Open Access. Powered by Scholars. Published by Universities.®

Physical Sciences and Mathematics Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Physical Sciences and Mathematics

Energetyczne Wykorzystanie Stałych Paliw Wtórnych Z Odpadów (Srf) Na Przykładzie Instalacji Współspalania Paliw W Cementowni Chełm, Magdalena Kasietczuk, Robert Oleniacz Nov 2012

Energetyczne Wykorzystanie Stałych Paliw Wtórnych Z Odpadów (Srf) Na Przykładzie Instalacji Współspalania Paliw W Cementowni Chełm, Magdalena Kasietczuk, Robert Oleniacz

Robert Oleniacz

The paper presents the use of Solid Recovered Fuels (SRF) in Chelm Cement Plant (Poland). These types of fuels are produced from non-hazardous waste and can be used for energy recovery in waste co-combustion plants. They are much cheaper compared to primary fuels, so their use in the process of cement clinker burning brings evident economic benefits. Chelm cement plant owned by the CEMEX company is a leader in the use of alternative fuels in Poland. In the years 2005-2011 the amount of co-combustion of alternative fuels in the cement had risen from 107 to 318 thousand tons, and their …


Co-Incineration Of Large Quantities Of Alternative Fuels In A Cement Kiln – The Problem Of Air Pollutant Emissions, Robert Oleniacz, Magdalena Kasietczuk Jan 2012

Co-Incineration Of Large Quantities Of Alternative Fuels In A Cement Kiln – The Problem Of Air Pollutant Emissions, Robert Oleniacz, Magdalena Kasietczuk

Robert Oleniacz

Over the last few years, a significant increase in the use of alternative fuels in the Polish cement industry has been observed. These are mainly waste and waste-derived fuels. The national leader in this field is Chełm cement plant (Poland), with the share of alternative fuels in the cement kiln heat balance reaching in 2012 the level of 78.5%. In this paper, an analysis of the emission rate of air pollutants from cement clinkering process in the above-mentioned cement plant in the years 1998–2012 was carried out, using the results of continuous and periodic measurements. The compliance with the emission …