped into an uncleared area or stepped on a missed mine (due to the faulty detectors).


Ddasaccident006, Hd-Aid Nov 1997

Ddasaccident006, Hd-Aid

Global CWD Repository

The team started work at 07:30 and at 09:30 it started to rain so they stopped work. The rain was light but it prevented the deminers from seeing through their visors until 10:55 when they started work again. At 11:10 the victim found a mine and was starting to mark it. He turned to his No.2 to request some pickets and as he did so he slipped and fell backwards onto the mine. The victim was holding his detector at the time. He was thrown into a mined area so a safe lane was cleared to reach him. He was …


Ddasaccident167, Hd-Aid Sep 1997

Ddasaccident167, Hd-Aid

Global CWD Repository

The working area was covered with dense vegetation and the clearance work involved the removal of thick bushes and small trees. The victim had been working as the vegetation cutter and prodder man on the morning of the accident and had completed the clearance of his lane just before the lunch break. As he was returning he noticed that one of the stakes holding the marking tape was not straight so he attempted to put it right by pulling the tape. In trying to do so he walked along a fallen log near the edge of the lane but his …


Ddasaccident169, Hd-Aid Aug 1997

Ddasaccident169, Hd-Aid

Global CWD Repository

Victim No.1 was carrying a DK2 fuse to the collections pit and dropped it. It exploded when it hit the ground. The victim was leaning over slightly when it fell and received injuries to his cheek and nose. The other two victims were close by and were hit on the back by fragments and small stones.


Ddasaccident236, Hd-Aid Jul 1997

Ddasaccident236, Hd-Aid

Global CWD Repository

The document stated that the victim was called to confirm the presence of a mine by one of his colleagues. He turned to comply, and as he did so his foot slipped "on a piece of wood" and he fell over. As he got up "he put his foot outside the cleared lane and detonated a PMA-3 which was buried and not visible".


Ddasaccident172, Hd-Aid Feb 1997

Ddasaccident172, Hd-Aid

Global CWD Repository

The primary cause of this accident is listed as a "Field control inadequacy" because the victim was apparently in breach of SOPs (habitually) but had not been disciplined or appropriately corrected.


Ddasaccident112, Hd-Aid Jan 1997

Ddasaccident112, Hd-Aid

Global CWD Repository

The investigators determined that the victim was pulling a wire obstacle out of the way when he accidentally stepped into an uncleared area and trod on a PMN [presumably identified by inference].