Social and Behavioral Sciences Commons^™

2016 Archaeological Investigations At The Sanders Site (41lr2), Timothy K. Perttula, Bo Nelson, Mark Walters

CRHR Research Reports

The T. M. Sanders site (41LR2) is a large and impressive ancestral Caddo mound center and village situated on an alluvial terrace (450 ft. amsl) at the mouth of Bois d’Arc Creek and the Red River. With the permission of the landowners (the Crawford family and the Sanders family), periodic archaeological and geophysical investigations have been conducted across much of the 200+ acres of the Sanders site since 2013; this article primarily discusses the work done in March 2016. These archaeological investigations, including controlled surface collections and shovel testing, recovered significant new information from many of the 39 non-mound habitation …

Documentation Of Caddo Ceramic Vessels In The Texas Parks And Wildlife Department Holdings From Goliad State Park, Timothy K. Perttula, Robert Z. Selden Jr.

CRHR Research Reports

On February 6, 2015, three Caddo vessels from an unknown site or sites were documented at the Texas Parks and Wildlife Department’s Archeology Laboratory, where the standard suite of metadata was collected, accompanied by photographs and 3D models of each vessel. While the donor of these vessels remains unknown, stylistic and technological attributes can be used to posit the potential region of origin.

There are three 3D models included in this report of NAGPRA documentation. To manipulate, measure, and otherwise quantify variability in the models, this document must be downloaded, then opened in either Adobe Acrobat or Adobe Reader. These …

3d Scan Data Of Caddo Burial Vessels From The Mcspadden Site Near Frankston, Texas, Robert Z. Selden Jr.

CRHR Research Reports

In the spring of 2013, three Caddo burial vessels from an unrecorded site near Frankston, Texas were documented at the McSpadden residence in College Station, Texas. All three vessels are intact and are not reconstructed. Scan data was collected using a ZScanner 700CX running VXElements 2.0 via the scanner direct control function in Geomagic Design X. Post-processing of these data occurred in Design X, and quality control for missing data leveraged both Design X and Verify. These data will be used in a study aimed at the 3D geometric morphometric analysis of Caddo vessels. In addition to the study of …