Open Access. Powered by Scholars. Published by Universities.®
Physical Sciences and Mathematics Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Physical Sciences and Mathematics
Atomic Hydrogen Cleaning Of Inp(100): Electron Yield And Surface Morphology Of Negative Electron Affinity Activated Surfaces, M. A. Hafez, H. E. Elsayed-Ali
Atomic Hydrogen Cleaning Of Inp(100): Electron Yield And Surface Morphology Of Negative Electron Affinity Activated Surfaces, M. A. Hafez, H. E. Elsayed-Ali
Electrical & Computer Engineering Faculty Publications
Atomic hydrogen cleaning of the InP(100) surface has been investigated using quantitative reflection high-energy electron diffraction. The quantum efficiency of the surface when activated to negative electron affinity was correlated with surface morphology. The electron diffraction patterns showed that hydrogen cleaning is effective in removing surface contaminants, leaving a clean, ordered, and (2×4)-reconstructed surface. After activation to negative electron affinity, a quantum efficiency of ∼6% was produced in response to photoactivation at 632 nm. Secondary electron emission from the hydrogen-cleaned InP(100)-(2×4) surface was measured and correlated to the quantum efficiency. The morphology of the vicinal InP(100) surface was investigated using …
High-Efficiency Solar Cells Based On Cu(Inal)Se[Sub 2] Thin Films, S. Marsillac, P. D. Paulson, M. W. Haimbodi, R. W. Birkmire, W. N. Shafarman
High-Efficiency Solar Cells Based On Cu(Inal)Se[Sub 2] Thin Films, S. Marsillac, P. D. Paulson, M. W. Haimbodi, R. W. Birkmire, W. N. Shafarman
Electrical & Computer Engineering Faculty Publications
A Cu(InAl)Se2solar cell with 16.9% efficiency is demonstrated using a Cu(InAl)Se2thin film deposited by four-source elemental evaporation and a device structure of glass/Mo/Cu(InAl)Se2/CdS/ZnO/indium tin oxide/(Ni/Algrid)/MgF2. A key to high efficiency is improved adhesion between the Cu(InAl)Se2 and the Mo back contact layer, provided by a 5-nm-thick Ga interlayer, which enabled the Cu(InAl)Se2 to be deposited at a 530 °C substrate temperature. Film and device properties are compared to Cu(InGa)Se2 with the same band gap of 1.16 eV. The solar cells have similar behavior, with performance limited by recombination through …