Physical Sciences and Mathematics Commons^™

Economic Feasibility Of Mixed Plastic Waste Pyrolysis Using Twin Reactor System In Northwest Arkansas, Carol Rogers, Patricia Means, Renato Gonzalez, Kaida Sheets, Hayden Townsend

Chemical Engineering Undergraduate Honors Theses

Plastic waste generation is increasing at an unsustainable rate while recycling solutions remain stagnant. As a chemical means of recycling, mixed plastic waste pyrolysis can generate synthetic oil appropriate for use as fuel in power generation from plastic waste that otherwise accumulates in landfills. With the scaling of a commercial plastic pyrolysis process in Northwest Arkansas (NWA) modeled after an operational sawdust pyrolysis unit in Huntsville, Arkansas, economic analysis resulted in 26.3% internal rate of return. Therefore, construction of a commercial mixed plastic-to-fuel pyrolysis plant is economically justified and should be pursued. To effectively implement the proposed design, NWA must …

Tailings Dust Emissions, Emily Degner, Sam Horn, Zakary Galligan, Ryan Bernard, Julie Jameson, Josh Mueller, Natalie Tucker, Joe Griffin

Chemical Engineering Undergraduate Honors Theses

Fugitive dust emissions from the storage and handling of mine tailings presents environmental and safety concerns, which must be addressed to promote the land sustainability and the health and safety of individuals around a tailings storage facility (TSF). The investigated dust control methods were agglomeration, binder slurry injection, and topical spray.

The Dust Busters determined that pelletizing was the most practical method of agglomeration. In order to produce durable pellets from the mine tailings, which consist primarily of silica, a binder must be added. A variety of binders were considered including magnesium and calcium chloride, bentonite, barite, cement, vinyl polymers, …

Haul Truck Tires Recycling, Jessica N. Lizarazu

Chemical Engineering Undergraduate Honors Theses

The disposal of large Off-the-Road (OTR) tires is an increasingly important concern. These tires can weigh up to 8,450 pounds with an overall diameter and width of approximately 140.7 inches and 45.1 inches respectively. OTR tires are used for mining vehicles such as haul trucks, wheel loaders, backhoes, graders, and trenchers. These new tires cost between $38,000 and $50,000 each, depending on multiple factors including oil prices and the cyclical nature of the industry. Haul trucks contain six tires per vehicle, and mines replace these tires around every 9-12 months. Statistics regarding discarded OTR tires are not provided by the …