Physical Sciences and Mathematics Commons^™

The Quaternary Tectonic And Structural Evolution Of The San Felipe Hills, California, Stefan M. Kirby

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

We examine the transition between extension and strike-s lip in the San Felipe Hills, western Salton Trough, southern California using new and compiled geologic mapping, measured stratigraphic sections, magnetostratigraphy, and structural analysis. A 625 m measured section describes the Borrego, Ocotillo , and Brawley formations in the SE San Felipe Hills and constrains a regional disconformity and correlative angular unconformity at ~ 1 Ma. Sedimentation rates for the Brawley Formation above the disconformity range from 1.0 to 1.2 mm/yr, palcoflow was to the ENE. The Brawley Formation consists of three interbeddcd lithofac ics; (I) fluvial and fluvio-d eltaic, (2) lacustrinc, …

Relating Bedrock Strength To Hydraulic Driving Forces Along The Large-Scale Profile Of The Colorado River In Glen And Grand Canyons, Rob D. Mackley

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The role of bedrock on the longitudinal profile of the Colorado River has intrigued workers for over a century. The river's profile exhibits large-scale (10 to 100 km) variations in geomorphology that are qualitatively associated with changes in rock type. This study provides the first bedrock-strength data to quantitatively test the relation of bedrock-resisting to hydraulic-driving forces in Glen and Grand canyons. The intent of this study is to explore the role, if any, that bedrock has on large-scale geomorphic variations along the profile of the Colorado River. Rock-strength data collected at 84 sites along the river corridor in Glen …

The Quaternary Stratigraphy Of The Henrys Fork And Western Browns Park, Northeastern Uinta Mountains, Utah And Wyoming, Ronald C. Counts

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The landscape evolution of the northeastern Uinta Mountains and the manner in which climatic and tectonic forcing have influenced it are not well constrained. Surficial deposits covering ~325 km² below the glacial termini in the Henrys Fork and ~50 km² along the Green River in western Browns Park were mapped at 1:24,000 scale to develop a Quaternary stratigraphic framework for the northeastern Uinta Mountains.

The Henrys Fork mapping area spans from late Wisconsinan moraines to Flaming Gorge Reservoir. The Henrys Fork stratigraphy contains 10 mainstem gravels, six piedmont gravels, and landslide deposits. Terraces preserved along the Henrys Fork …

Characterizing Deformation, Damage Parameters, And Clay Composition In Fault Zones: Insights From The Chelungpu Thrust, Taiwan, And Mozumi Right Lateral Fault, Japan, Angela J. Isaacs

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The Chelungpu thrust fault, Taiwan, and the Mozumi right-lateral fault, Japan, provide an opportunity to characterize active faults in clastic sedimentary rocks and provide constraints to seismologic models. The northern Chelungpu fault has a 10-30 m wide primary damage zone characterized by dense fractures and chemical alteration. The southern Chelungpu fault has a 25-70 m wide primary damage zone characterized by dense fractures, alteration, intensely sheared rock, and secondary faults. The complexity of the damage zone, geochemistry, and clay mineralogy of the southern fault zone reflects its greater maturity (~1 Ma) relative to the northern fault zone (~46-100 Ka). A …

Stratigraphic And Structural Analysis Of Coals In The Ferron Sandstone Member Of The Mancos Shale And Fruitland Formation: Relationship To Coal Reservoir Permeability And Coalbed Methane Production, Jason Lynn Kneedy

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Coal reservoir quality in the Ferron Sandstone Member of the Mancos Shale, and in the Fruitland Formation is dependent on coal cleat characteristics. Coal reservoir permeability increases as a result of high cleat density. From careful outcrop examination, we were able to identify several factors that increase cleat density. Vitrain coal typically has the highest fracture density as a result of having well-developed face cleats and conchoidal fractures. Clarain coal contains face and butt cleats. Cleat density in clarain is also controlled by mechanical layer thickness. As mechanical layer thickness decreases, cleat density increases. Durain and fusain coals typically contain …

Humic And Fulvic Acids: Effects On Plant Nutrition And Growth, Jason Tew

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Humic substances are reported to improve plant growth and nutrient uptake, with iron the most studied nutrient. The most common forms of iron in soils are iron oxides, which are stable under aerobic conditions and unavailable for plant uptake. Iron deficient plants become chlorotic, which reduces growth and yield. To determine if humic substances can reduce iron chlorosis, five commercially available organic acids were tested on maize grown in sand columns at high pH. The dry granular humic acid from Aldrich Chemical Company applied at 84.4 g/liter of sand by volume (5% by mass) and 1 g/liter added with irrigation …

Examination Of Exhumed Faults In The Western San Bernardino Mountains, California: Implications For Fault Growth And Earthquake Rupture, Joseph R. Jacobs

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The late Miocene Cedar Springs fault system is a high-angle transpressional system in the Silverwood Lake area, western San Bernardino Mountains, southern California. This thesis presents the study of oblique-slip faults with modest amounts of slip, which represent the early stages of fault development by using slip as a proxy for maturity. A structural and geochemical characterization is provided for six fault zones ranging from 39 m of slip to 3.5 km of offset in order to develop a model of fault zone geometry and composition. Basic geometric and kinematic results are provided for an additional 29 small-displacement (cm- to …