Open Access. Powered by Scholars. Published by Universities.®

Physical Sciences and Mathematics Commons™

Open Access. Powered by Scholars. Published by Universities.®

Statistical Models

PDF

Theses and Dissertations

Response surfaces (Statistics)

Publication Year

Articles 1 - 2 of 2

Full-Text Articles in Physical Sciences and Mathematics

Groundwater Model Parameter Estimation Using Response Surface Methodology, Richard M. Cotman Mar 1995

Groundwater Model Parameter Estimation Using Response Surface Methodology, Richard M. Cotman

Theses and Dissertations

This thesis examined the use of response surface methodology (RSM) to estimate the parameters of a finite-element groundwater model. An existing two-dimensional, steady-state flow model of a fractured carbonate groundwater system in southwestern Ohio served as the calibration target data set. A Plackett-Burman screening design showed that only four of the ten hydraulic conductivity zones significantly contributed to the output of the finite-element model. Also, the effective porosity parameter did not significantly affect the model's output. Using only the four significant hydraulic conductivity parameters; four two-level, four-factor designed experiments were conducted to exploit the first-order response surface defined by a …

Go to article

Estimating Groundwater Flow Parameters Using Response Surface Methodology, Leo C. Adams Apr 1994

Estimating Groundwater Flow Parameters Using Response Surface Methodology, Leo C. Adams

Theses and Dissertations

This thesis examined the use of response surface methodology RSM as a parameter estimation technique in the field of groundwater flow modeling. Using RSM, an attempt was made to calibrate three hydraulic parameters porosity, transverse permeability, and rate of recharge of an existing two- dimensional, steady-state flow model. The model simulated groundwater flow for a portion of landfill 10 located on Wright-Patterson Air Force Base, Ohio. The model had previously been calibrated by graphical matching observed water-levels to predicted water-levels. Using the parameter values from the earlier calibration effort as a starting point, a central composite design was developed and …

Go to article